6. What is the torque about the shoulder if the arm is held in an abducted position at 60° from the body in the frontal plane while holding a 10 kg dumbbell? Assume that the mass of the arm is 6 kg, its center of mass is located 38 cm from the shoulder joint center, and the arm's total length is 80 cm. A. 69.3 Nm B. 19.7 Nm C. 89 Nm D. 49.6 Nm

6. What is the torque about the shoulder if the arm is held in an abducted position at 60° from the body in the frontal plane while holding a 10 kg dumbbell? Assume that the mass of the arm is 6 kg, its center of mass is located 38 cm from the shoulder joint center, and the arm's total length is 80 cm. A. 69.3 Nm B. 19.7 Nm C. 89 Nm D. 49.6 Nm

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The free body diagram below represents a 1 500 kg car sitting on a 3 000 kg bridge supported at its far ends. The car's position is three quarters of the length L from the left end of the bridge. Identify the one error in the torque equation below: a. never produces a torque on the bridge no matter where the axis of rotation is placed. b. never produces a torque on the bridge no matter where the axis of rotation is placed. c. cannot produce a torque on the bridge no matter where the axis of rotation is taken since it is at the center of the bridge. d. Because the perpendicular distance to from the left end of the bridge is 0, F1L should be 0. e. Because the perpendicular distance to from the right end of the bridge is 0, F2L should be 0.
3. A very light rod of length 3L is pivoted at one end so it can rotate without friction on a flat table top. A mass M is attached to the rod a distance L from the pivot and a second mass 2M is attached to the opposite end from the pivoted end as shown in the figure. What is the ratio of the tension T1 to T2 ? That is, calculate T1/T2. шк 2M w T₂ M Pivot Point 3L
Thank you!
3. A rowing machine consists of a solid disk with a radius of 20-cm and a mass of 19-kg. An athlete pulls on the attached cable with a force of 10-Newtons and causes the disk to accelerate. If the disk starts from rest, determine; a. The disk's moment of inertia. b. The magnitude of the torque applied by the athlete. C. The disk's angular acceleration. d. The disk's angular momentum at t = 5.0 sec.
13 - F = -8 i +6 j A force with N position vector r = 3 i +4 j acts on a particle whose m. What is the torque acting on the particle relative to the centre? A) 30 N.m B) 40 N.m C) 50 N.m D) 60 N.m E) 10 N.m
1a. The above seesaw has a length of 4.00 m. It is in equilibrium with the people in places as shown. The clockwise torque is: A. 200 N m B. 600 N m C. 1000 N m D. 1200 N m 1b. The above seesaw has a length of 4.00 m. It is in equilibrium with the people in places as shown. The value of x is A. 0.50 m B. 1.00 m C. 1.50 m D. 2.00 m
Use g = 10 m/s/s.
2. Forces of F1, F2, F3, and F4 acts on the rod ABCD as shown in the figure. If the rod's mass is ignored, what is the magnitude of the moment of force, about point B. F- 10 N F-5N D. 2 m 1m 3 m F 4N F 10 N
Q7
In this problem you have to draw the free body diagram. Please be sure, don't use chatgpt.
If an object is in equilibriuim, the net torque about any arbitrary axis must be zero. A. True B. False
Which of the following ARE correct? a.If net force is zero, angular momentum is conserved. b.if net force is zero, linear momentum is conserved. c.if net torque is zero, angular momentum is conserved. d.If net torque is zero, linear momentum is conserved.