4. The capillary rise when a glass capillary tube of diameter 0.4mm is dipped vertically in olive oil is 3.8mm. If the angle of contact of olive oil with glass is 0 deg and the density of olive oil is 920 kg/cu.m, find the surface tension of olive oil. 5. A liquid rises to a height of 9cm in a glass capillary of radius 0.02 cm. What will be the height of the liquid column in a similar glass capillary of radius 0.03 cm?

4. The capillary rise when a glass capillary tube of diameter 0.4mm is dipped vertically in olive oil is 3.8mm. If the angle of contact of olive oil with glass is 0 deg and the density of olive oil is 920 kg/cu.m, find the surface tension of olive oil. 5. A liquid rises to a height of 9cm in a glass capillary of radius 0.02 cm. What will be the height of the liquid column in a similar glass capillary of radius 0.03 cm?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m3.
Q3) when we put in the class tube have diameter 1.5 mm liquid with mass density900 kg/m3 , the liquid rise in the tube about 15 mm . Calculate the surface tension force?
9. The viscosity of an oil of sp. gr. 0.9 is measured by a capillary tube of diameter 50 mm. The difference of pressure head between two points 2 m apart is 0.5 m of water. The mass of oil collected in a measuring tank is 60 kg in 100 seconds. Find the viscosity of oil.
A mercury Manometer is attached to a pipe having suction pressure. The right limb is open to the atmosphere while the contact between mercury and water is in left limb at a distance of 30 cm from the center of the pipe. a. If the difference in the Level of mercury in the two limbs is 20 cm, What will be the pressure in the pipe. b. If the pressure in the pipe is increase to Pascal, What will be the new difference in mercury level?
As shown in Figure 1, an ideal gas flows isentropically from a large tank into a converging nozzle and exits to a receiver. The gauge pressure of the ideal gas in the large tank is 80 kPa. The nozzle exit area is 38 cm?. (Assume Pam = 101 kPa). a) Determine Mach Number at section 1, the EXIT mass flow rate and EXIT Mach mumber. b) Calculate the flow area at section 1. V: = 580 km/hr T:= 500 K Exit, A Large Tank P= 166 kPa (abs) Ideal Gas k=1.43 R= 0.2968 kJ/kg.k Vi = 480 kan/hr Figure 1
In figure 2.5, if the pressure of gas in bulb A is 50 cm Hg vacuum and Patm = 76 cm Hg, the height of column H is equal to (a) 26 cm (c) 76 cm Patm 144.444 Hg= (b) 50 cm (d) 126 cm arter
A 0.6 m square glass plate slides on a plane with a slope of 30° from the horizontal (Figure 1.2). Knowing that the plate weighs 30 N and that it acquires a constant speed of 5 cm/s, it is asked: determine the dynamic viscosity of the film 0.1 mm lubricant, which is between the plates. Assume the velocity diagram linear in the fluid film). (R: 0.0833 Ns/m2) 5cm/s Figure 1.2 0.1 mm
1. a) Find the mass of a tank of ethyl alcohol in units of kg if it weighs 3.6 kN and the specific weight in units of kN/m³ if the volume is 0.3m³. | b) A 3 mm diameter of straw is inserted into a pan of water at 30°C (y water at 30°C = 9.764 kN/m³, o = 0.0712 N/m). If the water in the straw rises to a height of 3.6 mm above the water surface in the pan, calculate the contact angle, 0. c) Determine the viscosity of the fluid between the shaft and brushing shown in Figure Qld if the shaft moves at 1.5m/s under a force of 70 N. The uniform radial gap between the brushing and shaft is 0.15 mm. 90 mm / diameter F-70 N 1.5 m/s 155 mm Figure Qld
A U-tube manometer is arranged, as shown in Fig. 2.15, to measure the pressure difference between two points A and B in a pipeline conveying water of density 1000 kg/m³. The density of the manometric liquid Q is 13600 kg/m³ and point B is 0.3 m higher than point A. Calculate the pressure difference when h = 0.7 m. T Manometric liquid Q of density Pman Figure 2.15 Measurement of pressure difference Fluid P, of density blup all to 20 lens
Q.11 A liquid compressed in a cylinder has a volume of 0.0113 m³ at 6.87 x 106 N/ 3 m² pressure. When the pressure is raised to 12.73 x 106 N/m² volume becomes 0.0112 3 m³ Keeping the temperature constant at 20 °C. The compressibility of liquid m²/N.
A closed cylindrical container contains 2.7m high of an unknown liquid and the air pressure at the surface is 16KP.. If the pressure at the bottom of the tank is 54KPA and the diameter of the container is 0.8 m, determine the mass of the liquid. A 1114.32 kg No answer among the choices 1947.08 kg D 1687.59 kg E) 1434.66 kg
A gas expands from 0.03 m3 to 0.05 m3 at constant pressure of 3.5 atm. Determine the work done.