Answered: 6 The number of turns in a wire winding… | bartleby

Related questions

Question

E6 The number of turns in a wire winding 0.2 m long is 200. Since 10A current flows
through this winding
a) Calculate the magnetic field strength H
b) Calculate the magnetic flux density B if the winding is used in vacuum.
c) Calculate the flux density if a Titanium rod is placed in the winding.
(XM=1.81x10-4)
d) Calculate the intensity M of the magnetization.
=
✔

Expert Solution

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

4. The loop in figure is being pushed into the 0.80 T magnetic field at 70 m/s. The resistance of the loop is 0.20 2. What are the direction and the magnitude of the current in the loop? Assume that x = 5.0 cm V • • B ● ● • ● ● • ● ● x ●
Which of the following statements best describes Oersted’s Principle? a. A current-carrying conductor produces a linear magnetic field from the north to the south pole b. A current-carrying conductor creates a circular magnetic field around a wire c. A solenoid will create a magnetic field similar to that of a bar magnet d. A charge entering a magnetic field will undergo circular motion e. None of the above explain Oersted’s Principle
1. A DC power line for a light-rail system carries 950 A at an angle of 33° to the Earth’s 5.00 × 10-5 T magnetic field. What is the magnitude of the force (in N) on a 125 m section of this line? 2. Consider a 150 turn square loop of wire 15.5 cm on a side that carries a 56 A current in a 1.6 T field. What is the maximum torque on the loop of wire in N⋅m? What is the magnitude of the torque in N⋅m when the angle between the field and the normal to the plane of the loop θ is 14°? 3. Consider two two long, straight, parallel, current-carrying wires, separated by a distance d = 4.5 cm, as shown in the figure. The left wire is directed out of the page with current I1, and the right wire is directed into the page with current I2. The point P is a distance d from both wires, so the wires and the point form an equilateral triangle. If both wires are carrying a current of 3.5 A, what is the magnitude of the magnetic field, in teslas, at point P? If the current from the left wire is 3.5 A…
A cylindrical solenoid that is 40-cm long generates a uniform magnetic field of strength 1.4 T inside the solenoid when the current is 7.0 A. How many turns of a single coil are present in this solenoid? a. 40,000 turns b. 64,000 turns c. 56,000 turns d. 48,000 turns e. 32,000 turns
Two high-current transmission lines carry currents of 45 A and 78 A in the same direction and are suspended parallel to each other 28 cm apart. If the vertical posts supporting these wires divide the lines into straight 16 m segments, what magnetic force does each segment exert on the other? _N. Exponential format with 2 SẺ. QUESTION 14 An induced emf will occur if A. the strength of the magnetic field is changed. B. the coil's area is changed. C. the angle at which the magnetic field and the coil's area meet is changed. D. all of the above.
You put a magnet inside a coil of wire. Why is there not a current produced in the coil when the magnet is sitting in the wire? Select one: a. The magnet has to be very strong to cause current to flow. b. There has to be motion to cause current to flow. c. The wire has to have low resistance for current to flow. d. The magnetic field inside the coil isn't changing.
18. Two very long conductors (both oriented in the same plane) are shown in the sketch below. The same magnitude of conventional current in each is represented by the red arrows. The black dot is at a position (in the same plane) equidistant between the conductors. Determine the direction of the magnetic field at the position of the black dot. A. There is no magnetic field at this position. B. The magnetic field is oriented out of the page. C. The magnetic field is oriented into the page. D. The magnetic field is oriented to the left. E. The magnetic field is oriented to the right.