3. An ideal regenerative cycle is executed with steam generated at 8 MPa, 500°C. Before condensing at 0.014 MPa, steam is extracted for feedwater heating at 0.8MPA. Find: a) Ideal work of the turbine b) turbine thermal efficiency c) cycle thermal efficiency d) draw the actual Ts diagram

3. An ideal regenerative cycle is executed with steam generated at 8 MPa, 500°C. Before condensing at 0.014 MPa, steam is extracted for feedwater heating at 0.8MPA. Find: a) Ideal work of the turbine b) turbine thermal efficiency c) cycle thermal efficiency d) draw the actual Ts diagram

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Question 3: A 4-stroke, 4-cylinder Spark Ignition engine is running at speed of 1800rpm following an…

Q: 6 HX WARM Compressor medium Evaporator Condenser COLD mediumy Valve 8 3 A two-stage ideal cycle…

A: Given: Evaporator pressure in right cycle→P1=P4=0.15 MPa=150 KPa Evaporator pressure in left…

Q: The refrigeration cycle involves four main components a pump, a condenser, an expansion valve, and…

Q: QUESTION 2 Modification of the reversed Carnot Cycle to Vapour compression cycle involves: Repacing…

A: To fill: The box of the problem. Explanation: The reverse Carnot cycle: A Carnot cycle consists of…

Q: Which of the following statements is true regarding the Reheat Rankine Cycle? I. Reheat Rankine…

A: Reheating operating at very high boiler pressure increases the dryness fraction of the steam exiting…

Q: Briefly describe an ideal reheat Rankine cycle with schematic diagram and T-s plane.

A: Given Data - Topic- Ideal Reheat Rankine Cycle We have to Explain Reheat rankine cycle with TS…

Q: If the compression ratio of diesel engine is 18.7 and the cut off ratio is 2.3, the thermal…

A: Note:As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: What are the considerations that should be done before the installation process of pipes in a plant?

A: The consideration are:1. The selection of the material is good. The material to be selected can bear…

Q: Can you please give 3 disadvantages of Reheat Regenerative Cycle?

Q: Draw the schematic or plant layout. Draw the T-s diagram Mandatory: A, B, C Suggested: D, E, F…

Q: refrigeration plant has to handle a ure is 17ºC. The atmospheric air is com ure of 30°C due to ram…

Q: The water used as the working fluid in an ideal reheating Rankin Cycle, 15 MPa in the boiler, 2 MPa…

A: Since there are multiple subparts and it is not specified which subparts are needed to be solved. So…

Q: A ____ unit is a new set of high-pressure equipment to be added or topped into the existing system…

A: Cogeneration, also known as combined heat and power (CHP), offers boiler owners and operators an…

Q: nkine cycle the pressure in the rehea boiler pressure condenser pressure man boiler pressure Doiler…

A: Reheat Rankine Cycle

Q: na Reheat cycle, the steam after leaving the Low-pressure turbine enters into th Select one: O a.…

A: In reheat cycle the steam after expansion in high pressure turbine is reheated in boiler to increase…

Q: For combined cycle, which statement is incorrect Select one O a Heat utilization in combustor isn't…

A: e. The temperature difference between exhaust gad and steam through the waste heat boiler isnt…

Q: Explain Diesel-fired power plant

A: A generating station during which diesel motor is employed because the first cause for the…

Q: Why should the adiabatic flame temperature be much higher for a pure oxygen feed than for an air…

A: -The temperature of the products of the combustion reaction if no heat is lost in the external…

Q: How does reheating allow for improved Rankine cycle performance?

A: step by step solution is given below,

Q: How is regenerative thermal oxidizer (RTO) different from traditional thermal oxidizer?

A: A thermal oxidizer or a thermal incinerator or afterburner is an air pollution control process unit…

Q: Which one of the statement is true about Reheat Rankine cycle? Select one: a. Reheat pressure is…

Q: Match the following to its correct definition a. boiler b. condenser c. reheater d. open feedwater…

A: Boiler: It is where bled steam and/or water at different temperatures mix. It is where water is…

Q: What are the advantages of Contact condensing systems?

A: In contact condensing systems, the direct contact between the two mediums takes place. The…

Q: Which statement is right regarding the following heat pump? Outside air Inside air Condenser…

A: Option (a) it heats the indoor space by using heat rejection process.

Q: In a refrigerant 22 refrigeration system the capacity is 180 kW at a temperature of "-30°C." The…

A: The compressor, condenser, expansion device, and evaporator are the four key components of the…

Q: What is the purpose of reheating steam in the reheat cycle?

A: Reheating is a process in which expansion of steam takes place in multiple stages or multiple…

Q: Treated Natural Gas Mixed Refrigant m M Mixed Refrigant (M) LNG

A: Introduction: In the case of dual cycle mixed the mixed refrigerant cycle, which has a low power…

Q: The type of condenser that has the lowest operating head pressure is the ___________ cooled…

A: Given data : Lowest operating head pressure.

Q: Which one of the following is a vapor power cycle?

A: Option d) Rankine cycle is the answer

Q: In the absorption refrigeration cycle, which of the following componennts replace the compressor in…

A: Refrigeration: It means cooling a space, substance or system to lower and maintain its temperature…

Q: In vapour compression cycle the condition of refrigerant is superheated vapour O After passing…

Q: What is the ideal reheat Rankine cycle

Q: What is heat recovery steam generator (HRSG)?

A: A heat recovery steam generator is a type of heat exchanger which reuse the heat of the steam…

Q: safety measure

A: Hello you are asking about cardioxide refrigerant but currently there is no such a refrigerant in…

Q: on the

A: given: 8(Explain abou the heat transfer mechanism on the ljungstrom air preheater related into…

Q: A 200 MW steam power plant operates on a simple Rankine cycle with superheated steam entering the…

Q: 16-5 A two-stage ammonia system using flash-gas removal and intercooling operates on the cycle shown…

A: Refrigerant=Ammonia R717Condensing temperature, Tc=35oCIntermediate evaporator temperature,…

Q: 30°C. The flow rate o

Q: In the Benson boiler given below, what is A?

Q: If the air leaving the cooling coil were to be 55°F drybulband 53°F wet-bulb, what would the total…

A: Given data DBT=55°FWBT=53°F Here, DBT is the dry bulb temperature and WBT is the we bulb…

Q: R134a refrigerant is used as the working fluid, the cooled environment is fixed at -30\deg C. and…

A: Find outdryness degree of the refrigerant at the evaporator inlet.Cooling capacity.COP value of the…

Q: Modification of the reversed Carnot Cycle to Vapour compression cycle involves: Repacing the…

Q: Instructions: Perform a cycle analysis for the given reheat-regenerative Rankine cycles. Supply the…

Question

REHEAT CYCLE / REGENERATIVE CYCLE

3. An ideal regenerative cycle is executed with steam generated at 8 MPa, 500°C. Before
condensing at 0.014 MPa, steam is extracted for feedwater heating at 0.8MPA.
Find: a) Ideal work of the turbine
b) turbine thermal efficiency
c) cycle thermal
efficiency d) draw the actual Ts diagram

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Turbine Work

VIEW

Thermal efficiency of turbine

VIEW

Thermal efficiency of cycle

VIEW

TS Diagram

VIEW

Step by step

Solved in 6 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

23. Which of the following statements regarding a Rankinecycle with reheating are TRUE? (i) increase in average temperature of heat addition (ii) reduction in thermal efficiency (iii) drier steam at the turbine exit
Draw the installation diagram and T-s diagram of the ideal vapor compression heat pump cycle and write the phase changes in the cycle.
What are the four factors that determine the efficiency of a furnace?
In a gas turbine plant __________________ is used to increase the turbine output a.heat exchanger b.reheater c.intercooling d.regenerator
note: all feed water heater used in the cycle is open
Task 1 : Investigate the principles of operation of the used part of the gas turbine plant (Brayton Cycle). Task 2: Calculate the produced power of the used gas turbine system then assess its efficiency. Task 3: If the compressor and turbine isentropic efficiencies are 88% and 75 %, respectively, compare and evaluate the actual plant and theoretical efficiencies in the used single shaft gas turbine system.
Describe how a solar chimney power plant operate
16-3 In a refrigerant 22 refrigeration system the capacity is 180 kW at a temperature of -30°C. The vapor from the evaporator is pumped by one compressor to the con- densing pressure of 1500 kPa. Later the system is revised to a two-stage compression operating on the cycle shown in Fig. 16-16 with intercooling but no removal of flash gas at 600 kPa. (a) Calculate the power required by the single compressor in the original system. (b) Calculate the total power required by the two compressors in the revised system. Ans. 70.9 kW Condenser 1500 kPa 3 High-stage compressor Intercooler 2 600 kPa Evaporator 180 kW -30°C Low-stage compressor Figure 16-16 Intercooling system in Prob. 16-3.
urgent please
The type of condenser in which the steam and cooling water flow from top to bottom and mix is called O a. central flow surface condenser Ob. down flow surface condenser evaporative surface condenser O d. parallel flow jet condenser
10. PLEASE ANSWER ASAP
follow the steps while answering step by step detailed answer good HANDWRINTING (DONT REJECT LET OTHER ANSWER THE QUESTION IF YOU DONT HAVE IDEA THEN SKIP)