4) A simply supported beam supports the uniformly distributed load of intensity Wo. Determine the safe allowable value of w, if the flexural stress is limited to 160 MPa in tension, 200 MPa in compression, shear stress is limited to 70 MPa and maximum allowable deflection is 15mm. The modulus of elasticity of the beam is 200 GPa. Use Moment Area Method.

4) A simply supported beam supports the uniformly distributed load of intensity Wo. Determine the safe allowable value of w, if the flexural stress is limited to 160 MPa in tension, 200 MPa in compression, shear stress is limited to 70 MPa and maximum allowable deflection is 15mm. The modulus of elasticity of the beam is 200 GPa. Use Moment Area Method.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

PLEASE PROVIDE COMPLETE SOLUTION THANKS
The beam shown is made of a nylon for which the allowable stress is 24MPa in tension and 31MPa in compression. Determine the largest couple M that can be applied to the beam. 24 mm 60 mm 30 mm 80 mm
A simply supported beam carries a concentrated load at the center which fluctuates from a value of W to 4 W. The span of the beam is 470 mm and its cross-section is circular with a diameter of 57 mm. Take ultimate stress of beam material as 683 MPa, Yield stress as 0.55 times ultimate stress and the endurance strength as 0.45 times the value of ultimate stress and take a factor of safety of 1.5. Calculate the maximum value of "W", if the variable stress induced in the beam is 109 N/mm?. Using Goodman relation calculate the value of mean stress in N/mm?. **Note: Please upload your handwritten working/solution to the link provided. Maximum Bending Moment Minimum Bending Moment Mean Bending Moment Variable Bending Moment Section Modulus, Z mm3 The value of Load "W". in N The value of Mean stress using Goodman relation ..
Shea Where G is the shear modulus and can be writte ratio that is: 9 = Elateral %3D - Eaxlal
A flat steel bar, 26 mm wide by 2 mm thick and 1.8 m long, is bent by couples applied at the ends so that the midpoint deflection is 27 mm. Compute the maximum stress in the bar. Use E =220 GPa. Answer must be in MPa.
Please solve the problem in the question, Make sure you show all of your work please
The rigid beam shown has a cross sectional area of DB = 800 mm and defleetion at C- 20 mm due to the load P. Determine the normal strain in DB? 1250 Ridlen 100
Higdon
Q2: The simply supported beam shown as Figure 5. below is subjected to Loading as shown on the Figure. Using integration method. Find the maximum Lenght (L) so that the max. deflection is not greater than 30mm for the Beam.. The flexural rigidity (El) of Beam section El = 50*10% KN.m? “4m e | Sm