5 A metal has the following flow curve equation of O, = 850€ 03 where o, is in MPa. A part made of this metal is stretched to 150 mm from an initial length of 100 mm. The flow stress at the new length and the average flow stress that the metal has been subjected to during the deformation are, respectively, (a) 648 MPa, 498 MPa (b) 748 MPa, 598 MPa (c) 648 MPa, 598 MPa (d) 748 MPa, 398 MPa

5 A metal has the following flow curve equation of O, = 850€ 03 where o, is in MPa. A part made of this metal is stretched to 150 mm from an initial length of 100 mm. The flow stress at the new length and the average flow stress that the metal has been subjected to during the deformation are, respectively, (a) 648 MPa, 498 MPa (b) 748 MPa, 598 MPa (c) 648 MPa, 598 MPa (d) 748 MPa, 398 MPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Hello, I was just wondering how you find hte angle of the blocks to 45 degrees? Thank you!
How to draw 4/5 × 2/3 on a model
Need questions 13, 14, 15 explained and answered please.
In section views, match patterns should be drawn parallel to one of the edges of the part. True? A. Yes, always B. Optional C. Never Section views must retain the same scale as the part from which they are created. True? A. Yes, true B. No, they may be scaled
Provide a demonstrated drawing of the figure (construct) as well
If the answer is no can anything be done to save the part?
Diagram: Given the hook-up drawing, list all the equipment, tools and materials that are needed in installation. INST. PIPING 1- *1 INST. PIPING
Question 3 The Extrude Cut feature in SOLIDWORKS can be used to create both through holes (holes that go all the way through a part) and counter bore holes (holes that do not go all the way through a part), such as the holes shown in the 2-dimensional image below. True False Counterbore
2.... Hydraulic controlled riveting assembly machine. hydraulic control system. Must include the following controls: Rotational control of the index table (150 lbs weight). Part clamps at each station . Rivet insertion station (guarded station not clearly shown - assume pick (up/down) and place (forward/return) motion, with rivet gripper control (grip/release). Drill station to attach the rivet. Total cycle should be 10 seconds. how would that schematic look, and how would the speed, forces, and heat loss be calculated. there were no other info given as far as flow rate, torque and things like that. where would you start?
TYPEWRITTEN ONLY PLEASE UPVOTE. DOWNVOTE FOR HANDWRITTEN. DO NOT ANSWER IF YOU ALREADY ANSWERED THIS
Orthographics: Add missing lines and complete any missing views. Draw the isometric
Engineering drawing layout usually include a statement regarding ownership confidentiality or other legal subject matter. True or False