5. Draw the Bode plot for the transfer function below with n = 2. Label the cutoff frequencies and slopes on the graph. Draw and label what the transfer function looks like as n approaches infinity. Magnitude (dB) 20 20 10 0 -10 -20 -30 -40 -50 100 H(w): 101 10² || (1+ 1 jw 1000 103 Frequency (rads 1) n 104 105

In a series RLC circuit, which element would you adjust and by how much to (a) (b)- (c) Double the bandwidth without changing the center frequency? Double the center frequency without changing the bandwidth? Repeat parts (a) and (b) for a parallel RLC circuit.

Question 1 Magnitude (dB) Phase (deg) 20 10 0 -10 -20 -30 -40 0 -45 -90 -135 -180 10 -1 Bode Diagram O a, 5 rad/s O b. 1.72 rad/s O c. 0.72 rad/s O d. None of the above 10° Frequency (rad/sec) The gain crossover frequency using the figure above is: 10

A parallel resonant circuit has a resistance of 2 k2 and half-power frequencies of 86 kHz and 90 kHz. Determine: (a) the capacitance (in nF) (b) the inductance (in uH) (c) the resonant frequency (in krad/s) (d) the bandwidth (in krad/s) (e) the quality factor

Required information A parallel resonance circuit has a resistance of 2 k and half-power frequencies of 84 kHz and 92 kHz. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the bandwidth. The value of the bandwidth is krad/s.

Required information A parallel resonance circuit has a resistance of 2 kQ and half-power frequencies of 84 kHz and 92 kHz. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the resonant frequency. The value of the resonant frequency is krad/s.

Identify the reason for a nonsinusoidal signal being distorted when it passes through a filter. -The distortion occurs because harmonics are removed or rejected, leaving a different waveshape. -The distortion occurs because harmonics are synchronized, leaving a different waveshape. -The distortion occurs because the signal is modulated, leaving a different waveshape. -The distortion occurs because harmonics are added in the filter, leaving a different waveshape.

1. Find the half power frequency and use the transfuntion to find the out for the given signal 2. Use the bode plots for the low pass filter to find the filter response for the signal

Please solve the following problem.

A parallel R-L-C circuit is fed by a constant current source of variable frequency. The circuit resonates at 100 kHz and the Q-factor measured at this frequency is 5. Find the frequencies at which the amplitude of the voltage across the circuit falls to (a) 70.7% (b) 50% of the resonant frequency amplitude.