Water flows in a straight pipe (€ = 0.000005 ft.) that is 8-inches in diameter, between points A and B as shown in the figure below. The two points are 1,200 feet apart. The elevation of point A is 2,862 feet and the pressure reading is 38 psi. At point B, the elevation is 2856 feet and the pressure reading is 35 psi. Use a kinematic viscosity, v = 1.217 X 10-5 ft²/sec. What is the flowrate? A B

Water flows in a straight pipe (€ = 0.000005 ft.) that is 8-inches in diameter, between points A and B as shown in the figure below. The two points are 1,200 feet apart. The elevation of point A is 2,862 feet and the pressure reading is 38 psi. At point B, the elevation is 2856 feet and the pressure reading is 35 psi. Use a kinematic viscosity, v = 1.217 X 10-5 ft²/sec. What is the flowrate? A B

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The diameter of a pipe carrying oil (s=0.92) changes gradually from 400 mm at A to 600 mm at B. Point A is 3.6 m lower than B. If the pressure at A is 70 KPa and that at B is 49 KPa when 140 L/s is flowing, determine the direction of flow; (b) the frictional loss between the two points.
15. If the pressure in pipe A is 6 kPa, the SG = 0.85 pressure in pipe B =. ........... psig. Water 90 mm 30% a. 1.27 70 mm b. 8.73 40 mm C. 60.17 SG = 13.6 Mercury d. None of all these
1. For the setup shown, calculate the pressure difference between points 1 and 2 + Oil sg = 0.8 Oil sg = 0.8 1m 2.3m +Hg Hg 0.7m 0.4m 0.8m
Oil (SG = 0.83) flows at a rate of 200 L/s through a 500m pipe with a diameter of 200mm. The friction factor of the pipe is 0.0225. The pipe slopes down at 10 degrees from the horizontal. Determine the difference in pressure between the start of the pipe to the end of the pipe. A) 287.79 KPa B 176.36 KPa c) 129.34 KPa D No Answer among the choices 238.86 KPa
Oil (SG = 0.83) flows at a rate of 200 L/s through a 500m pipe with a diameter of 200mm. The friction factor of the pipe is 0.0225. The pipe slopes down at 10 degrees from the horizontal. Determine the difference in pressure between the start of the pipe to the end of the pipe. A) 287.79 KPa B) 176.36 KPa c) 129.34 KPa D No Answer among the choices E) 238.86 KPa
. Determine the surface tension in a tube with 0.2m radius and wetting angle 80 and capillary rise of 5mm in N/m and in lb/ft.
1. A differential manometer is attached to a pipe as shown. Calculate the pressure difference between points A and B. ₪t Mercury o..A 2. A manometer is attached ched and the mercury. to a water tank shown in the figure (a.) find the height of the free water surface above the bottom of the tank; (b.) Find the pressure at the interface of the water to a O water ROPERTON 100mm 0.15m 0.15m Oi, s 0.9 0.2m Hg(13.6)
A pipe conveys water with velocity 360 m/min and pressure gauge shows 5 bar pressure under which the water is following. The pipe is located at 5 metre above the datum line. The sum of total head and stagnation head is m. (g = 10 m/s?). (assume 1 bar = 105 Pa) %3D
Orifice meter with orifis cross-section 0.00785 m2 is inserted in a pipe of cross-section 0.0314 m2. The pressure gauge fitted upstream and downstream of orifice give reading of 19.62 N/cm2 and 9.81 N/cm2 respectively. Determine the value of dischareg using Cd=0.6.
13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carbo tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/em and pipe B contains ofl of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. 14. A differential manometer is connected at the two points A and B as shown in Fig. 2.25. At B air pressu is 7.848 N/cm (abs.), find the absolute pressure at A. [Ans. 31.36 cm of mercuryl (Ans, 6.91 Nicm) AIR WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm 30 cm 100 am 60 cm 10 cm MERCURY Sp. gr.13.6 WATER Fig. 2.25 Fig. 2.26
13. A U-tube differential manometer connects two pressure pipes A and B. Pipe A contains carb tetrachloride having a specific gravity 1.594 under a pressure of 11.772 N/cm2 and pipe B contains oil of sp. gr. 0.8 under a pressure of 11.772 N/em. The pipe A lies 2.5 m above pipe B. Find the difference of pressure measured by mercury as fluid filling U-tube. 14. A differential manometer is connected at the two points A and B as shown in Fig. 2.25. At B air pressu is 7.848 N/cm² (abs.), find the absolute pressure at A. [Ans. 31.36 cm of mercury] [Ans, 6.91 N/em) AIR B WATER OIL Sp. gr.0.8 OIL Sp. gr. 0.8 50'cm 30 cm om 100 cm 50 cm 10 cm MERCURY Sp. gr. 13.6 WATER Fig. 2.25 Fig. 2.26
Given a three-pipe system, the total pressure drop is P,- P, 150,000 Pa, and the elevation drop is Z, - Z, = 5 m. The pipe A data are: Pipe L, m d, cm E, mm eld 1 100 8 0.24 0.003 2 150 0.12 0.002 3 80 4 0.20 0.005 The fluid is water (density 1000 kg/m' and kinematic viscosity 1.02x10 m/s). Calculate the flow rate Q in m'/h through the system. 3