7. Nitrogen (N2) amounting to 10.5 grammes expands isothermally at a temperature of – 10°C from a pressure of P1 =3 atm. to P2 = 2 atm. Find the work performed by the gas during expansion. A) 112 J C) 332 J B) 222 J D) 442 J

7. Nitrogen (N2) amounting to 10.5 grammes expands isothermally at a temperature of – 10°C from a pressure of P1 =3 atm. to P2 = 2 atm. Find the work performed by the gas during expansion. A) 112 J C) 332 J B) 222 J D) 442 J

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A piston-cylinder assembly contains 2 kg of liquid at 20 ° C and 100 kPa pressure. 1000 kPa pressure…

A: Given Data: The mass of water in the piston cylinder is, m=2 kg. The initial temperature of water…

Q: An Ideal gas with R=25.9 lb-ft/lb-R and k=1.1is heated at constant volume. What is the a.)Cp and…

A: given:R=25.9 lb-ft/lb-Rk=1.1,Initial volume, V=15 ft3initial pressure, P1=70 psia or 70×144…

Q: 3- A piston-cylinder assembly is in equilibrium with a volume of saturated liquid of 0.15 m³ and a…

A: Given data as per question Volume of saturated liquid =0.15 m3 pressure = 700 kPa Volume of…

Q: A 100 liter tank contains a mixture of saturated liquid water and saturated steam at 370 °C. a) Find…

A: Given:V=100 Lvf=2.213*10-3 m3/Kgvg=4.925*10-3 m3/Kg

Q: Steam at saturation pressure of 1.75 MPa has a quality of 78%. Find the following properties: a.) v…

A: Write the given data with suitable variables: P=1.75 MPax=78 %

Q: A ball of weight 120 N rests in a right angled groove as shown in Fig. The sides of the groove are…

A: Given data: Weight = 120 N Need to determine the reaction force at point A.

Q: Liquid is held into two components Separated by a membrane.the total volume is 775ft3 and the volume…

Q: 4. A 100 liter tank contains a mixture of saturated liquid water and saturated steam at 370 °C. a)…

A: Answer: (a) If the volume of each phases are equal: ● The mass of liquid phase is 22.5938 kg. ● The…

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d 2.5 m). Take…

Q: Questions 1,2 and 3 In the figure shown, if F, 250 lb, and F₂= 200 lb, Determine the following: 1)…

A: Given data :- F1 = 250 lb F2 = 200 lb

Q: A 100 liter tank contains a mixture of saturated liquid water and saturated steam at 370 °C. a) Find…

A: Given:- Volume of the tank , V = 100 liter = 100×10-3 m3 temp, = 370°C vf = 0.002213 m3/kg vg =…

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d = 2.5 m). Take…

A: If a force F is inclined at an angle θ with the horizontal, then the component of force along the…

Q: Water atp1= 5 bars andT1= 240◦C is inside a rigid closed container of volumeV= 0.5 m3, which…

A: Since we only answer upto three subparts, we will answer the first three. Please resubmit the…

Q: Please show your complete solution. Thank you! A 1.5 kg of an ideal gas undergoes a process wherein…

A: The mass of ideal gas is .The initial pressure is .The initial volume is .The final pressure is The…

Q: 35 kg of certain gas is contained within the piston- cylinder assembly. THE GAS undergoes a process…

A: Given:m=35 Kgpv=Cp1=6 bars =600 KPaV1=0.2 m3V2=0.4 m3dU=10.5 KJ/Kg

Q: Steam enters a horizontal steam turbine at p₁-65 bar and T₁-500 °C with a mass flow rate of m = 1.5…

A: Given that: Steam enters turbine at: T1 = 500oC and P1 = 65 bar Steam exits turbine at P2 = 10 bar…

Q: The relation between mass and volume flow rate can be shown with the help of the fluid property...

A: Volume flow rate is the amount of volume flowing through a cross section in a period of time. Mass…

Q: 30. Steam at 2.65 MPa of 60% quality, undergoes a S = c process until its pressure becomes 0.265…

Q: Completely solve and box the final answers. Write legibly Two moles of gas (O2) initially kept in a…

Q: Two pounds of air contained in a cylinder expand without friction against a piston. The pressure on…

A: Write the given data. m=2 lb=0.907 kgP1=P2=200 psia=1.379×106 PaV1=0.50 ft3=0.0141 m3T2=100…

Q: 1. Ten ft of air at 300 psia and 400°F is cooled to 140°F at constant volume. What are a) the final…

Q: A piston-cylinder device initially contains 500 liters of liquid water at 2.5 Mpaa and 200°C. Heat…

Q: 20 02) Given the figure attached, Determine the following: 200 kg D • 1) What is magnitude of R and…

A: *As per our guidelines we are supposed to answer first three sub-parts of the question. Kindly…

Q: 4) Find: 01(s)/T(s) T(1) OA) 2 N-m-s/rad 7 N-m-s/rad 1 ke-m? 1 kg-m? 3 N-m/rad 8 N-m/rad

A: Given : To find : θ1(s)T(s)

Q: Air is heated at constant pressure of 5 x 105 Pa and the volume increases from 1 to 10 cubic meters.…

Q: A piston cylinder arrangement initially contains 7.0 kg of super-heated steam at 100 kPa and 250 C,…

Q: 16 - y (cm) mx 10 CM 8 my 5. x (cm) 8. The position of center of mass (CM) for the system composed…

A: Given data: The position of mass mx from Y axis is x1 = 8 cm. The position of mass my from Y axis…

Q: m=80kg 1m 175 cm A) Find the force F B) How much work does he do if his center of mass push up a…

A: givenmass=80kg

Q: 4) An ideal gas undergoes a constant volume (isochoric) process in a closed system. The heat…

A: Two objective type question given related to…

Q: In figure (1), the block moves upward from position (A) to (B) though the distance (d = 2.5 m). Take…

Q: a) Determine the density (p), specific gravity (SG), and mass (m) of the air in a room as shown in…

Q: A piston-cylinder assembly contains 2 kg of liquid at 20 ° C and 100 kPa pressure. 1000 kPa pressure…

Q: The 3 sides of a square plate shown in the figure below are kept at 0°C by fully insulating it, but…

A: The heat transfer equation can be written as:q = k * A * (dT/dx)Where: q is the heat flux (uniform…

Q: Which of the phase changes shown in the temperature (T) – specific volume (v) diagrams below can…

Q: Ideal

A: Given data:m=10 lbR=40 ft lbf/lbm.R=40lbfftlbmR*1Btu778lbfft=.0514Btu/lbm.Rcp=.25 Btu/lbm.RP1=20…

Q: 35 A ball of weight 120 N rests in a right angled groove as shown in Fig. The sides of the groove…

Q: Determine the units of pressure in the equation pv=RT v: specific volume, m3/kg R: constant in…

Q: From a state defined by 300 psia, 100 cu ft and 240°F, helium undergoes an is entropic process to…

Q: Consider a closed system undergoing a process with AU12 = 200 kJ. The system perform work of W12 =…

Q: A piston cylinder arrangement initially contains 7.0 kg of super-heated steam at 100 kPa and 250 oC,…

Question

7.
Nitrogen (N2) amounting to 10.5 grammes expands isothermally at a
temperature of – 10°C from a pressure of P1=3 atm. to
P2 = 2 atm. Find the work performed by the gas during expansion.
A) 112 J
B) 222 J
C) 332 J
D) 442 J

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A metal mug of thickness 2mm is 8cm in diameter and is filled with tea at 90°c to a depth of 10cm. If the ambient temperature is 20°c and the thermal conductivity of the mug is 50 W/mK, which of the following is the best estimate of how much heat the tea initially loses per second? A) 53KJ/S B) 0.88KJ/S 2.8KJ/s D) 1.4KJ/S
i need the answer quickly
Assume 5 ft/s of Hydrogen at 15 psia and 80 °F are compressed during an irreversible adiabatic process to 90 psia and 522 °F. For a non-flow process determine a) k, b) V₁. c) W, d) AU and e) AS.
2.0 lb of water inside a piston-cy inder assembly undergoes the following two processes in series Process 1-2: Contant pressure cooling from a saturated vapor at p1 = 170 psi until x2 = 80%. Process 2-3: Constant volume heating to a saturated vapor. There are no changes in kinetic or potential energy. a) [2 pts] Find the specific volume for state 1 in ft3/lb. b) [2] Find the specific volume at state 2 in At3/b
An open circular cylinder of 20 cm diameter and 120 cm long contains watr up to a height of 80 cm. It is rotated about its vertical axis at 400 rpm. Find the difference in the total force in N (a) at the bottom of the cylinder. (b) at the sides of the cylinder due to rotation. Possible Answer: a) 14.52 b) 2465.45 c) 1265.17 d) 568.73
20 b 'Given the figure attached, vetermine the following: 200 kg 1) What is magnitude of R and Cr in pt D? 20 kN (Unit must be in N and kN-m) • 2) What is the magnitude of R and Cr in pt B? -2 FT 200 kg (Unit must be in N and kN-m) 3) Unit Vector of R in the system. 4) Direct Cosines of Cr in pt D.
a) The velocity ratio (VR) b) The mechanical advantage c) The efficiency, Answer in % d) The ideal effort (P1). Answer in N
Determine the work of the force F = (6s² ), where s is the displacement in meter, of the figure shown below. -2 m- 4 F = (6 s²) N (A) 12J B) 16J C) 48J D) 24J
One kg of nitrogen contained in a cylinder at a pressure of 7bar and temperature of 300K expands 4 times of its original volume.The process of expansion is assumed to take place at constant pressure. Calculate a) Initial volume b) Final temperature c) Workdone d) Heat added. e) Change in internal energy. For nitrogen assume, Cp =1.045 kJ/kg K, R=0.296 kJ/kg K
Air occupying a volume of 12 liters at 35 °C is compressed adiabatically to a volume of 4 liters. It is then allowed to expand under isothermal conditions to its original volume. a) Show the process on a Pressure-Volume diagram b) Calculate the final temperature and pressure of the air. Assume y = 1.44
ا من ۱ A ball of weight 120 N rests in a right angled groove as shown in Fig. The sides of the groove are inclined at an angle of 30° and 60" to the horizontal If all the surfaces are smooth, the reaction R, is given by V. TT 120 N 30° B 60° 1) 60 N 3) 30 N 2) 120 N 4) 103.92 N temeter 100 cm Ganessh G@NU 20:14 äc luJI 21.03.11 ...