5. A heat pump operates on the ideal vapor-compression refrigeration cycle and uses refrigerant- 134a as the working fluid. The condenser operates at 1000 kPa and the evaporator at 200 kPa. Determine this system's COP and the rate of heat supplied to the evaporator when the compressor consumes 6 kW.

5. A heat pump operates on the ideal vapor-compression refrigeration cycle and uses refrigerant- 134a as the working fluid. The condenser operates at 1000 kPa and the evaporator at 200 kPa. Determine this system's COP and the rate of heat supplied to the evaporator when the compressor consumes 6 kW.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please answer Q5 and Q6 Thanks in advanced!
Please solve all three.
Solve correctly please.
need Z. Need only handwritten solution only (not typed one).
Show complete and detailed solutions. Write legibly. View Image.
Name at least two units that you use every day.
1.) A.) A cutting operation is performed on a piece of metal. The rake angle of the tool, α, is eight degrees. The tool penetrates the work to a depth of 8mm. The chips generated from this cut are 20mm thick. Calculate the shear plane angle, Φ, in the orthogonal model for this operation. Give your answer in degrees B.) For the same cutting operation, the cutting and thrust forces are measured. The cutting force is measured as 1600N, and the thrust force is measured as 1300N. The width of the cut is 4mm. What is the shear stress applied by the tool? Give your answer in MPa.
If 700 J of work are done in 7 seconds then which of the following is the average power produced? Select one: O a. 100 W O b. 7 W O c. 700 kW O d. 4900 W O e. 700 W
I am attaching both questions for 4 and 5 with the question in the image. thank you. NOTE : So the last person answered this question WITHOUT refencing the answer for whether question 4 or 5 answeres were given, so i am asking for question 5(or the answer for the question that was NOT solved because it was not referenced.) These were the following answers given to me from the last person on bartleby who answered my question without referencing whether it was the answer for question 4 or 5. 1 pass 2 fail 3 fail 4 pass
I need these three parts answered, if you are unable to answer all three parts please leave it for another tutor to answer, thank you.
In a lathe machine, The diameter of the driver and driven pulley are 2745 mm and 1200 mm respectively, And the driver pulley runs at speed of 225 rpm. Find the speed at which is driven pulley runs in the machine. the speed of the driven pulley in rpm is
i need the answer quickly