4. Geologist also use binary phase diagram to show compositional change with temperature. These diagrams are described on pages 249-256 of MMS, and in your chemistry books. For the initial composition shown by an X, determine the original composition of the olivine (core) and the final composition of the solid - the rim. Use Fo/Fa percentages. Olivine Binary Phase Diagram Temperature C 1990 1800 1400 1400 1:200 Ma 。 Fo Olivine 20 X Liquid 40 Weight % Fa 40 1205 100 Fe Fa Substances with >1 component melt over a range of temperatures core rim

4. Geologist also use binary phase diagram to show compositional change with temperature. These diagrams are described on pages 249-256 of MMS, and in your chemistry books. For the initial composition shown by an X, determine the original composition of the olivine (core) and the final composition of the solid - the rim. Use Fo/Fa percentages. Olivine Binary Phase Diagram Temperature C 1990 1800 1400 1400 1:200 Ma 。 Fo Olivine 20 X Liquid 40 Weight % Fa 40 1205 100 Fe Fa Substances with >1 component melt over a range of temperatures core rim

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

You were tasked to separate the components of a mixture containing silica, sodium chloride and charcoal. TNāCI dissolves in water while silica and charcoal are not water-soluble. Only charcoal dissolves in carbon disulfide. a. Write a short experimental procedure to carry out the separation of the mixture. b. Given the following data, determine the percentage of charcoal, sodium chloride and silica. Mass (g) Mass of beaker 100.000 Mass of beaker + mixture 110.000 mass of evaporating dish 62.000 mass of evaporating dish + solid after evaporation of water 65.000 Mass of beaker + charcoal + silica after evaporation of excess water 117.000 mass of beaker + silica after decanting dissolved charcoal and drying 113.545
_refers to the formation of a new, insoluble product by a chemical reaction; this product then precipitates out of the reaction 51. solution as an amorphous solid containing many trapped impurities. * Sublimation Crystallization Recrystallization O other:
What is the equilibrium concentration of N₂ in water that is in contact with air at 25 °C and air pressure 1 atm? The mole fraction of N2₂ in the air is 80 %, and Henry's law constant for N₂ is 6 x 10-4 mol L-1 atm-1. Select the nearest value. O 4.8x 10-3 mg L-1 4.8 x 10-4 mmol L-1 0.6 x 10-4 mol L-1 6 x 10-3 g L-1 6 x 10-4 mol L-1
Useful gas properties and constants: • Molar mass (gm/mol): CO2 = 44, N2 = 28, O2 = 32, O = 16, N = 14, NO = 30. %3D Universal gas constant = 8.314 J/mol/K, Boltzmann constant = 1.38×10–23 J/K, Avogardo constant = 6.022 x1023 mol -1.
A 1.250 g sample of bauxite (the primary ore of aluminum) was analyzed for aluminum. The sample was powderized and treated in concentrated nitric acid. The nitric acid was removed and solids were treated in hot water with added nitric acid. Insoluble solids were removed by gravity filtration. The solution was made basic by the slow addition of dilute ammonia forming the gelatinous precipitate (Al(OH), and Al,O,.x H2O). The precipitate was heated to coagulate it then filtered over filter paper. The paper and solids were placed in a porcelain crucible and the paper was ashed while the precipitate was ignited at 600°C to convert the precipitate to pure Al,O,. The mass of Al,O, recovered was 0.2890 g. The average mass of ash after charring 10 sheets of the identical filter paper was 0.0007 g. Calculate the percent aluminum in the bauxite ore sample.
Use the change of state interactive to answer the question. Which of the statements describe limitations or safety concerns of this interactive? The interactive assumes substances change phase as temperature changes. The interactive assumes that the temperature of a solid can be easily measured using a temperature probe. Boiling points must be carefully determined for liquids that are flammable, such as benzene. The interactive assumes that the reaction is a closed system.
physical chemistry Roughly, what is the error introduced by the solution of some of the CO2 in the water in the bomb? The solubility of CO2 is about 0.0015 g/mL at 25°C and 1 atm CO2 pressure. The heat of solution of CO2 in a dilute aqueous solution is roughly -19.4 kJ/mol. Assume that the final CO2 pressure is 2 atm and that Henry's Law applies.
24 g of sodium hydride were added to 1 L.of water. The result solution reacted with 100 ml of water solution of nitric acid (HNO3) = 30 %, 0 = 1.18 g/ml). Calculate mass fractions of all compounds in the final solution.
9 sample g/mol) and CaO (56.08 g/mol) was analyzed for its Ba and Ca content. These oxides were first converted into its corresponding sulfides (BaSO4: 233.37 g/mol; CaSO4: 136.15 g/mol) yielding a precipitate weighing 3.758 g. Upon drying, 0.574 g was lost due to water evaporation. Calculate the amount (g) of Ba and Ca in the sample. **need answer ASAP and show full steps thanks!!
Saved Normal BIIIU fxl Ix Actual mass used in solution prep (g) Volume solution prepared Measured conductivity (uS/cm) Substance 0.1 g Naci 0.1003 100 mL 1149 0.1 g Nal 0.10 100 ml 419 Calculate the mass of Nal that would be necessary to yield the same conductivity as the NaCl solution. Clearly show these calculations in your lab notebook. Saved T BII U X X + fr Normal
Why is it best to cool a solution slowly as a solid crystallizes? impurities are more likely to crystallize as well when done quickly the solid obtained will have a higher purity when done quickly no solid will form when done quickly the solvent could start to boil again when done quickly
Il Connected to DESKTOP-VKHKVG3 "Hot ice" releases heat when the crystals form because A. the enthalpy of solution for solid sodium acetate is endothermic Disconnect C. the enthalpy of solution for solid sodium acetate is exothermic B. the precipitation of sodium ac crystals is exothermic D. A and B are true