5. The hanger is supported using the rectangular pin. Determine the magnitude of the allowable suspended load P if the allowable bearing stress is b,allow = 220 MPa, the allowable tensile stress is at,allow = 150 MPa, and the allowable shear stress is Tallow = 130 MPa. Take t = 6 mm, a = 5 mm and b = 25 mm. 75 mm 37.5 mm P 20 mm 10 mm 37.5 mm

Q: For the diagram shown, if the load P = 14 kips, determine: a. the normal force in the member Bar BD…

A: Given data: the applied loadP=14 kipsthe diameter of the pin Bd=0.5 intotal length of the beamL=10…

Q: The structure shown has a diameter of 40??. The length dimensions are ? = 525 ?? and ? = 110 ??.…

A: To find: The stress state at point H. Given: The diameter is D=40 mm. The dimension are a=525 mm and…

Q: A rod has a solid circular cross section with a diameter of 40 mm is subjected to the shown loads.…

A: To find: The state of stress at point A. Given: The area moment of inertia of solid circular cross…

Q: The C83400-red-brass rod AB and 2014-T6-aluminum rod BC are joined at the collar B and fixed…

A:

Q: The five-bolt connection shown must support an applied load of P = 370 kN. If the average shear…

A: Given data as per the question Applied load =370 KN Average shear stress =200Mpa

Q: Axial loads are applied to the compound rod that is composed of an Aluminum segment rigidly…

A: Given:As=400 mm2Aa=500 mm2Ab=300 mm2P=12 kN

Q: a) The normal stress in bar BD is most nearly b) The shear stress in the pin at D is most nearly…

A:

Q: The concrete post is reinforced using six steel reiforcing rods, each having a diameter of 20 mm.…

A: Given data: Diameter of each rod = d = 20 mm Applied axial load = P = 900 kN Modulus of elasticity…

Q: 250 mm D 750 mm 120 N•m The two shafts are made of A-36 steel. Each has a diameter of 25 mm, and…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.