Q2 /Fill up the blanks in the following:6- the shape and surface texture of aggregate influence considerably the7-before the concrete has stiffened, at 1 to 2 hours after placing8- when small quantities of concrete have to be mixed by hand used9- The average rate mixing time about one minute to10-.....It is usual to vibrate concrete immediately after placing so that consolidation is generally complétedminutes.is a some of the water in the mix tends to rise to the surface of freshly placed concretear

Concrete is the homogeneous mixture of coarse aggregates,fine aggregates,cement ,water and…

6- the shape and surfäce texture 7- It is usual to vibrate concrete immediately after placing so that consolidation is generally complèted before the concrete has stiffened, at 1 to 2 hours after placing 8- when small quantities of concrete have 9- be mixed by hand used minutes. The average rate mixing time about one minute to 10- is a some of the water in the mix tends to rise to the surface of freshly placed concrete

6- the shape and surfäce texture 7- It is usual to vibrate concrete immediately after placing so that consolidation is generally complèted before the concrete has stiffened, at 1 to 2 hours after placing 8- when small quantities of concrete have 9- be mixed by hand used minutes. The average rate mixing time about one minute to 10- is a some of the water in the mix tends to rise to the surface of freshly placed concrete

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

i need clear ans and solve very very fast in 20 min and thank you | ᴅʏʙᴀʟᴀ ?✨؛
Given the four concrete mixes as shown in the table below, one without water reducers and three (c1-c3) with water reducer. The most economic mix where the workability and compressive strength maintained as for the original mix (the mix without water reducers) is With water Reducer Without water Reducer C1 C2 C3 Cement, Kg/m3 850 765 850 850 Water, Kg/m3 465 419 370 465 Slump, mm 50 S1 50 S2 Compressive Strength (MPa) 38 fc1 fc2 fc3 Select one: O A. C3 О В. С2 О С.С1 O D. C1 and C2
I need the answer as soon as possible
We need to solve them all. only the void
What is the initial and final setting time of ordinary Portland cement according to British and American standards
I need the answer as soon as possible
a) When the constituents of concrete are mixed fresh concrete paste is form and heat is produce. i) List the main constituents of concrete and explain their functions. ii) Name the chemical process and the heat produced in the all of the above constituent are mixed b) Table 1 shows the mix proportions of two concrete mixes. i) Calculate water cement ratio of Mix A & B j) Explain relationship the workability, water cement ratio and strength of the two concrete mixes. Table 1: Concrete Mixture Proportions (kg/m³) Concrete Mix Cement Sand Granite Water Proportion Mix A 350 600 1200 150 Mix B 350 600 1200 220
i need the answer quickly
Estimate the approximate quantity of Cement, Fine aggregate, Coarse aggregate and Water, for five (5) Concrete Cylinders. If one finalized the ratio from ACI-211 Mix design for specified strength as (1:1.3:2) and W/C of 0.48. (Assume the given ratio is by weight)
Plaese do question-3