5.1 The recommended scales for use on technical drawings are specified in the following table. Category Enlargement scales Full size Reduction scales 50: 1 5:1 Recommended scales 1:2 1:20 1 : 200 1: 2 000 20:1 2:1 1:5 1:50 1:500 1 : 5 000 10:1 1:1 1:10 1:100 1:1000 1:10 000 NOTE- If, for special applications, there is need for a larger en- largement scale or a smaller reduction scale than those shown in the table, the recommended range of scaies may be extended in either direction, provided that the required scale be derived from a recom- mended scale by multiplying by whole number powers of 10. In exceptional cases where for functional reasons the recommended scales cannot be applied, intermediate scales may be chosen.

5.1 The recommended scales for use on technical drawings are specified in the following table. Category Enlargement scales Full size Reduction scales 50: 1 5:1 Recommended scales 1:2 1:20 1 : 200 1: 2 000 20:1 2:1 1:5 1:50 1:500 1 : 5 000 10:1 1:1 1:10 1:100 1:1000 1:10 000 NOTE- If, for special applications, there is need for a larger en- largement scale or a smaller reduction scale than those shown in the table, the recommended range of scaies may be extended in either direction, provided that the required scale be derived from a recom- mended scale by multiplying by whole number powers of 10. In exceptional cases where for functional reasons the recommended scales cannot be applied, intermediate scales may be chosen.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please write the solution properly and give the given data first before solutions and input figures! Thank you.
X=1X=1I know you can do it please don't disappoint me I really like this website with big star. With big thumbs for you
Calculate with neat diagram.
Last digit is 8
As described in the Data and Results part of , all tables and graphs must have descriptive information such as titles, column or row headings, units, and axis labels, and data points must be clearly marked. All figures must be numbered and have a descriptive title. The figure number and the title should be placed below the figure. All tables must be numbered and have a descriptive title as well. However, for tables, the table number and the title should be placed above the table. The relationship between a spring force and its deflection is given in the table at the top of the next column. Plot the results using engineering paper and incorporating the ideas discussed in this chapter.
Define integer ambiguities.
Please write the complete solutions and FBD legibly. Good feedback will be given. Use 4 decimal places.
Draw diagram with computed values.
Please arrange the data in a table
Answer with given, required, and solution NO ROUNDING OFF DECIMALS pls draw diagrams with labels thank you
Give me right solution with clear calculations. Don't use any software.
can someone help me with this thank you I also added the sheet we are using in class. thank you again