4. For each of the situations in trie lapie welow, state the process bywhich heat is transferred.Getting burnt by touching a hot stoveHot air rising, cooling and fallingHeat from a campfire when you are seated beside itIce cooling down your handHeat from the Sun warming your faceBoiling water by thrusting a red-hot piece of iron into itA slice of bread placed undera red-hot electric grill to make toastHeating a tin can of water using a Bunsen burner

SITUATIONS PROCESS Getting burnt by touching a hot stove Conduction Hot air rising, cooling…

Answered: 4. For each of the situations in trie…

Engineering

Mechanical Engineering

4. For each of the situations in trie labie pelow, state the process by which heat is transferred.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.82P: Discuss the modes of heat transfer that determine the equilibrium temperature of the space shuttle...

See similar textbooks

Related questions

Q: | نقطتان )2( -- drink lot of water because l .am thirsty must have to

A: I have to drink a lot of water because I am thirsty here we need to use have to instead of must

Q: Let Pstel: 8000 Kg/m3

A: Solution :- Given data:- Thickness t = 3mm =0.003mDensity ,ρ =8000Kg/m3m1 = ρ.t1A1m1…

Q: 10 litres of water is heated from 15°C to 90°C how much heat is required?

A: Volume of water, V= 10 lit= 10*10-3 m3 Initial temperature, Ti= 15oC Final temperature, Tf = 90oC

Q: A- Four kg of water is placed in an enclosed volume of 1 m3. Heat is added until the temperature is…

A: Given data: ● The mass of the water: m = 4 kg ● The enclosed volume: V = 1 m3 ● The temperature of…

Q: An electric motor is used to drive the shaft of a small water pump. During a performance test, the…

Q: page), are bon. force of P = 2,8 e left. Determit ce applied to ea wa FBD of the a only exert horiz

Q: A. Four kg of water is placed in an enclosed volume of 800 L and heat is added until the temperature…

A: The specific volume of the mixture is

Q: www 3k m k 2m a) Determine DoF 6) Obtain governing equations.( hari tntal plone)

Q: a mass of 890 kg, calculate th

A: (i) 2916.5 N for every front wheel. (ii) 1449 N for each rear wheel.

Q: A lifting platform is to lift a load of 20KN and is to have a system pressure of 10 bar. How large…

Q: A spring, whose unstretched length is 3 ft, stretches to a length of 8 ft when a force of 10 lb is…

Q: In a lever, the load arm is always the part from the __ to the fulcrum. A. Force B. Mass C. Load

A: In a lever, the load arm is always the part from the __ to the fulcrum. A. Force B. Mass C. Load

Q: When the summation of internal forces is zero?

A: When all the external forces acting on a rigid body tend to cancel out each other, the summation of…

Q: The force in cables AD and AC is one-half that of cable AB. The flower container weighs 268…

A: Consider the diagram shown below for the top view. According to the given condition in the force…

Q: wo cables tied together at Care loaded as shown. Given: Q = 160 lb. A 30 3 |C Q

Q: Boil the kettle at your home. Determine the following c) Change of internal energy of water?

A: Given Boil the kettle at your home To find Internal energy of water

Q: 1. An iron casting of mass 10 kg has an original temperature of 200°C. If the casting loses heat to…

A: We have given the problem

Q: Calculate: Work net (kW), heat addition (kW), and thermal efficiency.

Q: A ballast-type accumulator with a 3,000-in. capacity is heated from 70°F to 225°F. What will be the…

Q: Determine the heat in kilojoules per kilogram required to turn 30°C Water into ice at -15°C.

Q: 2) a 1550-kg car moving at a constant speed of (900 km/hr) Its takes (16,000W)to keep it on alevel…

Q: f the steem is 100g and the liquid is 12 g. Find the quality of steam?

A: Given Data : Mass of steam(m)=100 gm Mass of liquid(M)=12 gm

Q: Calculate the energy transferred by the heater to i the iron block by 5 °C.

A: Calculate the energy transferred by the heater

Q: An electric motor is used to drive the shaft of a small water pump. During a performance test, the…

A: Given data, Torque T= 5.014 N.m Power P= 638.52 W Need to calculate N

Q: Find heat transfer between the plates in kW/m2

A: Given data; Two large parralel plates having a gap=10 mm T1=1000K T2=400K ε1=0.5 ε2=0.25…

Q: car batteries are rated in ampere-hours . to what physical quantity do ampere-hours coresspond…

A: Since the car batteries are rated in ampere-hours, it corresponds to the total charge of the…

Q: 2. What is the relationship between volume and pressure?

A: For a fixed mass of an ideal gas kept at a fixed temperature, pressure and volume are inversely…

Q: If 10 lbs of water evaporated at atmospheric pressure until a volume of 288.5ft is occupied, how…

A: m=10 lbs unit conversion 1 lbs =.4535 kgSo 10 lbs=10 ×.4535=4.535 kgPatm=101.325 kPa and atomsphere…

Q: Find :1) Nth 2)Net work per kg

Q: A 100 kN block slides down a plane inclined at an angle of 30° with the horizontal. Neglecting…

A: Given data as per question Mass of the block =100 kg Inclination angle =300

Q: *.He enjoys a bath in the evening have O having O to have O

A: He enjoys having a bath in the evening.

Q: Two forces are applied to an object, 2s shown below. In order to keep the object in a state of…

A: The resultant of the given two forces will lie in first quadrant. Therefore to balance these forces…

Q: Q2: Using a cable with a tension of 1350 N, a tow truck pulls a car 5.00 km along a horizontal…

A: Given data Tension in cable (T) = 1350N Distance (d) = 5 km = 5000m

Q: , what is the specific internal energy if the pressure is doubled while the temperature stays the…

A: Given, at certain pressure and temperature, internal energy u=375KJ/kg If pressure is increased…

Q: Explain the forms of energy.

A: Energy exists in different forms such as 1. Electrical Energy 2. Kinetic Energy 3. Potential Energy…

Q: A force of 30 lb is applied to a piston of radius 8 in. of a hydraulic press. The large piston has a…

Q: (d) 10 litres of water is heated from 15°C to 90°C how much heat is required?

A: For water : Specific heat (C) = 4.18 kJ/kg-K Density = 1000 kg/m3 Given : Volume = 10 litre =…

Q: difference between pressure force and body force?

A: Solution:

Q: An inclined plane has a mechanical advantage of 3. If a 79 N force is needed to slide an object up…

A: It is asked to find the mass of the object which needs to be pushed over a slope with a mechanical…

Q: 3 cm Az To 7 cm a̟= 4 m/s?

Q: 4. From #3, the ship was 1000 kgm when it left earth. How much does it weigh in N and kgf if it…

A: Note: the mass of the ship cannot be in kgm, it must be in kg. Take the mass of the ship as 1000 kg.…

Q: sec 2. Tower water, in kg sec MAT DICNANER DESEL %3D

A: Solution :- GIven data :- 507hp = 507×746 WP = 378222 WJacket water in = 60οCJacket water out =…

Q: D°C DBT. The sensible heat of spac the space, calculate : a- mass of d

Q: piston, on which rests a weight. . A gas is confined in a 1.25(ft) diameter cylinder by a The mass…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

4. For each of the situations in trie lapie welow, state the process by
which heat is transferred.
Getting burnt by touching a hot stove
Hot air rising, cooling and falling
Heat from a campfire when you are seated beside it
Ice cooling down your hand
Heat from the Sun warming your face
Boiling water by thrusting a red-hot piece of iron into it
A slice of bread placed undera red-hot electric grill to make toast
Heating a tin can of water using a Bunsen burner

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3) On a hot summer day, a student turns his fan on when he leaves his room at 9.00 am. When he returns at 1.00 pm, will his room be warmer or cooler than the neighboring rooms? Why? Assume all the doors and windows are kept closed.
Latent heat of fusion is the heat given up as a substance freezes. The latentheat of fusion for water is 144 British thermal units per pound (Btu/lb). Thismeans that 144 Btu are given up for each pound of water that freezes. Howmany British thermal units of heat are given up when 4,000 pounds of waterfreeze?
To demonstrate thermal expansion/contraction we saw a video clip with a sphere and ring (like the ones pictured here). The ring was dipped in liquid nitrogen, and then the sphere would no longer fit through it. What could now be done to the sphere so that it would fit through the ring again? O Dip the sphere in liquid nitrogen. O Use a blowtorch to heat the sphere up. O Nothing can be done to the sphere, only the the ring can be altered. O Put oil on the sphere to make it slippery.
K). average NUSseit Number. 2. A slab of iron with temperature, T1=48 deg C is used to heat a flat glass plate that has an initial temperature of Tg1=18 deg C. Assuming no heat is lost to the environment, and the masses are m;=0.49 kg for the slab and mg=310g for the plate, what is the amount of heat transferred when the two have reached equal temperature? Assume C;=0.11 kcal/kg-deg C for iron and cg=0.20 kcal/kg-deg C for glass.
(b) After graduation, you decided to work overseas to experience living in a country with four seasons. Your neighbour, knowing that you are an engineer asked your help to install a heat pump system for his house. He wanted to always maintain the temperature in his house at 24°C during winter. In that area during winters, average outside temperature is -3°C. He also has an underground water well with average water temperature of 10°C during winter. You estimated that the heat losses from the house under the average outside temperature to be 75000 kJh. Investigate the most economical mean to power the heat pump (by calculating the minimum power required) if you can choose to extract heat from either: i. The outside air at average temperature of -3°c ii. The well water at 10°C State the reasoning for your calculations.
b) For an Otto Engine the temperature at the end of combustion is 280 K. If the temperature in the gas side and coolant side of the wall are 177 °C and 127 °C and cylinder wall thickness is 5 mm;
Pls.answer thank you! A classroom that normally contains 40 people is to be air-conditioned with window air-conditioning units of 5 KW cooling capacity. A person at rest may be assumed to dissipate heat at a rate of about 360 KJ/hr. There are 10 light bulbs in the room, each with a rating of 100 watts. The rate of heat transfer to the classroom through the walls and the windows is estimated to be 15,000 KJ/hr. If the room air is to be maintained at a constant temperature of 21°C, determine the number of window air-conditioning units required.
4. When 435 J of heat is added to 3.4 g of olive oil at 21 C, the temperature increases to 85 C. What is the specific Heat of the olive oil?
c) A cooking pan is made of aluminium of mass 2kg and a specific heat capacity of 0.95KJ/kgK. The pan is filled with 6kg of water of density 1000kg/m and heat capacity of 4.2kJ/kgK. If the pan and water are at room temperature of 20°C, how much energy is required to raise the temperature to the boiling point of water.
Question 4: A person informs an engineer that he frequently feels cooler in the summer when standing in front of an open refrigerator. The engineer tells him that he is only “imagining things” because there is no fan in the refrigerator to blow the cool air over him. A lively argument ensues. Whose side of the argument do you take? Why?
Describe heat transfer by conduction.
Draw the thermal circuit for heat transfer through a double-glazed or a double-paned window. Identify each of the circuit elements. Include solar radiation to the window and interior space.