Answered: 47. (II) (a) What is the maximum…

47. (II) (a) What is the maximum instantaneous power dissi- pated by a 3.0-hp pump connected to a 240-Vms ac power source? (b) What is the maximum current passing through the pump?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Can the instantaneous power output of an ac source ever be negative? Can the average power output be…

Q: 15. A 100µF capacitor in series with a 402 323 1o3 resistance is connected to a 110V. 60 Hz supply.…

A: Solution:-Given thatCapacitance (C)=100 μF=100×10-6 F=10-4 FResistance (R)=40 ΩBoth are connected in…

Q: What is needed so that we can use the AC power source in appliances that requires only low AC power?

A: Transformer is device which can be two types according to its working. If a transformer convert high…

Q: Assume you have A power supply A delivers 10 V dc with a ripple voltage of 0.5 V while the power…

Q: An AC power generator produces 20 A (rms) at 400 V. The voltage is stepped up down 120V by an ideal…

Q: 13-15. For the circuit below, i, = 1.4 A. Calculate ix and the total power dissipated by the…

A: io = 1.4 ALet, Ro = 16 Ω, R1 = 8 Ω, R2 = 4 Ω, and R3 = 2 Ω

Q: A 54.0-?F capacitor is connected to a 46.0-N resistor and a generator whose rms output is 30.0 V at…

A: Given: Capacitor,C=54μF=54×10-6FResistance,R=46ΩRMS Voltage,VRMS=30VFrequency,f=60Hz The term RMS…

Q: Q4) Find the current i(t) for the series RC circuit if the applied voltage is E(t) = 4e- given that…

A: Given: Applied voltage is Et=4e-t. R=3Ω C=1F q0=0

Q: 2) 21.51: How many time constants does it take for the potential difference across the resistor in…

Q: Vh at is the maximum instantaneous power disSi- ted by a 3.0-hp pump connected to a 240-Vrms ac…

Q: Question 34.) A short circuit in a 120 V appliance cord has a 0.35 Ω resistance. 1.) Calculate the…

Q: Which AC circuit parameter below is not always changing its magnitude? Select one: O 1. Power O 2.…

Q: B. (1) An ac voltage, whose peak value is 180 V, is across a 330- resistor. What are the rms and…

Q: What happen when you reverse the direction of the battery? What happen when you change the current…

A: a) It is known that a battery in a circuit provides the potential difference and due to this current…

Q: A choke coil in series with a lamp is connected to a dc line. The lamp is seen to shine brightly.…

A: Given: A choke coil

Q: A light bulb is rated 100W for 220V ac supply of 50Hz.Calculate (1) The resistance of the bulb; (ii)…

Q: 4) Based on the circuit to the right answer the folowing questions. SHOW ALL WORK Swilch is closed…

A: solution of above question given in below step.

Q: "In the RLC circuit of the following figure: R = 100 N , C = 0.1 µF, and L = 0.5 Henry. QUESTION 24…

Q: The phasor diagram in Figure 3 shows the values of currents flowing thra a parallel network of…

A: Given: The RMS supply voltage is 240 V. The frequency of the source is 50 Hz. IC=10 AIR=15 AIL=15 A

Q: om the An AC voltage source has an amplitude of 96. V and frequency 400. Hz. The voltage was zero…

Q: (II) A power station delivers 750 kW of power at 12,000 Vto a factory through wires with total…

A: As we know , I = P/V = 750000 W/ 12000 = 62.5 A Ploss = I2R = (62.5)2×3 = 11718.75 W

Q: (II) A 3.5 kΩ resistor and a 3.0μ F capacitor are connectedin series to an ac source. Calculate the…

A: Given quantities: Resistance (R) = 3.5 kilo ohm capacitance (C) = 3.0 micro Farad Let, the impedance…

Q: If you placed an AC voltmeter across the outlets of a wall socket in Europe, you would measure…

Q: 3. A ball is thrown vertically upward with a speed of 15.0 m/s. (a) How high does it rise? (b) How…

A: According to guidelines we need to solve only first three sub-part kindly repost other parts in the…

Q: 3- which circuit will give higher impedance? Explain in detail M1 M2 M2 M1 A

A: Answer: Introduction: As per the above-given circuits, Below is the brief explanation of both the…

Q: When you want to measure the AC voltage, which range will you set the knob to? 3 V 600 600 V 1 200…

A: To measure the AC voltage to which range the knob of multimeter is to be set.

Q: (I) A 3500-pF capacitor is connected in series to a 55.0 μHcoil of resistance 4.00Ω What is the…

A: At resonance XL=XC Thus, 2πfrL=12πfrCfr2=12π2LCfr=12πLC

Q: (I) An ac voltage, whose peak value is 180 V, is across a 330-N resistor. What are the rms and peak…

Q: frequencies, the effective impen- At very high of the given circuit will be 192 0.5F ww Ω. 292 0.5F…

Q: 20 What is the potential difference between points Land Min the circuit in the figure? Note: The…

Q: (I) At what frequency will a 2.40μF capacitor have a reactance of 6.10 KΩ ?

A: Using the equation for capacitive reactance, XC=12πfCf=12πXCC

Q: ) All bus voltages drop when a control system failure happens. (Are you sure this is so or are you…

A: Yes if the control system failures happens then all bus voltages may drop to zero if they are all…

Q: Pel The RC Circuit in the followihg Fyu R=3 KSL and C= 5MF. The Capacitor has Valdage 6 at t:o when…

A: Using concept of charge on capacitor in RC circuit

Q: "In the RLC circuit of the following figure: R = 100 Q, C = 0.1 µF, and L = 0.5 Henry. QUESTION 25…

A: Given : RLC circuit with Resistance, R = 100 ohm Inductance, L = 0.5 H Capacitance, C = 0.1×10-6 F

Q: se 2. The phasor of an AC voltage is given as V, -10-10V. Assuming that co= 5 rad/sec. this voltage…

A: Given data, Voltage is given as, V0=10-j10 V. Angular frequency ω=5 rad/s.

Q: A load of 140 MW at a power factor of 0.65 lagging can be delivered by a 3-phase transmission line.…

Q: The rms current through a light bulb is 0.653 A when the bulb is connected to a standard 120 V rms…

Q: 5) Consider the DC-circuit shown below. This is an example of a parallel circuit, with a 12 V power…

Question

47. (II) (a) What is the maximum instantaneous power dissi-
pated by a 3.0-hp pump connected to a 240-V,ms ac power
source? (b) What is the maximum current passing
through the pump?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

2.) Para llel Circuit R, = |452 R3 62 50V I, Is 2. V,
5. (Consider the electrical circuit shown below. If the voltage input e, is sin wt, what is the output voltage e, at steady state?
(II) The peak value of an alternating current in a 1500-Wdevice is 6.4 A. What is the rms voltage across it?
(a) At what two times in the first period following t = 0 does the instantaneous voltage in 60-Hz AC equal Vrms ? (b) −Vrms ?
Final answer please.
-0.005- DC Auto Range CF AINMAX RANGE mV OFF 400 mA 600V CAT & 1000V CATE 10A FUSED COM 9. From the above picture, the digital multimeter is used for measuring DC Voltage + by connecting both terminals.
28b) When load current increases, the terminal voltage of DC shunt Generator is reduced. Justify
(a) At what two times in the first period following t=0 does the instantaneous voltage in 60-Hz AC equal Vrms ?(b) -Vrms ?
(II) A model-train transformer plugs into 120-V ac and draws0.35 A while supplying 6.8 A to the train. (a) What voltageis present across the tracks? (b) Is the transformer step-upor step-down?
(a) At what two times in the first period following t = 0 does the instantaneous voltage in 60-Hz AC equal Vrms ? (b) −Vrms ?
3. (i) Three identical capacitors are connected in delta with 400 V. If the line current is 12 A determine the capacitance of each of the capacitors. If the 0 = 60° then calculate the power dissipation in kW when it connected in STAR
The rms current through a light bulb is 0.717 A when the bulb is connected to a standard 120 V rms source. (a) Find the bulb's resistance. (b) Find the peak instantaneous current. (c) Find the peak instantaneous voltage. (d) Find the average electrical power used by the bulb.