(4) Three concrete specimens with the size of 200x200x200mm³ were prepared for compressive test. After 28 days of standard curing, the peak compressive loads are 1233kN, 1199 kN and 1010 kN, respectively. Please evaluate the strength grade of this concrete. Strength grade

Q: List several locations where flashing is required?

A: flashing  - flashing use as a obstacle for water penetration. it is thin impervious layer on the…

Q: Design Calculation of stair climbing trolly

A: In day today life we may have to carry so many goods and objects of various quantities through…

Q: Select appropriate air heating and cooling systems?

A: Selection of Air Heating and Cooling System:  There are six factors to select the appropriate air…

Q: what is piping system?

A:

Q: Why is drainage clogging occur?

A: 1)Damaged Pipes-Another major cause of blocked drains is broken pipes. For water to flow freely, it…

Q: How to do a evacuation Floor plan like an example

A: An evacutation plan is one of the most common and important plannings in any project. They are…

Q: Please provide detailed information about the usage classes of the buildings and the regulations…

A: Introduction : The National Fire Protection Agency (NFPA) has a list of fire safety laws that must…

Q: Illustrate a simple drawing plan of pipeline

A: Simple drawing plan of pipeline: The piping plan or general arrangement drawings show all major…

Q: Define Air-handling equipment.

A: Air-handling equipment is defined as the equipment that is used to regulate the temperature of the…

Q: Draw a schematic and block diagram of a flush toilet.

A: Environmental engineering : Environmental engineers explore answers to environmental problems that…

Q: Define electrical profiling method.

A: The electrical profiling method is defined as it is a DC resistivity survey which proposes to trace…

Q: What escalator installation configurations are generally used?

A: Answer Introduction An escalator is a device that is used for transporting people from one floor to…

Q: What are canopy restrictions?

A: Canopy:

Q: Flowchart of how to estimate EARTHQUAKE LOADS. Please write it down, don't use the book nscp.…

A: Analysis of past earthquakes aids in understanding their causes and mechanisms and may even aid in…

Q: Identify each of the letter designations used on metal fire doors?

A: The alphabetical letter designations used on metal fire doors are classified as class A, class B,…

Q: How does a plumbing contractor know what slope is required on sanitary piping installations?

A: The slope changes as the temperature changes in a sanitary installation.

Q: How are concrete water tanks insulated

A: Insulation of concrete tank is required because loss of moisture can occur as a result of the…

Q: y thermal bridging? thank you if you will answ

A: A thermal bridge, also known as a cold bridge, is a section of a building with much higher heat…

Q: How can a designer find the fire-spread and smoke-production data for various finish flooring…

A: Designer works under the direction of a project manager to prepare civil engineering plans and…

Q: What are flame-spread classifications?

A: Flame - spread: Flame spread is essentially a material's surface burning trait, and a flame-spread…

Q: Q/What are the methods of plumbing with a mention of the reasons for each of these methods?

A:

Q: A restroom should be located within 400 feet of every permanent workstation

A: Maximum distance is 400 feets ... Maximum of above or below 1 floor in case of building..

Q: xplain how the stormwater drainage system works and the process how the rainwater is collected from…

A: Stormwater: Stormwater is obtained from the rains or cyclones In which the water Is collected at…

Q: A building has an area of 16656 ft2. What is the minimum number of roof drains required?

A: The area of the building = 16656 ft2 We need to calculate the minimum number of drains required.

Q: " SANITARY PLANNING LAYOUT " A.   FLOOR PLAN - ONE -STOREY RESIDENTIAL BUILDING B.   PLUMBING…

A: A building's or structure's layout depicts the design of its foundation on the ground surface, as…

Q: Which dimensions should be taken into account while designing a cyclone seperator?

A: The dimensions or parameters should be taken into account while designing a cyclone separator are…

Q: Understand installation procedures for carpeting?

A:

Q: quality management plan of Lrt eglinton midtown crossover construction project. 500 words

A: here is your answer below ;

Q: Describe in detail a typical layout of an escalator systems

A:

Q: Please solve both question and detail solution and not Copypaste otherwise down vote

A: True  Hvac System design must be prepared by a licensed professional engineer beacause they used…

Q: hat is volume anaylsis system?

A: Civil engineering is mainly concerned with the planning and detailing of the structure. So for the…

Q: Describe with characteristics details for one of the plumbing devices in buildings

A: The various sanitary fittings provided in buildings, such as wash basins, bath tubs or bathrooms,…

Q: Describe about the drainage filter.

A: The drainage filter can be defined as it is made up of granular material either natural or processed…

Q: give detailed information about generalised compressibility chart.

A: It has been asked in the question to give detailed information about generalized compressibility…