4. The magnetic strength of a coil depends on a. current direction. b. the left-hand rule. c. flux direction. d. current magnitude. e. the point where the field emerges. 5. A 20-turn coil, with an air core, carries a current of 2 amperes. The magnetic strength of the coil can be increased by a. making the turns larger. b. inserting an iron core. c. decreasing the current. d. slightly decreasing the voltage drop across the coil. e. reversing the current direction. 6. When iron filings are attracted to a current-carrying conductor, this indicates a. a magnetic field direction. b. a N pole. c. the presence of a magnetic field. d. the strength of a magnetic field. e. the magnitude of current. 7. The properties of a magnet are present in a. a loop of wire. b. a straight wire. c. many turns of wire. d. a straight wire carrying current. e. a current-carrying loop of wire.

4. The magnetic strength of a coil depends on a. current direction. b. the left-hand rule. c. flux direction. d. current magnitude. e. the point where the field emerges. 5. A 20-turn coil, with an air core, carries a current of 2 amperes. The magnetic strength of the coil can be increased by a. making the turns larger. b. inserting an iron core. c. decreasing the current. d. slightly decreasing the voltage drop across the coil. e. reversing the current direction. 6. When iron filings are attracted to a current-carrying conductor, this indicates a. a magnetic field direction. b. a N pole. c. the presence of a magnetic field. d. the strength of a magnetic field. e. the magnitude of current. 7. The properties of a magnet are present in a. a loop of wire. b. a straight wire. c. many turns of wire. d. a straight wire carrying current. e. a current-carrying loop of wire.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Probl The rectangular coil in the figure below is in a field B = 0.01a,T. a. Find the torque about the z axis when the coil is in the position shown and carries a current of 10 A b. Find the torque if the coil turns through 90°7 0.2m & 0.2m 1-10A
1. A magnetic circuit constructed of sheet steel has an average length of 1.5 m and cross sectional area of 0.025 m². A 50 turns coil wound on the ring has a resistance of 0.8 Q and draws 4 A from A DC supply. The relative permeability is 5000. Determine a) The flux density. b) Voltage applied. c) If the material is replaced with another material with a relative permeability of 3000 and keeping the other parameters as it is then calculate the new flux and explain what happened.
14. A coil with 150 turns is wound over a 200 cm a cylinder iron core whose relative permeability is 250. If a current of 2 A is pass through the coil, determine the flux density in the core. a. 0.04 T b. 0.07 T c. 0.12 T d. 0.10 T
A. The brushes used in a DC generator a) ride against the commutator segments. b) are made from material softer than the commutator segments. c) are generally marked Al and A2 d) all of the above B. A magneto is a DC generator that uses for its pole pieces. a) electromagnets b) permanent magnets c) either "a" or "b" d) neither "a" nor "b"
The maximum amount of voltage is induced time(s) in 3600 of mechanical rotation for a single loop coil rotating between a north and south magnetic poles of a DC generator. a) one b) two c) four d) none of the above
An iron circuit with a small 0.75 mm air gap is shown in Figure 1. A 6000 turn coil carries a current I = 18 mA which sets up a flux within the iron and across the air gap. The cross section of the iron is a consistent 0.8 cm2, and the mean length of the flux path is 0.15 m. a) Redraw the magnetic circuit using schematic symbols of an electric circuit with reluctance in each part of the circuit. b) State's Ohm's Law for magnetic circuit. c) By neglecting the effect of fringing, calculate the reluctance of the circuit. d) Find the flux within the core. N = 6000 Iron circuit (4, = 800 for iron).
The length of a magnetic circuit in a moving iron instrument is 300mm. The coil around the soft-iron core has 360 turns and takes a current of 1.75 A. The core is square in section with sides of 20 mm. Takethe relative permeability of soft iron as 1100. Determine the flux density
If a loop is moving in a constant magnetic field then the voltage generated will be: Select one: V tr а. emf O b. Vemf c. Vemf
For the figure shown below if the current is moving clockwise around the coil. Which direction does the coil rotate? S O The whole coil moves down. The whole coil moves up. The right side goes down, and the left side goes up. The right side goes up, and the left side goes down.
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. The coil of a generator has an equivalent resistance of 1.5 ohms at 20 °C. After being used for several hours, the resistance is found to be 1.75 ohms. Determine the temperature of the coils at this time. The temperature coefficient of resistance at 0 °C of the coil is 0.004 OC-1.
7. A coil having a resistance of 20 ohms and an inductance of 0.75 henry is connected in series with a 30-ohm resistor and to a 120-volt d-c source. A switch across the series resistor is then closed, and the circuit is assumed to be in a steady-state condition. At the instant the switch is opened, what will be the rate of current change and the power delivered by the magnetic field.