33. A conductor of length 15 cm is moved at 750 mm/s at right angles to a uniform flux density of 1,2 T. Determine the emf induced in the conductor. A.0.135 V B. 0.327 V C. 0.525 V D. 0,707 V 34. In the preceding problem, calculate the change of flux linked with the other coil if it is wound with 400 turns.

33. A conductor of length 15 cm is moved at 750 mm/s at right angles to a uniform flux density of 1,2 T. Determine the emf induced in the conductor. A.0.135 V B. 0.327 V C. 0.525 V D. 0,707 V 34. In the preceding problem, calculate the change of flux linked with the other coil if it is wound with 400 turns.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Tubular strip lights is an best example for |type lamp.
Which of the following is not an approved grounding method?A)Metallic underground water pipingB)Ground rodsC)Gas pipingD)Metal frame of a building
Please answer ASAP for like this please Asap for like this please... Please
Refer to the National Electrical Code® or the working drawings when necessary. Where applicable, responses should be written in complete sentences. For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft x 18 ft (~3.7 m x ~5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0. 1. The maximum distance that the luminaires can be separated and achieve uniform illuminance is ft ( m). For problems 2-5, two luminaires, 8 ft (2.5 m) and 4 ft (1.2 m) in length with dimensions as shown in Figure 15-7, are to be installed in tandem (end to end). The end of the long luminaire is to be 2 ft (600 mm) from the wall. 2. The center of the outlet box should be roughed in at ft ( m) from the wall. 3. The first support should be installed at the wall. ft ( m) from 4. The second support should be installed at from the wall. ft ( m) 5. The final support should be installed at the wall. ft…
wiring/ connection diagram of fire alarm system by adruino. and dicuss it
b) State six (6) examples of electrical hazard sources that can be found in home or office.
@26&12 Please help me answer this problem. Choose the correct answer from the given choices. NOTE: Show your solutions or answers why you've got or undergone this answer. BOX YOUR FINAL ANSWER. Make sure your answer is in the given choices. State whether the answer is Option A, B, C, or D. Type only your step by step solutions and answers here, do not handwritten. Failure to follow the above reminders and direction will be marked as not helpful. Thank you.
write down the slection of wiring accessories used in electrical installation
A small office (10 ft by 10 ft with an 8.5 ft ceiling) has two luminaires, each of which is mounted at the ceiling and produces 2000 lumens. The reflectances of the room are 80% for the ceiling, 50% for the walls, and 20% for the floor. For the given room conditions, you've determined that the coefficient of utilization for the luminaire is 0.80.
powe calculrions
Answer ONLY the items in number 07. Circuit Diagram is given below. Thanks!!!NOTE: I only included number 5 question because it has connection to number 7.