3. Find the proper thickness of 900 mm cast-iron pipe under a 95m head of water with a working stress of 25 MPa.

Q: How did you solve for the velocity of b?

A: The given question was solved using velocity polygon method.If AB is a link which is rotating about…

Q: solve and show every step with right answer

A: Data given - Rectangular cross section 225×75 mm2 Torsional moment = 20kN Axial Compressive force =…

Q: For the bearing shown below in the figure which of the following represents the bearing bore? For…

A: This question is based on the concept of deep groove ball bearing.

Q: Draw the Mohr stress circles for the states of stress at a point given in the figures below. For (a)…

A: Draw the Mohr stress circles for the states of stress at a point given in the figures below.  To…

Q: In the figure below, Which of the following represent the dedendum

A:

Q: now please answer question 2 and 3 please

A: This question is based on the concept material science. As per the guidelines we are subjected to…

Q: idk where you got the 4 from

A: The number of independent equations=5The number of unknowns=7To determine:Degree of freedom

Q: SHAFT KEY

A:

Q: C) What is the maximum possible mass flow rate that the pump can produce?

A:

Q: Where did you get the 3 from for the distance of q?

A:

Q: 6 Using the drawing callout shown in Figure 5 below, which part(s) shown in Figure 4 would now…

A: According to the given dimensional tolerance for the part, the maximum and minimum allowable…