4) Write the equilibrium equations 5) Solve for the unknown exterior reactions. Hinge 16 ft 3.45 k/ft B 16 ft- PC -16 ft- 7.5 k D 45 k-ft

Q: Determine the reactions at the supports for the beam shown. Show free body diagram and solutions.

A:

Q: Problem 2: Determine the reactions of the structure shown below. 15 kips B w = 4 kips/ft /C hinge…

A: A compuond frame with both ends pinned and a hinge at point C.To find: Support reactions at point A…

Q: Determine the reactions at A and B for the steel bar and loading shown, assuming a close fit at both…

A: Given data:- Conditions given-Remove restriction at A and solve for the reactions Below bar figure…

Q: From the truss shown, determine the reaction at roller support.

A:

Q: Problem 1. The wooden beam is supported by a pin at A and the two-force strut BC. Draw a complete…

A:

Q: Determine the reactions. w = (4 +2F) lb/ft |8.90 lb/ft 4 Ib/ft 6 ft

A:

Q: Determine the components of the reactions at A if a 750-N force directed vertically downward is…

A:

Q: Question 2 Determine the external reactions for the cantilever beam which is subjected to two point…

A:

Q: find the reaction forces

A: Given Data  Determine the support reaction.

Q: Determine the reactions at the supports. 3m m 800 N/m 3 m-

A: Given data:-

Q: Determine the reactions at the supports for the beam shown. Show handwritten free body diagram and…

A: Solution:

Q: Find the reactions at A and B

A: Step 1: Step 2:

Q: Determine the horizontal and vertical components of reaction at the supports A and B. 20kN/m

A:

Q: For a = 1.5m, determine the reactions at pin A and roller B. 1800 N/m A 4 m Solution: • There are…

A:

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.