504. Determine the resistance of a conductor 0.10 m ong, with a uniform diameter of 1.0 cm and having a resistivity which varies as a function of length L measured from the one end of the conductor according to p = 0.003 + 104 L² ohm-cm. A. 0.0852 ohm 3. 0.0915 ohm C. 0.0806 ohm

504. Determine the resistance of a conductor 0.10 m ong, with a uniform diameter of 1.0 cm and having a resistivity which varies as a function of length L measured from the one end of the conductor according to p = 0.003 + 104 L² ohm-cm. A. 0.0852 ohm 3. 0.0915 ohm C. 0.0806 ohm

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Two parallel plates separated by distance of 5cm have a potential difference of 20V between them.…

Q: Current Attempt in Progress The figure shows a resistor of resistance R = 6.32 02 connected to an…

Q: a) State Kirchoff's first and second laws and name the fundamental physics principle that each law…

A: As per the guidelines of Bartley we supposed to answer first three subpart only.

Q: A) A solid specimen of dielectric, dielectric constant of 4.5, shown in the figure has an intemal…

A: As per Bartleby guidelines we are allowed to solve only question with maximum three subparts, please…

Q: A telephone line (cable) stretches between two points which are 150 ft apart and at the same…

Q: Power Triangle

Q: An electric toaster works by radiative heat transfer. On each side of a four-slice toaster, there…

A: Considering the power is radiated in the form of heat. Then by the Stefan Boltzmann law the power…

Q: A bar of gold (Au) is in thermal contact with a bar of silver (Ag) of the same length and area (see…

A: Given, A bar of gold (Au) is in thermal contact with a bar of silver (Ag) of the same length and…

Q: The student engineer of a campus radio station wishes to verify the effectiveness of the lightning…

A: A campus radio station is having, The resistance between C and E be Rx. Where point E is true…

Question

show the solution

504. Determine the resistance of a conductor 0.10 m
long, with a uniform diameter of 1.0 cm and having a
resistivity which varies as a function of length L
measured from the one end of the conductor
according to p = 0.003 + 10-4 L? ohm-cm.
A. 0.0852 ohm
B. 0.0915 ohm
C. 0.0806 ohm
D. 0.0902 ohm
A View Answer:
Answer: Option C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Q2/ Consider a bar of p-type silicon that is uniformly doped to a value of N₁ = 2 x 106 cm³ at T = 300 K. The applied electric field is zero. A light source is incident on the end of the semiconductor as shown in Figure. The steady-state concentration of excess carriers generated at x-0 is (0)=2x10¹4 cm³. Assume the following parameters: H = 1200 cm² /V-s, Tho = 106 s. Neglecting surface effects, (a) determine the steady-state excess electron concentrations as a function of distance into the semiconductor, and (b) calculate the steady-state electron diffusion current density as a function of distance into the semiconductor. Light x=0 p type
The electrical circuit representing a small axon section of length delta x is shown. Which of the following is NOT true if a potential difference is set up between the inside and the outside of the axon? Rm HE Cm Ro www R₁ A. The inside and outside of the axon are shown as Cm and Rm. B. There are four currents that can be identified in this circuit. C. The resistances can be simplified further in the series of axons. D. The capacitor can be removed to simplify the circuit (for ideal DC assumption).
Watch the video "Can 100% renewable energy power the world?" by Federico Rosei and Renzo Rosei. Write the important points that you have learned from the video.
please sir solve these 2 questions
For an electrical component, the formulas for charge and voltage are given here. q(t) =Ae$ vt)-Ce $ B. Your values of A, B, C, and D are given on the Student Values Spreadsheet. A is measured in coulombs, B is measured in seconds, C is measured in volts, and D is measured in seconds. (a) Give the current of this component at time t1, where t1 is measured in seconds and is given on the Student Values Spreadsheet. You must round your answer to the nearest thousandth and give your answer as an integer followed by the appropriate metric prefix and the letter that represents the units of current. (b) Give the power of this component at time t2, where t2 is measured in seconds and is given on the Student Values Spreadsheet. You must round your answer to the nearest thousandth and give your answer as an integer followed by the appropriate metric prefix and the letter that represents the units of power. (C) Give the total energy of this component from time 0 to time t3, where t3 is measured in…
The student engineer of a campus radio station wishes to verify the effectiveness of the lightning rod on the antenna mast (see the figure below). The unknown resistance Ry is between points C and E. Point E is a "true ground," but is inaccessible for direct measurement because the stratum in which it is located is several meters below Earth's surface. Two identical rods are driven into the ground at A and B, introducing an unknown resistance Ry. The procedure for finding the unknown resistance Rx is as follows. Measure resistance Ry between points A and B. Then connect A and B with a heavy conducting wire and measure resistance R, between points A and C.
What is the second equation?
Difficult problem that I need some help on please
please sir solve these 2 questions
Number 2 A piece of beef steak 7 cm thick will be frozen in the freezer room -30°C. This product has a moisture content of 73%, a density of 970 kg/m³, and a thermal conductivity (frozen) of 1.1 W/(m²K). Estimate the freezing time. using the Plank equation. This product has an initial freezing temperature of -1.75°C, and the movement of air in the freezing room gives a convective heat transfer coefficient of 15 W/(m²K). t f = answer in hour