3k/ft В 10 k Inc = 800 in.4 10 ft Ln = 600 in. Icp = 600 in. A D 10 ft Prob. 10–19

Q: 2 kN 5 m

A: Given Data :

Q: Determine the reaction at the roller support at point B in kN unit. Take P = 5.6 kN. P kN B 30° 6 m-…

A:

Q: loh: proced ● Determine reactions at A and C A 2 m MB 1m -C Rc

A:

Q: 6) Find the horizontal and vertical components of the reactions at points A and D. 2m D -1.5 m B 1.5…

A: Given

Q: 200 N 200 N 200 N 30 1m 1m -1 m 400 N 3 m 60

A:

Q: Determine the reactions at the fixed support A and the roller B. EI is constant.

A:

Q: A beam supports a distributed load as shown. Determine the reactions at the supports. 200 lb/ft 6…

A: This is the very basic question of strength of material portion. Topic:-Reaction calculation of…

Q: Determine the reactions at the supports A and B. EI is constant.

A: Given data: The uniformly varying load on the beam is w0. The length of the beam is L.   The free…

Q: Determine the reactions at roller support A and fixed support B.

A: from the equilibrium equation:

Q: Solve for all reactions at A and B

A: The free-body diagram of the given truss system can be drawn as below, Here, RB is the normal…

Q: Determine the reaction at A on the beam. Let wo = 97 kN/m, L= 3 m.

A:

Q: Determine the four support reactions. El is constant L-4 m, q=5 kN/m A q L B

A: Given question is from Basic mechanics. We have to find support  reation. Stepwise solution is…

Q: Determine the components of the reactions at A and B if a 62-lb load

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.