5. A pull in a bicycle chain of 250 N applied to a sprocket of diameter 80 mm provides the necessary torque to the rear wheel. If the wheel is 600 mm in diameter, what is the force between the wheel and the ground?

Q: A ladder of length 2L and mass M is positioned on level ground leaning against a wall such that the…

A:

Q: Calculate the normal reactions on front and rear axles in case of front wheel drive vehicles. Take,…

A:

Q: The length AB for the lug wrench shown below is 12 inches. What is the maximum force (F) that one…

A: Given data:find:The maximum force

Q: Q2/ Arm ABC acts as a brake on the wheel as shown in Fig. 2. The coefficient of static friction at B…

A:

Q: 200 N 300 N 3 m B 500 N-m 200 N-m Figure 1 800 N 400 N-m 1100 N-m 300 N 200 N 300 N (a) (b) 500 N…

A:

Q: 4.) A flat belt makes contact with an 18 in. diameter pulley through half its circumference. If the…

A:

Q: rque Problem diagram below shows the lower leg being held in a stationary. The torque ng to turn the…

A: Angle made with horizontal = 50° Weight of leg WL = 90 N Weight of barbel Wb = 120 N Quadriceps…

Q: The diameter of two pulleys are (0.3m)and (0.2m), center distance (1m).if we use open belt drive.…

A: The diagram of the V-belt drive (open belt) is given as, The diameters of two pulleys are given as,…

Q: weighing 200 lb at point D. The vertical wall is smooth and offers no frictional resistance. The…

A: Given,

Q: The 6.0-1b bar is pinned at its center O and connected to a torsional spring. The spring has a…

A: In this problem first the moment about O is taken and the acceleration is integrated to get the…

Q: Shown in the figure below is a magazine resting on top of a book. There is static friction between…

A: given:

Q: 2.18 A 200# stone is being lifted off the ground by a lev- ering bar. Determine the push P required…

A:

Q: In the figure, a slab of mass m, = 40 kg rests on a frictionless floor, and a block of mass m, = 9…

A:

Q: A flat belt makes contact with an 16 in. diameter pulley through half its circumference. If the…

A: Given data:- Diameter of pulley =16 in Angle of contact θ =π the coefficient of friction μ = 0.45…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.