Answered: 5 In the diagram, a 4-wheel drive… | bartleby

Related questions

Question

5 In the diagram, a 4-wheel drive vehicle is bogged on a muddy road.
A winch is pulling the vehicle with a force of 2000N. The chain
connecting the winch to the vehicle makes an angle of 15° with the
direction of motion. Calculate, correct to the nearest newton, the
winch
1200N
4WD 15
direction
of motion
magnitude of the component of the force:
a in the direction of motion,
b perpendicular to the direction of motion.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

The block in the figure below has a mass of 5.9 kg and it rests on an incline of angle 0. m 07 You pull on the rope with a force F = 38 N. Assume the incline is smooth and determine the angle of the incline if th moves with constant speed.
A fish has been hooked and is pulling on the line as shown in the figure below. 25.0⁰ N.m 25.0⁰ 35.0⁰ T If the pole makes an angle of 25° with the horizontal, the distance between the point where the line is attached to the pole and the anglers hand is L = 2.00 m, and the fish pulls on the line such that the tension in the line is T = 130 N at an angle 35.0⁰ below the horizontal, determine the magnitude (in N m) of the torque exerted by the fish about an axis perpendicular to the page and passing through the angler's hand.
Two boxes are stacked as shown in the diagram below. The bottom box has a mass of 3.5 kg and the top box has amass of 1.5 kg. They are pushed up a ramp inclined at 15° by an applied force of 25 N, applied to the lower boxand directed parallel to the ramp. The coefficient of kinetic friction between the ramp and the bottom box is 0.12.Determine the minimum coefficient of static friction required to keep the top box in place on the bottom box.
Pls help ASAP.
A 37 N block rests on an inclined plane with a slope of 25°. What is the normal force acting on the block?
ebAssign 110 N 40 ASK YOUR TEACHER 3. DETAILS SERCP11 4.7.P.065.MI. Objects with masses m, = 15.0 kg and m, = 8.0 kg are connected by a light string that passes over a frictionless pulley as in the figure below. If, when the system starts from rest, m, falls 1.00 m in 1.78 s, determine the coefficient of kinetic friction between m, and the table. 4. DETAILS SERCP11 5.2.OP.015. ASK YOUR TEACHER A 7.80 g bullet is initially moving at 620 m/s just before it penetrates a block of wood to a depth of 5.80 cm. (a) What is the magnitude of the average frictional force (in N) that is exerted on the bullet while it is moving through the block of wood? Use work and energy considerations to obtain your answer. (b) Assuming the frictional force is constant, how much time (in s) elapses between the moment the bullet enters the block of wood and the moment it stops moving?
The figure below shows a Ferris wheel that rotates four times each minute. It carries each car around a circle of diameter 18.0 m. Тop bot nop R mg Bottom What force (magnitude and direction) does the seat exert on a 36.0-kg child when the rider is halfway between top and bottom? magnitude 353 90.0 Your response differs from the correct answer by more than 100%.° measured inward from the vertical direction
a person is trying to judge whether a picture (mass =2.59kg) is properly positioned by temporarily pressing it against a wall. the pressing force is perpendicular to the wall. the coefficient of static friction between the picture and the wall is 0.650. What is the minimum amount of pressiong force that must be used? answe is 39N
A 1.5 kg block resting ina rough flat surface is pulled by a string. The string makes an angle of 20 degress with the horizontal. The coefficient of static friction between the blodk and the surface is 0.35. What is the maximum tension in the string to keep the block unmoved?
Mass = 5kg Force = 8N a) Calculate the horizontal and vertical tension vector values. b) Calculate angle theta.
question 3