6. Describe and provide and example of the most appropriate situation for the following: a) but-for or collapsed as-built analysis, b)line-of-balance and c) impacted baseline techniques.7. Many contracts require that the contractor prepare and present the construction schedule and receive the owner's approval beforeany contract payments are made. Explain in detail what are the three elements of the contractor's schedule that the owner willtypically be interested in?

As per the guidelines, I will answer the first question only. Please upload other questions as a…

Answered: 6. Describe and provide and example of…

6. Describe and provide and example of the most appropriate situation for the following: a) but-for or collapsed as-built analysis, b) line-of-balance and c) impacted baseline techniques.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The four estimating methods are bottom-up estimating, top-down estimatic, parametric estimating, and…

A: Introduction : One of the most critical tasks in project management is cost estimation. It can be…

Q: 5. Which one of the followings is not a reason of excessive local scour at bridge piers? a) Number…

A: 15)Increasing the velocity of vehicles can cause scour at the bridge piers . 16) checkdams never…

Q: Explain the Navfac DM7 (1982) settlement method ? Define the assumptions of this ?

A: The correlation for settlement and SPT N value is given by Navfac DM7 (1982) is S = CσKv×bb+12Cw…

Q: Comparison between vulnerability screening and penetration testing When would they have a need for…

A: Vulnerability screening and penetration testing are two methods used to assess the security of…

Q: Site investigation is the process for the collection of information, appraisal of data, assessment…

A: The five issues which arise due to improper site investigation are 1) Inadequate site investigation…

Q: Describe four soils exploration methods

A: Question is based on soil exploration . Process of gathering data for analysis and assessment of it…

Q: Which of the following is mandatory in a Geotech report for a 25-story commercial building? (Select…

A: All the three steps which are mentioned are used in geotech report Among them Sesimic info is…

Q: Given in the accompanying tabulation are the observed data for a closed traverse obtained from a…

A: Given data:

Q: Research and site 4 examples of modern tools used to make pre-planning easier (e.g AutoCAD) and…

Q: 2. The data tabulated represents earthwork quantities for a certain road extension project. STATION…

Q: 6. Discuss some well known engineering interventions to arrest landslides.

A: A landslide is a rapid downward movement of rock, earth, or debris forming a sloped section of…

Q: Given the project network shown below, the amount of slack for activity b is: Multiple Choice O ² O…

Q: Describe from what does the Zoned earth fill dams consists of?

A: They are dams having central portions termed as hearting or core constructed from relatively…

Q: What are the steps for applying an urgency assessment?

A: INTRODUCTION: It refers to project management technique that examines and specifies overall…

Q: Define the concept Cross-Hole Sonic Logging.

A: for non destructive testing of drilled shaft and other concrete piles we used cross hole sonic…

Q: Which of the following occurrences are a specified (named) peril commercial building and personal…

A: The following occurrences are a specified or named peril commercial building and personal property…

Q: What degree are the operations at a Juneau Alsaka Sawmill Site susceptible to seismic events? What…

A: The susceptibility of a sawmill site in Juneau, Alaska, to seismic events depends on factors such as…

Q: (a) The Varnes system divides slope failures into five types. Briefly explain all FIVE types of…

A: THE FIVE SLOPE FAILURE DESCRIBED BY VARNES SYSTEM : TOPPLE FALL SLIDE SPREAD FLOW

Q: A roadway section is 2000 ft long (20 stations). The cut and fill volumes are to be computed between…

A: Excavation and excavation are also called excavation and embankment. In this process, the excavator…

Q: dinate system) ffness matrix) 10. Consider the structure in Figure 3. Assume the hydrostatic load…

Q: The cut and fill areas for the cross-sections at five stations along the centerline of a highway…

A: The given data is shown below:

Q: What are the steps involved in doing cyclic redundancy tests?

A: The following are the steps involved in performing cyclic redundancy tests Choose a generator…

Q: (b) Identify the two (2) broad categories of sampling methods and name two 2) types under cach

A: There are two types of the sampling methods. They are 1. Probability sampling 2. Non-probability…

Q: Project Name: Contract Duration: ITEM NO. PART NO. C 100 (3)a 101 (3)b3 102(2) PART NO. D 200(1)…

A: Every activity and event in a construction project has a timeline, which is called a construction…

Q: 39. Calculate the total fill volume (yd³) for the segment from 22+00 to 23+00

A: Answer we are given Area of fill at STA 22+00 = 6 ft2 Area of fill at STA 23+00 = 4 ft2 shrinkage…

Q: Penetration testing reports should clearly document conclusions. What are three additional areas…

A: Solution: Penetration test reports are crucial because they provide you with a structured summary of…

Q: The area of section 1 is 120 square meters of fill and the area of section 2 is 160 square meters of…

A: Solution:- Volume of fill by, Average End Area method:

Q: How does exploratory testing vary from other types of testing and what are those differences?

A: Exploratory testing is a method for evaluating software that is frequently defined as concurrent…

Q: Why is it important for an estimator to be knowledgeable of the OSHA requirements regarding…

A: Solution: An estimator must be knowledgeable of OSHA's safety rules and regulations for excavations…

Q: been cotracted to costruct a swimming pool at residential area, through your site investigation it…

A: The water content changes in the soil which lead to drastic volume change is termed as expansive…

Q: As a geotechnical engineer and considering the questions below, select the question or questions…

A: Note here i have to select only the desired question but i gave some explanation too

Q: What is a two-peg test, how is it conducted?

A: Two peg test checks wheather dumpy level is capable of showing true horizontal reading or not and if…

Q: Describe what is Stability Analysis for Gravity Dams?

A: The gravity dam is made up of concrete or masonry. The gravity gets hold down to the ground results…

Q: Determine the volume of excavation works required, assuming that Erika does not allow a quantity…

A: Given Equilateral Traingle : Volume = Area * Length = 1/2 * 6* 4*4 = 48 yd^2

Q: Discuss the challenges that might be faced by the contractor for the site clearing and earthworks…

A: Earthwork challenges In Earthworks many different activities all happening on at once. Even a small…

Q: Define the term Preconstruction Operations?

A: Pre-construction operation:

Q: 55 kM y 70 kN/m В C 3 m 7 m

A: Given : Simply supported overhang beam with UDl, UVL and point loads

Q: What is Flowable fill? What are its advantages and disavantages?

A: Flowable fill is a lean watery mix of concrete used for non structural works such as backfill and…

Q: Explain the concept of Estimation of the Rate of Consolidation Settlement ?

A: Solution: The consolidation settlement is basically time dependent settlement that occurs in clay…

Q: what is meant by the zone of risk test?

A: Zone of risk test?

Q: Does either the method of limits or the staircase method offer a better operational definition of…

A: 1.Answer In Fechner's Method of limits, threshold is defined as the average of the points on each…

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

6. Describe and provide and example of the most appropriate situation for the following: a) but-for or collapsed as-built analysis, b)
line-of-balance and c) impacted baseline techniques.
7. Many contracts require that the contractor prepare and present the construction schedule and receive the owner's approval before
any contract payments are made. Explain in detail what are the three elements of the contractor's schedule that the owner will
typically be interested in?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a certain portion of road to be constructed, the following data were taken. Station 20.00 6.85 +2.3 Station 6.0 +2.0 Base width for cut +1.5 +1.2 1+ 1+ 6 m 6.39 +1.0 6.9 +2.6 70 Solve for the volume using End-Area method.
Discuss Simple Elastic Solutions for Settlement
answer question 37 only
Explain some Traditional geotechnical design methods ?
Can recovery of contractor costs be made under a “Type 2 Differing Site Conditions” clause for weather-related delays?
In preparation of data what is the used as standard for comparison- Optimal rainfall- nominal rainfall- average rainfall- normal rainfall pls explain thankyou
What does evaluation record keeping policies include in WHS?
What are Influence Factors for Schultze and Sherif Method ?
Use the superposition method and determine: 1. The deflection of the beam at point C Important: It is known that.... • The modulus of elasticity of the beam is E = 29 x 106 psi • The moment of inertia of the beam is l= 350 in4 W A C - a B
Define the Berardi et al. (1991) an elastic approach CPT to estimate settlements ?
A shallow trench for a 1000-foot water line installment will take 10 days. It will take 4 days to install the first 400 feet of pipe. A water meter will then be installed during the following 2 days at the end of the pipe. After the meter is installed, the remaining 600 feet of pipe will be installed in 6 days. develop the linear schedule for this project.
Describe 4 or more applications of Failure Analysis