7.7.1 For the RC circuit shown in the image below, assuming that the switch hasbeen in position A for a long time and is moved to position B at t= 0. Then at t = 1second, the switch moves from B to C. If R1 = 480 S2 and R2 = 1.9 kS2, determinethe voltage across the capacitor, v when t= 0.5 s. Please pay attention: the numbersmay change since they are randomized. Your answer must include 3 places after thedecimal point, and the proper SI unit.10 k2ABIC15 V (+2 mF|R1R2Your Answer:Answerunits 7.7.2 For the RC circuit shown in the image below, assuming that the switch hasbeen in position A for a long time and is moved to position B at t = 0. Then at t = 1second, the switch moves from B to C. If R1 = 540 S2 and R2 = 2.8 kS2, determinethe voltage across the capacitor, v when t = 1.3 s. Please pay attention: the numbersmay change since they are randomized. Your answer must include 3 places after thedecimal point, and the proper Sl unit.10 k2ABIC15 V (+2 mFR1R2Your Answer:Answerunits

As per the guidelines, we are supposed to answer only first question. Please repost the other…

7.7.1 For the RC circuit shown in the image below, assuming that the switch has been in position A for a long time and is moved to position B at t= 0. Then at t = 1 second, the switch moves from B to C. If R1 = 480 S2 and R2 = 1.9 kS2, determine the voltage across the capacitor, v when t= 0.5 s. Please pay attention: the numbers may change since they are randomized. Your answer must include 3 places after the decimal point, and the proper SI unit. SS

7.7.1 For the RC circuit shown in the image below, assuming that the switch has been in position A for a long time and is moved to position B at t= 0. Then at t = 1 second, the switch moves from B to C. If R1 = 480 S2 and R2 = 1.9 kS2, determine the voltage across the capacitor, v when t= 0.5 s. Please pay attention: the numbers may change since they are randomized. Your answer must include 3 places after the decimal point, and the proper SI unit. SS

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The Capacitor value is 0.08 F.
An initially uncharged 4.57 uF capacitor and a 6.57 k2 resistor are connected in series to a 1.50 V battery that has negligible internal resistance. What is the initial current in the circuit, expressed in milliamperes? initial current: Calculate the cir time constant: x10 elapsed time: TOOLS conds. How much time, in milliseconds, must elapse from the closing of the circuit for the current to decrease to 3.69% of its initial value? mA ms ms
8
Lecture Review Assignment Draw a circuit with only one resistor and capacitor that is equivalent to this circuit. What is the time constant of this RC circuit? R₁ www After a long time of charging, what is the charge on the capacitor 1 and current in resistor 1? V S C3 V = 6.0V R₁ = 250 25Ω R₂ = 330 33N R₂ C₁ C₂ C₁ C₁ = 12µF C₂ = 23µF C3 C3 = 46µF
GENERAL RLC CIRCUITS: Solve and show your solution completely. Make sure your answers are in 4 decimals places. A 400 mH coil of negligible resistance is connected to an AC circuit in which an effectivecurrent of 6 mA is flowing. Find out the voltage across the coil if the frequency is 1000 Hz.
What is a capacitor and how do they work? What is it about capacitors that make them unique? What is the formula for one time constant? How many time constants does it take to fully charge a capacitor? Show illustrations. What other electronic component(s) are commonly found with a capacitor…especially in timing circuits? What types of capacitors are there? What are the formulas for series and parallel capacitors? If three 30 uF capacitors were connected in parallel what would the net capacity be? How about the net value if the capacitors in Q7 were connected in series? If you were to connect a 5K-ohm resistor in series as in Q7… what would the first time constant be? What about time to full charge? Describe the difference between AC (alternating current) and DC (direct current). Use illustrations. Why is voltage generated and distributed in AC? What type of circuit(s) would change AC to DC? How about DC to AC?
-In the circuit shown on the right the switch S has been open for a long time. What is the current flow through the inductor (0, 2 to 1, or 1 to 2) ? -In the circuit shown on the right the switch S has been open for a long time. At the instant the switch S is closed, the current flow through the inductor is (0, 1 to 2, or 2 to 1)? -In the circuit shown on the right the switch S has been open for a long time. The current flow through the inductor is (increasing, steady, or decreasing)? -In the circuit shown on the right the switch S has been open for a long time. Immediately after the switch S is closed, the current flow through the inductor is (increasing, steady, or deacreasing)? -In the circuit shown on the right the switch S has been closed for a long time. The current flow through the inductor is (1 to 2, 2 to 1, or 0)? -In the circuit shown on the right the switch S has been closed for a long time. At the instant the switch S is opened, the current flow through the inductor is (1…
If u cant do these 4 parts better skip ill rate based on that, please do ill like its easy