61 SSM A block of mass m, = 4.0 kg is put on top of a block of mass m, = 5.0 kg. To cause the top block to slip on the bottom one while the bottom one is held fixed, a horizon- tal force of at least 12 N must be ap- plied to the top block. The assembly Fig. 6-47 Problem 61. of blocks is now placed on a hori- zontal, frictionless table (Fig. 6-47). Find the magnitudes of (a) the maximum horizontal force F that can be applied to the lower block 2. so that the blocks will move together and (b) the resulting acceler- ation of the blocks. 1.

61 SSM A block of mass m, = 4.0 kg is put on top of a block of mass m, = 5.0 kg. To cause the top block to slip on the bottom one while the bottom one is held fixed, a horizon- tal force of at least 12 N must be ap- plied to the top block. The assembly Fig. 6-47 Problem 61. of blocks is now placed on a hori- zontal, frictionless table (Fig. 6-47). Find the magnitudes of (a) the maximum horizontal force F that can be applied to the lower block 2. so that the blocks will move together and (b) the resulting acceler- ation of the blocks. 1.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

At an intersection, two cars have collided. Car 1 has a mass of 2200kg, moving west collided with car 2 with a mass of 1500kg moving north. The cars stuck together and skid at angle of 20 degrees north of west with a distance of 15m. Between the tires and the road, the coefficient of kinetic friction is 0.60. If the speed limit of each car was 50km/h, was either car speeding? Two things happened in this questions. There is a collision and then the cars slid to a stop together. a) consider the second scenario where the two cars were stuck and skid 15m to a stop. Using work energy Theorem, calculate the velocity righ after the collision and the two cars started to skid B) sketch the diagram of collision before and after the crash with labels of masses and velocities of both the vehicles C) from part A, we know the velocity of the two cars after collision. Determine the initial velocities of the two cars and find which car is speeding using conservation of momentum
A 100-N block on a rough 30°-incline is acted upon by a force P as shovm causing it to accelernte at Kinetic friction is 0.30. (a) Draw the FBD of the block (b) Find the magnitude of P. Please explain in full detail
counter- A crane is set to lift a load as shown in the figure. The load has mass m=2000 kg. The vertical tower of the crane has mass 6000 kg. The horizontal beam of the crane has mass Mg = 4000 kg. The rope carrying the load is at a distance 8 m to the crane's vertical tower. Total length of the uniform horizontal beam weight M7 = horizontal beam 8m T2 m of the crane is 12 m. ) Draw a free-body diagram of the beam. ) At what distance x must the crane's counterweight of load b) ( mass M-8000 kg be placed in order to keep the crane at balance? (See figure.) c) What is the maximum force that the tower must withstand, in order to lift this load? vertical tower ador
A 5.00 kg block is thrown up an inclined plane with an initial speed of 8.00 m / s which stops after traveling 3.00 m along the plane, which is inclined at an angle of 30 , 0 ° from the horizontal. For this motion determine the coefficient of kinetic friction between the block and the surface.
15-57
Can i get help with these problems
10. A snowboarder starts at the top of a 160. m tall hill with a velocity of 3.00 m/s. The portion of the hill covered with snow is essentially frictionless, but the flat, horizontal section at the base of the hill covered with mud is not. If the snowboarder masses in at 80.0 kg, and the coefficient of kinetic friction between board and mud is 0.750, how much distance is required for the snowboarder to come to rest?
y x A 35.1-cm-by-35.1-cm checkerboard has a mass of 110.9 g. There are four 15.7-g checkers located on the checkerboard, as shown in the figure. Relative to the origin located at the bottom left corner of the checkerboard, where is the center of mass of the checkerboard-checkers system?
Surely upvote u, do it correctly
50. (I) Find the center of mass of the three-mass system shown in Fig. 7-37 relative to the 1.00-kg mass. 1.50 kg 1.10 kg 1.00 kg K 0.50 m FIGURE 7-37 0.25 m Problem 50.
7) The mass m = 3 kg is hanging from a thread as it is shown in the figure. It is let to fall from a height h = 1.28 m. When it passes through its origin (vertical position), it collides against a block of mass M = 12 kg initially at rest. The restitution coefficient is 0.75. The blocks has a friction coefficient of 0.2 with the ground. Estimate the distance covered by the block after collision. Ans: 0.784 m.