4. a) A communications link between two towns 38km apart is required to operate at a bit rate of 295Mbit/s. The chosen system uses single mode 1300nm fibre with a dispersion coefficient of 4ps/km.nm. What is the maximum allowed linewidth of the source assuming that the maximum allowed pulse spread is 0.25T. b) The attenuation coefficient of the fibre in the above link is 0.42dB/km and the receiver sensitivity is -35dBm. What is the minimum acceptable transmitter power in mW assuming a 12dB reduction in the power budget for joints, margin and penalties.

4. a) A communications link between two towns 38km apart is required to operate at a bit rate of 295Mbit/s. The chosen system uses single mode 1300nm fibre with a dispersion coefficient of 4ps/km.nm. What is the maximum allowed linewidth of the source assuming that the maximum allowed pulse spread is 0.25T. b) The attenuation coefficient of the fibre in the above link is 0.42dB/km and the receiver sensitivity is -35dBm. What is the minimum acceptable transmitter power in mW assuming a 12dB reduction in the power budget for joints, margin and penalties.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

. Suppose two hosts A and B, are separated by 10,000 kilometers and are connected by a directlink of R = 1 Mbps. Suppose the propagation speed over the link is 2.5 x 108 meters/sec.a. Calculate the "bandwidth-delay product", R.tprop.b. Consider sending a file of 400,000 bits from host A to B. Suppose the file is sent continuouslyas one big message. What is the maximum number of bits that will be in the link at any giventime?c. Provide an interpretation of the bandwidth-delay product.d. What is the width (in meters) of bit in the link? Is it longer than a football field?e. Derive a general expression for the width of a bit in terms of the propagation speed s, thebandwidth R, and the length of the link d
Please solve the question and explain fully. Thanks.
When a mobile node moves farther away from a base station, a base station may take a number of precautions to ensure that the likelihood of losing a transmitted frame does not rise. What are two of these precautions?
An optical Fibre System is to be installed between two towns that are 74 Kms apart. If the fibre has a maximum allowed dispersion of 0.15nsecs/km, what is the maximum NRZ signal rate that can be transmitted to keep the dispersion within the required limits.
For a transmission medium, SNRdb is given as 30. If bandwith is selected as 9,06 MHz, which answer is correct? O a. Bit = 3 Max Capacity = 92,20 Mbps O b. Bit = 4 Max Capacity = 90,70 Mbps O c. Bit = 2 Max Capacity = 81,60 Mbps O d. Bit = 8 Max Capacity = 99,80 Mbps O e. Bit = 5 Max Capacity = 90,60 Mbps
4. How much is the percentage increase in bandwidth efficiency if a broadcast system shifts from 8 QAM to 16 QAM for the same level of bit rate?
An alternativeapproach that is similar to ADSL; uses coaxial, fiber-optic or twistedpair cable for short distances (300 to1800 meters) a. Very High Bit Rate DSLb. High Bit Rate DSLc. RADSLd. SDSL
Higher bit rates can be achieved over voice grade line by employing M-ary modulation schemes TRUE FALSE
For a transmission medium, SNRdb is given as 12. If bandwith is selected as 5,62 MHz, which answer is correct? a. Bit = 2 Max Capacity = 22,48 Mbps b. Bit = 8 Max Capacity = 23,50 Mbps c. Bit = 2 Max Capacity = 27,90 Mbps d. Bit = 8 Max Capacity = 17,00 Mbps e. Bit = 5 Max Capacity = 23,10 Mbps
- The plot of the obtained VSWR for the short circuit load, and compare the obtained speed of em wave in the cable with that of the speed of light. - The obtained value of the load.