300 m ring distributor has loads as shown in Figure below, where distances are in meters. The resistance of each conductor is 0-2 22 per 1000 meters and the oads are tapped off at points B, C and D as shown. If the distributor is fed at A at 240 V, find voltages at B, C and D. 50 A 70 D 90 240 V ✰ A C 60 B 80 100 A

Q: Please answer in typing format

A: Step 1: Let the per meter resistance of the conductor be r (r= 0.2ohms/1000) and currents be flowing…

Q: 22. The following figure shows a network of conductors. Apply Kirchhoff's voltage rule to the two…

A:

Q: A 208-volt 3-phase circuit that draws 10-amps is installed in a raceway that measures 200ft, the…

A:

Q: J) 1-line on the high side is IA a) 1.73A b) c) 2A d) 4A K) VA/phase of the load is a) 120VA b)…

A: The line current on the high voltage side is √3 times the phase current on the high voltage side…

Q: QUESTION 2 The source in Figure 2 has an internal resistance of 120 Ohm. Determine the load power…

A: 2) To calculate the load power when the load resistance is 25 ohm

Q: 4. You have two cylindrical conductors each one meter long. One is made of aluminum with a radius of…

A: Given, LAl=1 mLCu=1 mrAl=1 mm=1×10-3 mρAl=2.8×10-8 ΩmρCu=1.7×10-8 ΩmV=10 VI=10 A

Q: E D AV = 6.00V C R B AV I = 0.300A 5.00V A 3.000 18. ΦΩ F 32.00 G Use the junction rule for currents…

A: The circuit diagram,

Q: The figure below shows a two-member truss supporting a block of weight W. The cross- sectional areas…

A: The given figure is shown below: It is given that: Area of members:AAB=800  mm2=800×10-6 m2AAC=400…

Q: If the resistor R1 and R2 terminals are connected across each other. If the Rory is 10 and R1 is…

A: We need to find out value of R1

Q: 2. In the circuit shown in Figure 1, a load having an impedance of 3z + j26 is fed from a voltage…

A:

Q: A two-node AC circuit is shown in Figure 1. 10 50/0⁰ 1 ele 5 www Determine the voltages at node 1…

A:

Q: answer the following based on the 3-phase transfomer configuration in figure 7, worksheet4.…

A: The primary sides of given bank of transformers are connected in delta and the secondary side as…

Q: Measure currents for unbalanced load

A: In the given circuit, the 3-phase source(s) and load element(s) both are connected in star-form.

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.