4 - A rectangular block is loaded with a 180 kN axial force and a moment M, as shown in the figure. If the maximum allowable tensile stress is 50 MPa, what is the allowable magnitude of the moment? 60mm 100mm 국 Cross-section 180KN M elevation view -X

Q: 4 - A rectangular block is loaded with a 180 kN axial force and a moment M, as shown in the figure.…

A: Given data:-  Axial force =180 kN the maximum allowable tensile stress = 50 MPa To find:- the…

Q: What is the force in member DF? C. (include units with answer) What is the force in member CD? D.…

A:

Q: For the element shown in the figure, replace the distributed load with the equivalent nodal forces.…

A: To replace the distributed load with equivalent nodal forces, we need to calculate the forces at…

Q: Need help with all 4 questions please include all units and steps. Thanks

A: Step 1: Step 2: Step 3: solution is given above Step 4:

Q: Determine the internal forces at point J for the structure shown, where member BD can only carry…

A:

Q: Consider the bracket shown in Fig-3. If: • F1 = 10 lb @ -90° • a - 2 ft • b = 4 ft C = 1 ft then,…

A:

Q: The round bar in the figure is made of steel (E-207 GPa). The load F has a magnitude of 100 N. You…

A: Young modulus of the material,(E)=207 GPa. Applied force (F)=100 N. Diameter of the shaft,(d)=20 mm.…

Q: 18 kN A AZ 2 m 4 m B

A:

Q: Set P₁ = 7 kN, P₂ = 8 kN . (Figure 1) Figure 4m B E 4m 4 m 6 m D

A:

Q: A two-story building has steel columns AB in the first floor and BC in the second floor, as shown in…

A: Given data:- A two-story building P1=400 KN P2=720 KN L=3.75 m To find:- Internal axial force axial…

Q: hy is the external load not shown in the free body diagram of limk 2 and 4?

A: To find:The forces in each element.FBD:The free-body diagram is shown below.

Q: . From the system shown in the figure, obtain the forces and the average axial stres on each bar AB,…

A:

Q: M C a In the figure above, g = 3, f = 7, d = 7.616, a = 5.2m, b 3 2.2m, с — 1.2т and @ — 28° A…

A:

Q: In the figure below, a member is subjected to an axial force P. If the cross sectional area of the…

A: Answer: when any axial load will act on a member then shear stress will be maximum at an angle of 45…

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.