5-A steam power plant operates on the simple ideal Rankine cycle between the pressure limits of 10 kPa and 10 MPa, with a turbine inlet temperature of 600°C. The rate of heat transfer in the boiler is 800 kJ/s. Disregarding the pump work, the power output of this plant is (a) 243 kW (b) 284 kW (c) 508 kW (d) 335 kW (e) 800 kW

5-A steam power plant operates on the simple ideal Rankine cycle between the pressure limits of 10 kPa and 10 MPa, with a turbine inlet temperature of 600°C. The rate of heat transfer in the boiler is 800 kJ/s. Disregarding the pump work, the power output of this plant is (a) 243 kW (b) 284 kW (c) 508 kW (d) 335 kW (e) 800 kW

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

10- A steam power plant with a power of 210 MW operates according to the simple ideal Rankine cycle. The steam enters the turbine at 10MPa pressure and 500 ºC and is cooled in the condenser at 10 kPa pressure. Calculate the mass flow of steam. A-164,7 kg/sB-96,3 kg/sC-35,4 kg/sD-65,8 kg/sE-154,9 kg/s (Note: This question is Turkish) orginal question: 210 MW gücünde bir buharlı güç santrali basit ideal Rankine çevrimine göre çalışmaktadır. Buhar türbine 10MPa basınç ve 500 ºC sıcaklıkta girmekte ve yoğuşturucuda 10 kPa basınçta soğutulmaktadır. Buharın kütlesel debisini hesaplayınız.
Consider a steam power plant, which can be modeled using the ideal reheat Rankine cycle. The steam entering the high- pressure turbine is at 6 MPa and 400 degrees C and leaves at 2 MPa. The steam is then reheated to 400 C at constant pressure, before it expands to 20 kPa in the low-pressure turbine. Calculate: (a) the turbine work output in kJ/kg (b) the thermal efficiency of the cycle
In a reheat cycle steam at 15 Mpa, 540°C enters the engine and expands to 1.95 Mpa. At this point the steam is withdrawn and passed through a reheater. It reenters the engine at 540°C. Expansion now occurs to the condenser pressure of 0.0035 Mpa. (a) For the ideal cycle, find ee (b) A 60,000 kW turbine operates between the same state points except that the steam enters the reheater at 1.95Mpa and 260°C, departs at 1.8 Mpa and 540°C. The steam flow is 147,000 kg/hr; generator efficiency is 96%. For actual engine, ek, mk, and nk, (c) Determine the approximate enthalpy of the exhaust steam if the heat lost through the turbine casing is 2% of the combined work.4. Steam at 200 bar, 760°C enters the thrott
T B A D Consider the cycle in the diagram (very similar to the Rankine Cycle) using water as the working fluid. Process A-B: A saturated mixture of water is pumped from low pressure to a high pressure saturated liquid in an iso-entropic (and adiabatic) process. Process B-C: The high pressure saturated liquid enters a boiler where it is heated at constant pressure process by an external heat source to a super-heated vapor. Process C-D: The super-heated vapor goes through a turbine, generating power exiting as a saturated vapor. Assume an iso-entropic (and adiabatic) process and neglect kinetic energy and potential energy changes. Process D-A: The saturated vapor then enters a condenser where it is condensed at a constant pressure process back to its original state. The boiler operates at 10 MPa (points B & C) and the condenser operates at 100 kPa (points A & D). Assume a mass flow rate of 1 kg/s. a) Make a table of the temperature, pressure, volume, internal energy, enthalpy, entropy…
T B A D Consider the cycle in the diagram (very similar to the Rankine Cycle) using water as the working fluid. Process A-B: A saturated mixture of water is pumped from low pressure to a high pressure saturated liquid in an iso- entropic (and adiabatic) process. Process B-C: The high pressure saturated liquid enters a boiler where it is heated at constant pressure process by an external heat source to a super-heated vapor. Process C-D: The super-heated vapor goes through a turbine, generating power exiting as a saturated vapor. Assume an iso-entropic (and adiabatic) process and neglect kinetic energy and potential energy changes. Process D-A: The saturated vapor then enters a condenser where it is condensed at a constant pressure process back to its original state. The boiler operates at 8 MPa (points B & C) and the condenser operates at 200 kPa (points A & D). Assume a mass flow rate of 1 kg/s. Make a table of the temperature, pressure, volume, internal energy, enthalpy, entropy and…
A steam power plant operates on the basis of Rankine cycle between the pressure limits of 10 MPa in the boiler and 15 kPa in the condenser. The turbine inlet temperature is 4250C. The turbine isentropic efficiency is 90 percent, the pump losses are negligible, and the cycle is sized to produce 2500 kW of power. (a) Calculate the mass flow rate through the boiler, the power produced by the turbine, the rate of heat supply in the boiler, and the thermal efficiency (b) How much error is caused in the thermal efficiency if the power required by the pump were completely neglected? c) fill the table stream 1 2 3 state T(C) P(kPa) H(kj/kg)
3 (a) A simple Rankine cycle uses water as the working fluid (Figure Q3). IA 9 in 4s 4 gout Figure Q3. Rankine Cycle The boiler operates at 7,000 kPa and the condenser at 100 kPa. At the entrance to the turbine, the temperature is 450 °C. The isentropic efficiency of the turbine is 90%, pressure and pump losses are negligible, and the water leaving the condenser is subcooled by 9.6 °C. The boiler is sized for a mass flow rate of 20 kg/s. Determine, (i) The rate at which heat is added in the boiler, (ii) The power required to operate the pumps, (iii) The net power produced by the cycle, (iv) The thermal efficiency. (b) After a long walk in the 14 °C outdoors, a person wearing glasses enters a room at 25°C and 60% relative humidity. (i) What is the difference between specific and relative humidity? (ii) Please explain whether the glasses will become fogged or not and why. An
A steam power plant is operating in an ideal Rankine cycle. The boiler pressure is 2 MPa and steam leaves the boiler as a saturated vapor. The condenser pressure is 10 kPa. What is the pump work in kJ/kg?
H.W 1- A stationary gas-turbine power plant operates on a simple ideal Brayton cycle with air as the working fluid. The air enters the compressor at 95 kPa and 290 K and the turbine at 760 kPa and 1100 K. Heat is transferred to air at a rate of 35,000 kJ/s. Determine the power delivered by this plant (a) assuming constant specific heats at room temperature and (b) accounting for the variation of specific heats with temperature. 2- A gas-turbine power plant operates on the simple Brayton cycle with air as the working fluid and delivers 32 MW of power. The minimum and maximum temperatures in the cycle are 310 and 900 K, and the pressure of air at the compressor exit is 8 times the value at the compressor inlet. Assuming an isentropic efficiency of 80 percent for the compressor and 86 percent for the turbine, determine the mass flow rate of air through the cycle. Account for the variation of specific heats with temperature.
Carnot cycle heat pump utilizes R-134a as the working fluid. Heat is transferred from the fluid at 100 F, and during this process the refrigerant changes from saturated vapor to saturated liquid. Heat transfer for the refrigerant takes place at 20 F. You are asked to do the following: (a) Show and describe the cycle on a T-s diagram (b) Calculate the quality at the beginning and at the end of the isothermal process at 20 F (c) Determine the coefficient of performance for the cycle.
Superheated steam generated in a power plant at a pressure of 8,600 kPa anda temperature of 500 ℃ is fed to a turbine. Exhaust from the turbine enters acondenser at 15 kPa, where it is condensed to saturated liquid, which is thenpumped to the boiler.(a) What is the thermal efficiency of a Rankine cycle operating at theseconditions?(b) What is the thermal efficiency of a practical cycle operating at theseconditions if the turbine efficiency and pump efficiency are both 75%?Which of the two efficiencies has greater impact on the thermal efficiency?(c) Sketch both cycles in the same T-s diagram.(d)If the power output of the turbine is 80,000 kW in case (b), calculate themass flow rate of the working fluid.(e) Calculate the heat transfer rates in the boiler and the condenser. Doublecheck the result for the condenser.(f) For both cases (a) and (b), make a comment about the operation of turbine(issue of cavitation). [one sentence is fine](g) How you would operate the condenser of a practical…
1. Consider a steam power plant that operates on a simple ideal Rankine cycle and has a net power output of45 MW. Steam enters the turbine at 7 MPa and 500°C and iscooled in the condenser at a pressure of 10 kPa by runningcooling water from a lake through the tubes of the condenserat a rate of 2000 kg/s. Show the cycle on a T-s diagram withrespect to saturation lines, and determine (a) the thermal efficiency of the cycle, (b) the mass flow rate of the steam, and(c) the temperature rise of the cooling water. Answers:(a) 38.9 percent, (b) 36 kg/s, (c) 8.4°C 2. Consider a 210-MW steam power plant that operateson a simple ideal Rankine cycle. Steam enters the turbine at10 MPa and 500°C and is cooled in the condenser at a pressure of 10 kPa. Show the cycle on a T-s diagram with respectto saturation lines, and determine (a) the quality of the steamat the turbine exit, (b) the thermal efficiency of the cycle,and (c) the mass flow rate of the steam. Answers: (a) 0.793,(b) 40.2 percent, (c) 165…