30 15 22.5 Question 4 Figure 4 is an isometric view of an object where Arrow A indicates your FRONT VIEW and B your RIGHT VIEW for the sometric drawing. Figure 5 is the given RIGHT SIDE VIEW. Use your drawing instruments and a scale of 1:1; you are required to perform the following tasks: 4.1 Drawaccording to Third Angle Orthographic Projection, the FRONT AND PLAN VIEWS of the object using the given dimensions (in mm). 4.2 Show a specific title, scale and projection symbol. 25 50 TRUE R5 50 TRUE R3 x2 100 80 B Figure 4: Isometric View Figure 5: Given RIGHT SIDE VIEW

Q: I need help solving problems 7, 8, and 9 pertaining to the print attached below.

A: 7.In question no. 7 information is not enough to answer the question. As there are many circles in…

Q: DIMENSION THE OBJECT SHOWN BELOW. NOTE THAT NOT ALL ORTHOGRAPHIC VIEWS WILL REQUIRE DIMEN- SIONS. DO…

A: Orthographic views of a part i.e., Top view and Side/Front view is given here. Grid spacing is…

Q: GIVEN THE ORTHOGRAPHIC VIEWS, CREATE AN ISOMETRIC SKETCH OF THE FOLLOWING OBJECT.

A: Find Create an isometric sketch of the given object on isometric paper.

Q: Some necessary dimensions are dimensions that are missing. missing from the following 3-view…

A: According to the details provided in the three views of the drawing, there is a hole of 2 units in…

Q: Sketch the isometric view Sketch the first angle orthographic view Note:use creo parametric to…

A:

Q: For the given multiview projection, draw the corresponding isometric drawing. ME DA

A: For the given multi view projection, draw the corresponding isometric drawing.

Q: Please use the isometric graph paper in my picture to draw it to scale!

A: According o the given data Three orthographic views of the object are given  We need to draw The…

Q: 3. On the drawing and produced part below, label the following terms: Datum feature symbol Datum…

A: Label the given terms.

Q: L. Sketch the objects shown using isometric, oblique, and one- or two-point perspective.

A: It is asked to draw isometric, oblique and one point perspective views

Q: Use creo parametcric 4.0 drawing to Sketch all the compulsary part and partial views, including…

A:

Q: I need these three parts answered, if you are unable to answer all three parts please leave it for…

A: 4.The number 81073 denotes the CAGE no. as shown in the print. The CAGE code indicates Commercial…

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.