3.) When a gas surrounded by air is compressed or expands adiabatically, its temperature rises or decreased even though there is no heat input or dissipated to the gas. Where does the energy come from to raise or lower the temperature? 4.) Why must a room air conditioner be placed in a window rather than just set on the floor and plugged in? Why can a refrigerator be set on the floor and plugged in?

3.) When a gas surrounded by air is compressed or expands adiabatically, its temperature rises or decreased even though there is no heat input or dissipated to the gas. Where does the energy come from to raise or lower the temperature? 4.) Why must a room air conditioner be placed in a window rather than just set on the floor and plugged in? Why can a refrigerator be set on the floor and plugged in?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Thermodynamics: A refrigeration unit using Refrigerant-134a is used to maintain a certain space at –15°C. The condenser rejects heat (?H) to cooling water that enters the condenser at 15°C at a rate of 0.2 kg/s and leaves at 35°C (all as saturated liquid water). The superheated refrigerant enters the condenser at 0.8 MPa and 40°C and leaves as a saturated liquid at the same temperature. If the compressor consumes 4.5 kW of power, determine (a) the mass flow rate of the refrigerant, (b) the refrigeration load (?̇L), (c) the COP.
Differentiate Refrigerator from Heat pumps in terms of: (a) Transfer of Heat, (b) Location of the evaporator, (c) Location of the condenser, and (d) Working of evaporator and condenser.
What are the Difference of a Open Heater to a Closed heat exchanger?
Comment on the importnace of quickly returning the milk carton to the refrigerator for an energy conservation point of view.
The PV diagram below shows a sequence of processes applied to an ideal gas inside an engine 1. Which process is an isothermal compression? 2. In which process does the pressure increase with constant volume? 3. In which process is workdone on the gas? 4. What is the workdone on the gas by the process DA?
PART A ONLY ( USE IMAGE BELOW) In a standard ideal refrigeration cycle (Fig. 1), the refrigerant 134a enters adiabatically isolated expansion valve as a saturated liquid at a pressure P1 = 1 MPa and leaves the device at a pressure P2 = 100kPa. Then the refrigerant enters the evaporator, where it changes into the saturated vapor. Subsequently, the vapor is compressed in an isentropic compressor to the pressure 1MPa and condensed in the condenser back to the initial saturated-liquid state. PART A - Determine the heat qL absorbed by the refrigerant in the evaporator and the compressor work win (per 1 kg of the refrigerant).
please provide full calculations thank you
How is the process of refrigeration explained in terms of the First Law of Thermodynamics.
For refrigeration, answer the following questions
Provide complete solution and detailed diagram. A refrigerator is to remove heat from the cooled space at a rate of 300 KJ/min to maintain itstemperature at - 8oC. If the air surrounding the refrigerator is 25oC, determine the minimum powerrequired for this refrigerator? A. 0.263 kw B. 0.473 kw C. 0.623 kw D. 0.984 kw
3- Three refrigerators in Figure 4, shown with the designations A, B, and C are working in a temperature range of TH=32 °C and T1=3 °C. Among these three refrigerators, while the first refrigerator (A) is known to be a reversible, on the other hand, the other two (B and C) are known to be an irreversible and an impossible type, respectively. So, a) Calculate the COPR value of the refrigerator A under these temperature limits. b) Based on your Carnot calculations, give a COPR value for B which can be accepted as an irreversible refrigerator. And discuss why the value that you had chosen can be chosen as an irreversible refrigerator COP value. c) Again, based on your Carnot calculations, give a COPR value for C which can be accepted as an impossible refrigerator. And discuss why the value that you had chosen can be chosen as an impossible refrigerator COP value. Warm environ ment at Ty-32 °C Irreversible refrigerator (Impossible refrigerator Reversible refrigerator A B Cool refrigerated…