6. A. In the laboratory you measured the two primary characteristics of the PF5102 n- channel JFET: VGS-OFF and IDSs. Explain how you found the values for these two characteristics. B. Make a sketch of the channel region when VGS=VGS-OFF and make a sketch of the channel region when ID=IDSs and explain why each channel has this shape. C. Assuming that the measured values for the PF5102 were VGS-OFF= -1V and IDSS 10mA, design a common source amplifier for ID=4mA and VDS= 4V using a 12V supply and combination biasing without degeneration as you did in the laboratory. D. Find the input resistance, output resistance, and voltage amplification of your design using the hybrid-pi model and explain how you measured these parameters in the laboratory.

Q: Thevenin and Norton Equivalent: 15). For the circuit in Fig. 4.109, find Thevenin equivalent between…

A: We need to find out thevenin equivalent circuit and norton equivalent circuit

Q: Q2/ Compare between star connection and delta connection ?

A: In this question we will compare between star and delta connection.....

Q: difference between measurement uncertanty and measurement error

A: Given : Need to find the difference between measurement error and uncertainty.

Q: Q1-A LED had been connected to the output 12, write the codes of programing arduino UNO that the led…

A: There are two functions is used to turn ON/Off the LED. void setup(); This is used for the setup of…

Q: List the minimum trade size Type EMT for each of the following applications. (Objective 12-1)…

A: As per Bartleby expert policy only first individual question is to be answered. So, answering only…

Q: What information is contained in the specification K, 10,000

A: Kp stands for the position error constant for the step input function.  here, Kp = 10000

Q: please could give a simplified drawn schematic/diagram to show a how  microcontroller is connected…

A: The above question is based on the interfacing of a microcontroller to a relay circuit.

Q: In FET, what is the value for when Ip=lpss/2? [Approximate time to answer: 2 Minutes.] O gmo/2 O 3…

A: solve for transconductance

Q: Vab=C --- ) v (a) 2.5 v (b) - 2.5 v (c) - 10 v (d) 10 V

A: The solution can be achieved as follows.

Q: c) Given the changed lines of code below, answer the following questions. ANALOG_COMPARE_SETUP: LDI…

A: The given code is shown below.ANALOG_COMPARE _SETUP:LDI R16,0STS ADCSRA, R16LDI R 16, 0b00000000STS…

Q: I dont get it. howcan I make sure its in low condition?

A: You have asked that how to make sure it is in low condition.

Q: How must the uno be configured to create a traffic light? A. Pins can be configured any way B. 1 pin…

A: Arduino Uno :  The Arduino Uno is a microcontroller board based on ATmega32u4.

Q: please tell me last part answer

A: let Z = a+jb  then a is called real part and b is called imaginary part .

Q: What is HT supply?

A: What is HT supply?

Q: 3. Using Mason's Rule, find the transfer function T(s) = for the system represented in the fugre.…

A: Signal flow graphwe have to find Transfer function

Q: how did you find Rth?

A:

Q: Refer to the National Electrical Code or the working drawings when necessary. Where applicable,…

A: We are authorized to answer one question at a time, since you have not mentioned question you are…

Q: Is there an interference between multiple users in telephone system communication? If your answer is…

A: Ans .  No

Q: Electric Powers System for Nonelectrical Professional can you describe effective preventive…

A: Electrical Preventive Maintenance (EPM) is the act of leading routine assessments, tests, and the…

Q: My pofessor gave me a task, i need to write discription of image in step by step manner. kindly help…

A: It is asked to write description of image in step by step manner. In step 1 we need to write a short…

Q: Redo the question, a

A: It is given that: SS=150 KVAVP=3000 VVS=300 Vf= 50 HzVsupply=6250 V

Q: Q2)  The certain operational amplifier has the following data sheet specifications: IOS= 0.80 µA and…

A:

Q: For The Volfage-divider bias configurafion of the hgure Shown below, determine: Vc ,VE B IBQ. I ca,…

A:

Q: What is the difference between blocking assignments and non- blocking assignments ? What is the…

A: Verilog is a hardware description language. The memory and array declaration in Verilog is static.…

Q: HERE IS IT

A: Physical address can be expressed by the following formula:Physical Address = (Segment Address) x 10…

Q: Which is easier to use a bnc connector or sma connector

A: BNC are bigger and easier and faster to handle. SMA are quite a bit higher in frequency capability…

Q: Hoow did the r13 equate to sq root of 0.5? when it shouldve been 0.2?

A: It is given that:

Q: 13-Find the Thevenin and Norton equivalent circuits between ab. 2 A a 6 0 18 V 3 A 10 V

A: Given:

Q: The circuit shown in Figure Q5.1 consists of a current source connected to a load via a cable. The…

A: Given circuit is - Value of current source is -

Q: Convert below base20 number into base3 number  (7AD)base 20 Please provide answer as soon as…

A: