3. An air compressor which operates at 900 rpm has a piston displacement of 4500cm3. Determine the mass flow rate of air at standard density considering that the volumetric efficiency is 77%. a. 314.57 kg/hr b. 324.35 kg/hr c. 137.54 kg/hr d. 224.53 kg/hr  Please answer this immediately. Thank

Q: Consider the arrangement shown in Fig. 1. For this setup the streams of air and water flow are…

A:

Q: 2) A heat pump with the amount of heat of liquid refrigerant (mix) when it will enter the expansion…

A: Answer: The coefficient of performance of the heat pump is 0.575.

Q: A compressor receives 21.6 m³/min of carbon dioxide (CO₂) gas. The initial and final specific…

A:

Q: A mass of water of 1 kg enters a tank, the mass leaving the tank is 500 gm, then the change of mass…

A:

Q: Determine the total mass flow rate at the inlet of a turbofan if the flow rate at the inlet of the…

A: Present day Turbofan motors can convey high push without the high fuel utilization as looked at to a…

Q: 4 Calculate the isothermal and polytropic work of a reciprocating compressor and thus deduce the…

A: given; initial volume(V1)=0.1m3initial pressure(P1)=1bar                       =100kpainitially…

Q: 1.1 Determine the electrical power supplied to a boiler when the temperature of the entering water…

A: Consider the following diagram for the boiler system, the heat input is Ql and heat loss from the…

Q: Steam enters a turbine operating at steady state with a mass flow rate of 1.5 kg/s. The turbine…

A: Given:m=1.5 kg/sP=2.7 MWh1=3506.2 kJ/kgc1=30 m/sh2=1671.67 kJ/kgc2=130 m/s

Q: . A pump extracted water 60 meters below the ground and discharge to a tank 5 meters above the…

A:

Q: 3) If the measurement parameters of a refrigeration machine are known, the amount of heat for liquid…

A:

Q: Steam enters a turbine stage with an enthalpy of 3628 kJ/kg at 70 m/s and leaves at the same stage…

A:

Q: 4. Considering the Typical Energy Balance for gasoline engine, @ atmospheric condition of 1.013 bar…

A: Introduction: A four-stroke engine sometimes known as a four-cycle engine is a type of internal…

Q: 1. An engine operating on the air standard heat engine has 13 KJ heat added at isochoric process,…

A: given:Heat addition, Qa=13 kJheat ratio, γ=1.35minimum pressure=101 kPaminimum temperature=305…

Q: The device that stores the potential energy of an incompressible fluid is O a. pressure absorbing…

A: Question)  The device that stores the potential energy of an incompressible fluid is .............

Q: You are replacing an HVAC system in your building. The system is a hot water system that consists of…

A:

Q: A pump is used to circulate hot water in a home heating system. Water enters the well-insulated pump…

A: Given :  rate = 0.42 gal/min inlet pressure = 14.7 lbf/ in2  inlet temperature = 180 0F exit…

Q: Q2. The bore and stroke of a single cylinder SI engine that operates on a four stroke cycle are 8 cm…

A: (i) Write the formula for the average piston speed. v=2SN60 Here, v is the average piston speed, S…

Q: Determine the mass flow rate of air entering the air-handling unit, in lb/s, the volumetric flow…

A:

Q: A turbine receives steam at the following state: pressure 1200 kPag, enthalpy 2875 kJ/kg, speed 33.3…

A:

Q: 3. 12 kg of air per minute is delivered by a centrifugal air compressor. The inlet and outlet…

A:

Q: A steam turbine seems to operate at a mass flow rate of 1.5 kg / hr. Turbine inlet state P1 = 2 MPa,…

A: Given information: The mass flow rate at the inlet of the turbine (m) = 1.5 kg/hr = 4.166×10-4 kg/s…

Q: 2. Helium expands polytropically through a turbine according to the process pv1.5 =C. The inlet…

A:

Q: Question 6 Name the four criteria for classifying compressors. 01.highest pressure developed 2.…

A: Given: There are several criteria for which we can classify compressors. But we have to classify…

Q: State two industrial applications of the diesel engin

A: Explanation  Diesel engine: Diesel engine is the internal combustion engine in which heat is…

Q: (2) (3 STEAM P₁ = 40 BAR (AV)₁ = 70m ³ min (2 P₂ = P4 20 Bar T₁ = 500°C T2 400°C T3 = 500°C P3= 20…

A:

Q: A fan which ventilates a small mine run at 500 rev/min. The airflow is measured at 150m3/s when the…

A: Fan speed,  = 500 Air flow,  = 150 Pressure drop, Efficiency of fan, It is asked to find the speed,…

Q: A gas compressor draws in 600 m³/min at 27°C and 120 KPa. What would be the mass flow rate of gas if…

A: Given data: The volume is, v=600 m3/min. The pressure is, p=120 kPa. The gas constant is, R=300…

Q: a.Which of the following appropriately describes the pumping energy efficiency when a pump is…

A: please refer handwritten solution

Q: When two similar pumps operates in parallel, the volumetric capacity of the system changes by a…

A: When the pumps are added in parallel the volumetric flow rate (Q) is given by - Qnet =Q1 + Q2

Q: 1. Why do you find droplets of water (sweating) forming on a cold drink as soon as it is taken out…

A: Solution:   Note: Dear Student! As per our guidelines, we are only allowed to answer a single…

Q: If there are five different Carnot engines (C1, C2, C3, C4 and C5) with low temperature reservoirs…

A:

Q: A 4-cylinder compression-ignition engine using air has an intake pre temperature of 14.1psia and…

A:

Q: Problem 4: Make sure to draw all diagrams. All Units must be included. The screw eye is subjected to…

A: Given data: F1=300 NF2=500 N Need to determine the magnitude and direction angles of the resultant.

Q: 2 15 kg of air per minute is delivered by a centrifugal compressor. The inlet and outlet conditions…

A:

Q: Support your answer with the appropriate solution and diagram. 5. Air at 2.50 kg/m^3 enters a nozzle…

A:

Q: A- What are the differences between the heat and temperature? B- List two important factors that the…

A: We often interchangeably use the terms heat and temperature, because they are closely related to…

Q: 3. During a reversible process there are abstracted 320KJ/s of heat from 1.23kg/s of a certain gas,…

A:

Q: A compressor draws in 0.5 kgm/s of air with 7 m/s speed, 100 kPa pressure, and 0.95 m³/kg,m. The air…

A:

Q: The efficiency of wind turbine is equal to

A: The power input to the wind turbine from the moving air is, Pwind=1000 J/s The mechanical power…

Q: is a device which converts fluid power to linear or rotary mechanical power. Select one: O a. Valve…

A: Answer:- Option (B) correct.  Cylinder