7. Which of the following depends oncharging and discharging rate of acapacitor? *PowerCurrentTime constantO Voltage8. The resistivity does not change if*O both material and temperature are changed.the temperature is changed.the material is changed.the shape of the resistor is changed.

Answered: Image /qna-images/answer/326d60ff-b810-4e8e-bed6-9f7fde4b77c9.jpg

7. Which of the following depends on charging and discharging rate of a capacitor? * Power Current Time constant O Voltage 8. The resistivity does not change if both material and temperature are changec the temperature is changed. the material is changed. O the shape of the resistor is changed.

7. Which of the following depends on charging and discharging rate of a capacitor? * Power Current Time constant O Voltage 8. The resistivity does not change if both material and temperature are changec the temperature is changed. the material is changed. O the shape of the resistor is changed.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Q.2 An Op Amp network is given in the figure below. Find out the output voltages V2 and V3. 200 KL V = 0-2 V 20012 10KR
H5.
a) How many electrons are contained in one coulomb of charge? b) When a resistor conducts electric current, its temperature increases. Explain how this phenomenon is significant to the application of resistors in electric circuits. In other words, why would we care about a resistor's temperature increasing? c) Define SI unit of the following: Resistance, Voltage, Current, Power d) The potential difference across a capacitor is 5.0 V and the charge on the capacitor is 150nC. Determine the charge on the capacitor when the potential difference is 10.0 V
A single 12 Volt battery is connected to a single 40 Ohm resistor. a. how much current is flowing through the resistor ? b. what power is being consumed by the resistor ?
A 10 μF capacitor with an initial energy of 0.1 J is discharged through a 7.5 MΩ resistor. What is the initial charge on the capacitor? The charge, Q0 = Units . What is the current through the resistor when the discharge starts? The current, I0 = Units . Determine the potential difference across the capacitor and the rate at which the thermal energy is dissipating in the resistance 0.9 min after the discharge starts. The potential difference across C, VC = Units . The power dissipated in R, P = Units .
Referring to the given figure where V= 21 V, use source transformation to determine the current and power absorbed by the 8-0 resistor. 32 ww 82 3 A 102 The current absorbed by the 8-0 resistor is The power absorbed by the 8-0 resistor is A. W. ww
A series combination of a 45,000 Ohm resistor and an unknown capacitor is connected to a 15 V battery. Once second after the circuit is completed, the voltage across the capacitor is 8 V. a. Determine the capacitance of the capacitor. b. What is the voltage across the capacitor 2 seconds after the circuit is completed?
Kate has an iron wire connected across the terminals of a battery. When her circuit is at 20 degrees celcius , a current of 9.2 mA flows through her wire. When the circuit is placed somewhere else the current becomes 8mA. If the iron has a temp coefficient of resistivity of 5x10^-3(degrees celcius)^-1 , the temp of the new environment in degrees celcius is? a. -46 b. -6.1 c. 10 d. 30 e. 50
2 An uncharged ( 680 µF ) capacitor, a ( 100 kQ) resistor, a (9 V) ed battery and a key are connected in series. The charge on the capacitor after ten seconds from closing the key is : out of question Select one: a. 507 uC b. 400 µC C. 837 uC Next page
Which of the following statements is/are ALWAYS TRUE for the resistivity and conductivity of a material? I. The resistivity of a material is temperature-dependent. II. The conductivity of a material is temperature- dependent. III. As the resistivity of a material increases. its conductivity decreases. A. Tand II only B. I and III only С. C. Il and III only D. I, II, and II
You are given a number of 10 Q resistors, each capable of dissipating only 2.4 W without being destroyed. What is the minimum number of such resistors that you need to combine in series or in parallel to make a 100 resistance that is capable of dissipating at least 7.4 W? Number i Units
Three resistors with values of 2 ?, 9 ?, and 11 ? respectively are connected in series to a 12 V power source. What is the equivalent resistance of the three resistors? What is the current in the 9 ? resistor? What is the potential difference across the 2 ? resistor?