36 22 32 20 Capt. Kittinger, USAF 1961 31.3 km (102,800 ft) Air pressure = 0.6 mb Pressure exerted by the atmosphere 18 28 16 24 14 20 12 Air pressure at top of Mt. Everest (29,035 ft) is 314 mb 16 10 1013 mb 50% of atmosphere lies below this altitude 12 or 14.7 Ibs/n? 6 4 2 200 400 600 800 1000 Pressure (mb) Atmospheric pressure is simply the weight of the air above. Allitude (km) || | || 8. Alttude (miles)

Q: ording to Figure (1) below, the pressure at point 2 is..... the pr t1 2 Equal to 50 m 150 m

A: Ans: greater than

Q: If a tire pressure gauge reads 32 psi and the ambient pressure is 12 psi, what is the absolute…

A:

Q: Calculate the approximate specific weight of the object.

A: The weight of the object in air Wair=75 lbs The weight of the object when immersed in water…

Q: Eleven liters of SAE 30 oil weighs 92 N. Calculate the oil's a. Specific weight b. Density Specific…

A:

Q: For the given beam with shown loading, determine the reaction at the ro. support. 20 kips/ft B A

A: Given     Load, P = 20 kips/ft  Length, L = 8 ft Find   Reaction at roller support, R2

Q: * Water enters the condenser at 20°C and leaves at 35°C. What is the LMTD if the condenser…

A:

Q: 4. A barometer (see Figure 2) is used to measure atmospheric pressure and is filled with a high-…

A: Consider the following data. Range of pressures,  Acceleration due to gravity,  Density of mercury,…

Q: The angular velocity of link AB is 3 rad/s. At the instance, the angle is O-7, determine the…

A:

Q: 6) Use the 3 relations (equations) below to relate T(°F) to T(°C). Then, find out, at what…

A: Given equations , TR°=1.87 TK -1                           TC°=TK-273.15-2…

Q: what will be the absolute pressure in SI unit

A: Atmosperic pressure is

Q: Convert each temperature. 22 °C to K (approximate room temperature)

A: Given, temperature = 22oC we know 1oC = 273 K

Q: What is the pressure at 61, 500 ft in SI.

A:

Q: The fluid pressure is the same in all directions. This is known as a.Archimedes' Principle b.Ideal…

A: As per honoue code we will answer the first question .  For the other parts please submit a new…

Q: Given the following state of stress where ox = 50 MPa, 0y = 0 MPa, txy = %3D -25 MPa, (i) draw…

A:

Q: Each statement below has a word written in ALL CAPS. If the statement is true, write T in the blank…

A: 1).F, MASS 2).F, CONSTANT 3).F, WEIGHT OF VOLUME DISPLACED 4).T,

Q: waten tunnle

A: given water tunnel  as shown below

Q: FA =1N F8 = 3 N TABULATION Table 1.Reactions of a rigid body Dynamometer Reading (N) Computed…

A:

Q: The gauge pressure of a pneumatic cylinder reads 40 lb/in.2 when the volume is 30 in.3. The cylinder…

A: GivenP1=40  lb/in2 guageV1=30 in3P2=60 lb/in2  guage

Q: 1) We want to measure the density Q2 of the fluid in the tank depicted in the figure by attaching a…

A:

Q: y-coordinates of tne centrolId of the shaded area. y R d0 R R, 0 3 ỹ = R sin 0 do

A:

Q: air-standard Compression Ignition cycle has a compression ratio of 18.2. Air is at 3200°R at the of…

A:

Q: Complete the following table for specific volume of water pressure specific volume (m³/kg) (bar) 80…

A: Specific volume of water is defined as the volume of the water per unit mass. It is expressed in the…

Q: 5.24 The 14.5-lb chain saw is subjected to the loads at A by the log it cuts. Determine the…

A:

Q: The right side leg of the pictured manometer is open to the atmosphere with a pressure of 1 atm. The…

A: The pressure in the left hand lag is 106.9kPaExplanation:Explanation

Q: How do I calculate the specific gravity of water?

A: To find : specific gravity of water

Q: water 0.125m glycerine P2 1.0 m 0.5 m mercury

A: Find the pressure difference .

Q: What is the purpose of starting with the temperature if the water lower than room temperature and…

A: When you add energy to a group of atoms, they usually travel faster and get hotter. Similarly,…

Q: Construct a plot showing the sequence of events on an oil viscosity vs. pressure for the given…

A: Consistency estimations for live supply oils require a multistep cycle including separate…

Q: We have the following state space model: *1 = 4x1 – 16x2 + 10u1Uz *2 = 3x3 – 9uz y = 5x1u2 + 3x2u1…

A:

Q: The dynamic coefficient of viscosity m (viscosity of a fluid) is from, where v= velocity, d =…

A: Given data The dynamic coefficient of viscosity m (viscosity of a fluid) is from, where v= velocity,…

Q: When & where will the ball be at the sam height from the ground Given;

A: GivenVo1=50ft/sVo2=75 ft/sh=100 ft

Q: Give 10 basic question about conversion in pressure units. A sentence form

A:

Q: Suppose the pressure in a car tire is specified as 3 bar, what will be the absolute pressure in SI…

A: Given,absolute pressure inside a car tyre = 3 barto find - absolute pressure in KPa

Q: Convert each temperature. 77 K to °F (temperature of liquid nitrogen)

A: Given: The temperature of the liquid nitrogen is T1=77 K.

Q: If the specific gravity of the unknown fluid is 13.92, what is its specific weight in lbf/ft^3?…

A: Given data Specific gravity = 13.92

Q: In the Figure shown, find the Pressure difference between A and B. Given: Specific Gravity of Oil,…

A:

Q: A syringe (X), forces air, at a high velocity, over a straw (Y). The air in the water chamber (Z) is…

A: Solution is attached below

Q: PART A Using the graph to the right, what would Air Pressure be (mb) at an altitude of 10 km? What…

A: Given:The graph of altitude Vs pressure.The  axis of the graph is pressure and  axis of the graph is…

Q: Which of the following statements is right? O a The kinematic viscosity is not a fluid property Ob…

A: Option d is correct.

Q: at is the conversion for the displacement volume of of an automobile in^3 to liters?

A: Conversion for the displacement volume from in3 to L.

Q: Given that p = fluid density, V = fluid velocity, L = characteristic length, and p = dynamic…

A: Given Data :* Fluid denity = f* Fluid velocity = V* Characteristic Length = L* Dynamic viscosity =…

Q: Suppose you are given data in SI units (mass in kg and length i  meters)and because there is such a…

A: The formula for pressure drop in a pipe is: ΔP = (f×L×ρ×v2)/(2×D) where: ΔP is the pressure drop (in…

Q: Fill the table with the correct data and signs (+) (-) please.

A: