(4) The A-36-steel band, made up of two halves, is 50 mm wide and is secured around the smooth rigid cylinder. If the bolts are tightened so that the tension in them is 2 kN, determine the normal stress in the band, the pressure exerted on the cylinder, and the amount of stretch that occurs in each half the band. 5 mm 200 mm

Q: Determine the minimum diameter of the bolt if the maximum shear stress is equal to 10 ksi. The value…

A: dmin = 12/16in final answeri have attached the photo of step by step solutionExplanation:Step 1:…

Q: The member is connected to a gusset plate with 10 inch longitudinal welds. Fin el shape to carry the…

A:

Q: An aluminum alloy [E = 10,000 ksi; Oy= 40 ksi] pipe (1) is connected to a bronze [E = 16,000 ksi; Oy…

A:

Q: 2. The structure is used to support a distributed load of w = 5 kN/m. The bolts at A, B, and C each…

A:

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A: Force = 22.3 kN or 22300 NDiameter of shank, d = 12 mm Thickness (t) = 8mm

Q: An aluminum alloy [E = 10,000 ksi; σy = 40 ksi] pipe (1) is connected to a bronze [E = 16,000 ksi;…

A:

Q: 1-66 Figure P1-69 shows a bolt subjected to a tensile load. One failure mode would be, if the…

A:

Q: area of the triangle s

A: A triangle is a 3 sided geometric figure . Area of the triangle with three different sides is given…

Q: s to be made of steel having an ultimate shearing stress of 400 MPa, determine: (a.)The diameter of…

A:

Q: An aluminum alloy [E = 10,000 ksi; σY = 40 ksi] pipe (1) is connected to a bronze [E = 16,000 ksi;…

A:

Q: Evercise:- A cylindrical rod 100 mm diameter of 12 mm long with is subjected to a 30000 N. Assuming…

A: Given,Initial length of the rod, say L = 100 mmInitial diameter of the rod, say D = 12 mmTensile…

Q: Problem 4.81 The 60-mm-diameter cylinder is made from Am 1004- T61 magnesium and is placed in the…

A: Given : Dia of cylinder = 60 mm   Determine the force in the cylinder when the temperature is 130o…

Q: e single shear connection consists of six 26-mm-diame Its. If the ultimage strength of the bolts is…

A: Number of bolt (n)=6 d=26mm P=570kN

Types and properties of steel

Steel is an alloy of iron. It is formed by heating iron and combining carbon (0.1-1.7%) with it and minor amounts of other elements such sulfur,  chromium, manganese, nickel, etc. Thousands of steel grades have been published, registered, or regulated around the world, each with its chemical composition, and special numbering systems have been devised in various countries to classify the vast number of alloys.