5. An angle bracket ABC is restrained by a high- strength steel wire CD, and it supports a load P at A, as shown in Figure. The strength properties of the wire and the shear pin at Bare o, = 380 MPa (wire), and t= 350 MPa (pin at B).If the wire and pin are to be sized to provide a factor of safety against yielding of the wire of 3.0 and a factor of safety again st ultimate shear failure of the pin of 3.5, what are the required diameters of the wire (to the nearest mm) and the pin (to the nearest mm)?

5. An angle bracket ABC is restrained by a high- strength steel wire CD, and it supports a load P at A, as shown in Figure. The strength properties of the wire and the shear pin at Bare o, = 380 MPa (wire), and t= 350 MPa (pin at B).If the wire and pin are to be sized to provide a factor of safety against yielding of the wire of 3.0 and a factor of safety again st ultimate shear failure of the pin of 3.5, what are the required diameters of the wire (to the nearest mm) and the pin (to the nearest mm)?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Completely solve and box the final answers. Write legibly 5. How much twisting moment in lbf-ft is required to drive the shaft of the motor coupled to a pump with a rotational speed of 2,000 rpm. The pump efficiency is 82.0% and can deliver 2,000 gallons per minute of cold water to a height of 200 feet.
20 R3 Which tools that can be used to :3 draw the following shape in .AutoCAD 37 23 43 R3 dimension, circle, arc, line, scale and rectangle 30 dimension, arc, line, rectangle, purge, and block construction line, polygon, arc, polyline, and dimension rectangle, trim, dimension, polyline, circle, and arc O O
I need these three parts answered, if you are unable to answer all three parts please leave it for another tutor to answer, thank you.
2. Round off to FOUR DECIMAL PLACES for all calculations made.
Round off the numbers in the following problems to three significant figures. Find the percent difference between each rounded-off number and the original number by using the original number as the reference. 6748.3
Solve it correctly please. I will rate accordingly.
Please give answer clearly with each steps.
Draw the three projections of the body in Figure 1- using AutoCAD 1-Do not write the dimensions on the drawing 2- Draw with the same measurements as shown 3 -Show graphics properties At least properties are required for the circle and arc R10 R20 40 35 55 -1- JSI 9.
Completely solve and box the final answer. Write legibly 7. Calculate the specific heat of a substance in BTU/lbm-ºR if 17.8 pounds can raise its temperature from 71.4 ºF to 118.5ºF in a period of 1.12 minutes. The computed amount of heat applied to it is 4.79 HP.
show your solution at number 3
Round off the numbers in the following problems to three significant figures. Find the percent difference between each rounded-off number and the original number by using the original number as the reference. 26.394
Please solve quickly