Two high-current transmission lines carry currents of 45 A and 78 A in the same direction and are suspended parallel to each other 28 cm apart. If the vertical posts supporting these wires divide the lines into straight 16 m segments,what magnetic force does each segment exert on the other?_N. Exponential format with 2 SẺ.QUESTION 14An induced emf will occur ifA. the strength of the magnetic field is changed.B. the coil's area is changed.C. the angle at which the magnetic field and the coil's area meet is changed.D. all of the above.

Given: The current flow through wire 1 is I1 = 45 A The current flow through wire 2 is I2 = 78 A The…

Answered: Two high-current transmission lines…

Similar questions

9
106. The vertical magnetic field, initially zero, is slowly increased. When the field strength reaches the value B0, the rod, which was initially at rest, begins to move. Assume that the rod has a slightly flattened bottom so that it slides instead of rolling. Use g for the magnitude of the free-fall acceleration. Find μ0, the coefficient of static friction between the rod and the rails.
2. Suppose that a rectangular toroid has 2000 windings, h = 1 cm, an inner radius of R1 = 4 cm, and an outer radius of R2 = 6 cm. What is the current flowing through the toroid when the energy in its magnetic field is 2.0 x 10-6 J?
19. A square conducting loop of side a and resistance R passes through a region of space that has uniform magnetic field B into the page, as shown in the figure. Assume that the speed of the loop is constant throughout its motion. What is the magnitude and direction of the current in the loop: as it enters the magnetic field, a) b) while travelling inside the magnetic field, as it leaves the magnetic field. Provide your answer symbolically. a V Ø 8 Ø Top view Uniform magnetic field pointing into the page
A solenoid is wound on a rod 4 cm in diameter in 50 cm long. The windings carry a current of 3.5 A in the sense that is shown. The current produces a magnetic field of magnitude 4.1 mT at the center of the solenoid. The number of turns in the solenoid is closest to which? A. 4700 B. 3700 C. 470 D. 1900 E. 19
2. A slinky is stretched so that there is a gap of 0.95cm between each loop. The magnetic field at the center of the slinky is measured for a range of currents and a graph is plotted of B (in milli-Tesla) versus current I (in Amperes). The result is a straight line with a slope of 0.14 mT/A and an intercept of 0.024 mT. Determine the value of 4 from this result.
a.) a current in the CW direction to enhance the decreasing north magnetic field. b.) a current in the CW direction to enhance the decreasing south magnetic field. c.) a current in the CW direction to oppose the increasing south magnetic field. d.) a current in the CW direction to oppose the increasing north magnetic field. e.) no current in the coil. 7.) A conducting coil is rotated at constant speed in a uniform magnetic field as shown in the figure here. The time required by the loop to make a full rotation is T. The current generated in the coil would increase Side view a.) if the angular speed of the coil increases. b.) if the area of the coil increases. c.) if the strength of the magnetic field increases. d.) All of the above are correct. e.) None of the above are correct. 8.) An RLC circuit has a resonant frequency of fo. When the circuit is driven by an AC voltag source whose frequency is 2fo, which of the following is the most accurate?
A square wire 2.0 cm on each side is oriented so that a 5.00 mT magnetic field makes a 30.0° anglewith the normal to the plane of the square. If a 1.0 mA current causes a 32.0 N · m torque on thewire, how many loops does the wire make?A) 3.2 × 106 B) 4.5 × 1010 C) 1.6 × 1010 D) 3.2 × 1010
When the given bar magnet is placed along the NS line by identifying its poles, the field of bar magnet and the field are earth are aligned parallel and opposite by. Select one: O a. by rotating the drawing board O b. by rotating the bar magnet O c. rotating the compass needle O d. by rotating the earth field
4. A rectangular coil of wire (a = 28.0 cm, b = 36.0 cm) containing a single turn is placed in a uniform 4.80 T magnetic field, as the drawing shows. The current in the loop is 12.0 A. Determine the magnitude of the magnetic force on the right side of the loop. oof19 o0 19 0of19 oof19 009 oof19 dookig oof19 a oof19 0of19o B 19. 0of19 oof19.of19 oof19.0 0of19 0of19 c
3. A zero-resistance rod of length 14.4 cm is being pushed along zero-resistance wires in a region where a uniform magnetic field of strength 2.00 T is directed out of the page as shown. If the wires and rod complete a circuit through a 2.90 N resistor then what velocity will the rod maintain if it is subjected to a constant pushing force of 22.0 N? Zero-resistance wires Push