4/3- Methods of Joints/ Méthode des Nœuds Sample Problem / Exemple (4-1) Compute the force in each member of the loaded cantilever truss by the method of joints. 5 m A 30 kN RO 5 m 5 m 5 m с 5 m 20 kN D 5 m 5 m Calculez la force dans chaque barre du treillis cantilever en utilisant la méthode des nœuds.

Q: Why is it important to determine the slopes and displacements?

A: Slope – when ever any load is applied on the beam due to its elastic properties it bend in very…

Q: In the drawing operation, technological property weldability is an important parameter. Select one:…

A: Drawing: It is a process in which uses tensile forces is used to stretch metal.

Q: What is meant by the idea of testing individual units?

A: By the idea of testing individual units we mean that it is a process of software development in…

Q: Hi is there any way the format can be changed a little bit so I can see the full explanation?

A: Given Data

Q: What are 1-, 2-, and 3-point perspectives? Draw cubes of different sizes using 1-, 2-, and 3-point…

A: Approach to solving the question: drawing, constructing of answer Detailed explanation: Examples:Key…

Q: Need auxiliary views of this drawing

A: This question is based on the concept of engineering drawing.

Q: How would tou answer #10?

A: As mentioned in the question to solve #10, i will solve only question 10th

Q: If the part was cut by this plane, what would the resulting remaining face look like?

A: Section planes in SketchUp cut a model along a plane so you may look within it without altering…

Q: On a technical drawing, what is the difference in the application of the "cutting plane line" and…

A:

Q: What is areal velocity?

A: The measure of the velocity of one celestial body in orbit to another body which is equal to the…

Q: 9. The top view shows a bend radius of the thin metal. Would a bend radius of 1/8" meet the…

A: If the bend radius lies with in the given range then it will meet the requirements. 18"=0.125" The…

Q: What happens when Fabrication Errors occur?

A: Fabrication errors are defined as errors which are occurred due to improper or incorrect fabrication…

Q: What is line of impact?

A: The line of impact is the line along which the impact forces act during the collision. Generally, it…

Q: Question 2 ( When creating a solid model part intricate geometry of your part, s True

A: Solidworks or ansys is a software where simpler and more complex designs can be drawn with each…

Q: How were the areas for part 2 found?

A: Given Data and to find: How the areas are calculated?

Q: Describe the method of sections?

A: Method of section In this method we deal with the non-concurrent forces. Here, we get three…

Q: How far from the lens must the film in a camera be, if the lens has a 32.0 mm focal length and is…

A: Given data as per question Object distance(u) =80 cm =800 mm Focal length(f) =32 mm  Here Location…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.