5. The machine part of negligible weight is supported by a pin at A and a roller at C. Determine the magnitudes of the forces acting on the part at A and C.

Q: The 50-lb rectangular access door is held in the 90° open position by the single prop CD. Determine…

A: Given the weight of door and the position of door.  Required: F, A and B

Q: Also determine the magnitude of the force in hydraulic cylinder AB. Express your answer in units of…

A:

Q: 00 N. Draw the free body di

A: Load =100N Required Tension in the cable and free body digram

Q: Determine the unknown forces by applying d’alemberts principle to a free body.

A: Even in the course of Fundamentals of Dynamics and Kinematics of machines, this principle helps in…

Q: Statics of Rigid Bodies (Equilibrium of Rigid Bodies) 3. The 25-kg rectangular access door is held…

A: The Answer is below

Q: Water pressure in the supply system exerts a downward force of 30 lb on the vertical plug at A.…

A: The downward force at vertical plug A is .

Q: m The hoist supports an engine Determine magnitude of the force created by the engine mass

A: tanθ1=a+ba-btanθ1=2.2+1.12.2-1.1θ1=71.56o∑Fv=0RA+RB-mg=0RA+RB=mgRA+RB=175×9.81RA+RB=1716.75 N ,…

Q: mass The power unit A of the tractor-scraper has a mass of 5.9 Mg with mass center at G₁. The fully…

A: To find: The compression F in each cylinder and the magnitude of the force supported by each of the…

Q: The elements of a wheel-height adjuster for a lawn mower are shown. The wheel (partial outline shown…

A:

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: 8. The uniform rod in the figure shown weighs 400N and has its center of gravity at G. Determine the…

A:

Q: Q.2) Member ABC is supported by arm BD (pin connections at B and D) and a pin support at A. Member…

A:

Q: The structure is made of the light bar AB and the 50-kg uniform bar CD. Compute the magnitude of the…

A:

Q: draw the free-body diagrams for the set (or structure) complete and each of its parts. Ignore…

A: (a) Free-body diagram of the complete structure is given as, At points A and B, the hinge joints…

Q: 180 lb · ft В. C 9 ft 4.5 ft

A: Now draw the free body diagram for the above problem. Convert the triangular varying load into the…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.