3. The work done by substance in a reversible non-flow manner in accordance with V=700/P where V is volume in m³, P is absolute pressure in Kpa. Evaluate the work done on or by the substance as the pressure increases from 70 to 700 KPa

3. The work done by substance in a reversible non-flow manner in accordance with V=700/P where V is volume in m³, P is absolute pressure in Kpa. Evaluate the work done on or by the substance as the pressure increases from 70 to 700 KPa

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Which of the following is incorrect about the overall energy balance and mechanical energy balance in fluid flow phenomena?A. The former only accounts the first law of thermodynamics while the latter includes the second.B. The former only accounts the work brought by changes in the volume while the latter includes the Δ(PV) work.C. The enthalpy of the system for both balance is the sum of the changes in the internal energy and the reversible work at constant pressure.D. The former is not often used to evaluate a system with changing pressure unlike the latter.
The cv and cp values of incompressible substances are identical and are denoted by c.
Phy
3. A fluid system undergoes a non-flow frictionless process from 5.5 ft to a final volume 2.5 ft in accordance with the defining relation P= 60/V + 23 psi, where volume is in ft. During the process the system reject 30 BTU of heat. Determine the change in enthalpy and internal energy.
Determine the work done by a 1 kgm fluid system as it expand slowly in a closed system from p1 = 2.84 Mpa, V1=0.08m^3 to v2 = 0.22m^3 in accordance to the defining relations: (a) pV(InV) = c and (b) pV^14 = c. Express your answer in Calories.
In an engineering system, air passes through two sequential processes. These processes Information about it is given below. Process 1-2: Polytropic compression, n = 1.3, P1=100 kPa, v1 =0.04 m3 /kg v2 =0.02 m3 /kg. Process 2–3: v3 = constant pressure process up to v1. In the light of this information, 1)draw the P-v diagram of the system. 2)Work per unit air mass in kJ/kg set as.
Refrigerant 134a expands in a piston-cylinder assembly from p₁= 200 lb/in² and T₁ = 140°F to p₂ = 30 lb/in² and T₂ = 80 °F. The mass of refrigerant is 0.46 lb. During the process, the work done by the refrigerant is 4.32 Btu. Kinetic and potential energy effects are negligible. Determine the initial volume of the refrigerant, V₁, in ft³, and the heat transfer for the process, in Btu. Step 1 * Your answer is incorrect. Determine the initial volume of the refrigerant, V₁, in ft³. V₁= 0.105743 ft3
One pound of air with an initial temperature of 200F is allowed to expand without flow between pressure of 90 and 15 psia. if the air is undergoing a process that follows pVn=C, where n=1.5, what is the non-flow work?
A rigid tank of volume 10 m³ initially contains saturated water vapor at a temperature of 120 °C. Steam at a pressure 1.2 MPa and a temperature of 400 °C enters the tank through a valve in steam line that is connected to the tank until the final pressure in the tank is 800 kPa, at which time the temperature is 200 °C. All kinetic and potential energy effects can be neglected. A schematic of the problem and properties at all state points except state 1 are shown in the figure below. All of the properties at state 2 and the inlet state i are provided on the figure. Initial State in Tank T₁-120 °C, Sat. vapor u₁=? kJ/kg V₁=? m³/kg Pi=1.2 MPa, Ti-400 °C hi-3261.3 kJ/kg V=10 m³ Final State in Tank T: 200 °C, P₂-800 kPa u₂= 2631.1 kJ/kg v₂=0.26088 m³/kg Qout For Question 6: The initial specific internal energy, u1, of the saturated vapor in the tank in kJ/kg is
EXTRA CREDIT PROBLEM: Oxygen is flowing steadily in a pipe that is gaining or losing heat from the surroundings at 200 °C. The measured values for the pressure and temperature at two locations (A and B) along the pipe are shown below. Assuming that oxygen is an ideal gas, establish the direction of the flow of oxygen in the pipe. Neglect work during this process. Location A Location B Pressure 280 kPa 430 kPa Temperature 252 °C 68 °C
Saturated water vapor at 85 ° C comes out of a turbine and condenses on the outer surface of a cooling pipe 2 in diameter and 20 m long at a rate of 90 kg / hr. Find the rate of heat transfer from the steam to the cooling pipe.