7. Determine the difference in pressure APAB between locations A and B in kilopascals (kPa) based on the differential manometer shown below. 1m Water Water Water B ၂ 1.2 m 1.5 m 1.3 m T 0.5 m Mercury (sp gr = 13.6)

7. Determine the difference in pressure APAB between locations A and B in kilopascals (kPa) based on the differential manometer shown below. 1m Water Water Water B ၂ 1.2 m 1.5 m 1.3 m T 0.5 m Mercury (sp gr = 13.6)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Based on the provided differential-type manometer, calculate the difference in the pressure between…

A: To find :- the pressure difference between points A & B.

Q: Calculate the pressure and speed of water at points b and c as shown.

A: ASKED: To determine the pressure and speed of water at points B and C. Given, Pressure at A (PA) =…

Q: A U-tube mercury manometer is used to measure pres- sure of oil flowing through a pipe at a point.…

A: Specific gravity of oil (So) = 0.8Oil head = 50cm = 0.5 m Mercury head = 150 cm = 1.5 m

Q: The pressure drop of water in a pipe is measured by a manometer using a liquid of density 2000…

A: Given data- Density of the liquid- ρm=2000 kg/m3, The difference in height h=10 cm=0.1 m, To Find-…

Q: Water is flowing through a venturimeter shown. The difference in pressure between Point 1 (D = 4cm)…

Q: Water GLYCERIN, SG = 1.26 Pipe 30mm 3mm

Q: identify the type of manometer and then solve. Determine the difference in 02 pressure between A and…

A: The given data is: h1=0.2 m h=0.15 m h2=0.3 m SGoil=0.862

Q: For the shown inverted manometer, all fluids are at 20°C. If P - P = 97 kPa, what must the height X…

A: Using concept of Pressure in left limb of manometer = pressure in right limb solution = 1.31m

Q: 1. In Figure below, sensor A reads 3.5 kPa (gage). All fluids are at 15°C. Determine the elevations…

A: PA=3.5kPa

Q: 5. The system shown on the right is used to accurately measure the pressure changes when the…

A: Given:- Δh=70 mmSpecific gravity of glycerin, SG=1.26Specific density of water, γw=9.81 kN/m3 To…

Q: G Q1/ Water flow through an orifice meter at an empirical equation Re = 0.35Re0 – and a rate of…

A: The given data is as follows: Empirical equation, Re=0.35 Re0-G0.9m.Flow rate=300×106…

Q: CLW3.8 Problem • A manometer is used to measure the pressure of a gas in a tank. The fluid used has…

Q: A differential manometer is attached to a pipe as shown. Determine the pressure difference between…

A: 2 rules :- 1. Pressure in a liquid at a particular level is same everywhere. 2. There is increase in…

Q: P.3.5 Three pipes A. B. and C at the same level connected by a multiple differential manometer shows…

A: Some standard units for pressure 1 bar= 105 Pa

Q: A differential manometer is attached to a pipe, as shown in the figure. Calculate the pressure…

Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…

Q: A manometer with mercury (S-13.6) is connected to a pipe carrying water (S-1). If the manometer is…

A: Given data in question Water as fluid in pipe Manometric liquid is mercury Specific gravity of…

Q: Water flows in a straight pipe (€ = 0.000005 ft.) that is 8-inches in diameter, between points A and…

A: Diameter of pipe, Roughness, Elevation of point A, Pressure at point A, Elevation of point B,…

Q: A tank is fitted with a manometer on the side, as shown. The liquid in the bottom of the tank and in…

Q: For the shown inverted manometer, all fluids are at 20°C. If P, - P, = 130 kPa, what must the height…

Q: 5 Determine the absolute pressure at B in kPa if the atmospheric pressure is 101.325 kPa. * 105.543…

A: Given data in question Atmospheric pressure 101.325 kPa Depths Specific gravity 0.86 To find out…

Q: As you have seen in lectures (and in Lab 3), the height above the pipe centre to which water rises…

A: Given data in question Discharge 0.025 m3/s Diameter 20 cm and 15 cm Length 5m To find out Head…

Q: В A SG= 1.50 Water 30сm 80cm

Q: A horizontal venturimeter with inlet and throat area as 706.858 cm2 and 176.715 cm2 respectively is…

A: We have to determine the value of rate of flow of the horizontal venturimeter with inlet and troat…

Q: Problem 3 The pressures Pa and Pg in the differential manometer gage are 154.415kPag and 150 kPag…

Q: For the following inverted manometer setup, if the pressure at x is 200 kPa, what is the pressure at…

Q: Water, Oil (sg = 0.90) 6 in 8 in 6 in 10 in 6 in Mercury (sg = 13.54)

Q: A: Derive an expression to determine the hydrostatic force and the centre of plane submerged inside…

Q: Identify the type of manometer in the following figures and then compute for the pressures. Open PA-…

A: 1)First image is of Differential U-Tube Manometer 2)Second image is of U-Tube Manometer 3)Third…

Concept explainers

Pressure and Stress

Question

7. Determine the difference in pressure APAB between locations A and B in kilopascals (kPa) based on the
differential manometer shown below.
1m
Water
Water
Water
၂ ကြ
၀က်
B
1.2 m
1.5 m
1.3 m
0.5 m
Mercury (sp gr = 13.6)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given figure of manometer

VIEW

Step 2: Calculation of pressure difference

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the differential manometer shown. (a.) Find the H (in inches) if pressures at A is 9psi and Bis 7psi.
What is the pressure difference (PA - PB) measured by the U-tube manometer shown in the figure below. use S.G. mercury = 13.6, y water = 9.81 KN/m³. Water Mercury
For the setup shown, Determine the rise of liquid h on the left leg of the manometer in inches.
Example 7 (Page 266): Water (T = 20°C) flows from a tank through a 50-cm-diameter steel pipe. Determine the discharge of water. (Include only the head loss in the pipe) Assume the flow is fully developed. Kinematic viscosity: v= 1 x 10-6 m²/s Steel pipe: absolute roughness, & = = 0.046 mm. Water Elevation = 60 m D = 50 cm 100 m Steel pipe 40 m El
Example 7: The figure below shows a complex manometer. Calculate: 1. The gauge pressure of the air in the tube (2943 N/m²). 2. The gauge pressure at A (20718.72 N/m²). 3. The absolute pressure at A if the atmospheric pressure is 105Nm2 (120718.72 N/m²). s.g.= 0.90 S.g.= 2.94 B Air 0.6m 0.3m D FU 0.8m Water Density of water = 1000 kg/m³.
To keep track of water pressure, a manometer is attached to a water supply pipe. The 3 ft (Hg) measurement on the manometer, on the other hand, could be inaccurate. Determine the right value of the reading (h) if the pressure in the pipe is measured and determined to be 18.6 lb/in² (psi). The specific gravity of Hg is 13.6.
Which parameters do Barometer and Manometer measure? o Pressure difference; Atmospheric pressure o Pressure difference; Absolute pressure o Absolute pressure; Pressure difference o Atmospheric pressure; Pressure difference • What is the absolute pressure at location 1 (P1)? Ga OP = Pan + Pgh OP = Pan OP, - Pgh OP can not be calculated
7. Two water tanks are connected to each other through a mercury manometer with inclined tubes, as shown in figure. If the pressure difference between the two tanks is 20 kPa, determine the value of ? in degrees. (2 decimal)