3. A transTormer connected to a 120 as power line has 200 turns in its primary winding and 50 turns in its secondary winding. The secondary is connected to a 1000 light bulb. How much current is drawn from the 120 V power line.

3. A transTormer connected to a 120 as power line has 200 turns in its primary winding and 50 turns in its secondary winding. The secondary is connected to a 1000 light bulb. How much current is drawn from the 120 V power line.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: 0.4 고 6V H www 20 л А. лееее 0.1 H ДАМА S 10 л

Q: 3. Find the three currents shown in the figure using Kirchhoff's rules Show the loops in the Figure.…

A: Apply the Kirchhoff's voltage law in the left and right loop and apply the Kirchhoff's current law…

Q: Q2. A 1000-m long, two-wire DC distributor AB is fed from point A at 440 V. Loads of 15 A, 30 A, 35…

A: Each conductor resistance = 0.35 ohm /km R = 35 m ohm/kmtotal current at point F = 25 +20 =…

Q: A resistor, capacitor, switch, and ideal battery are in series. Originally the capacitor is…

Q: 2. Given the partial circuit below, determine the magnitude and direction of the currents i, and iz.…

A: Hi. as you have posted multiple questions and have not specified which question needs to be solved,…

Q: 5. What is the value of the short-circuit current (Isc) across terminal ab for the circuit given in…

Q: 1. In the circuit shown in the figure, R1 = R2 = 2kN, C1 = 500µF, C2 = 1000µF, C3 = 1000µF, and 50V.…

A: R1 = 2000 ohm R2 = 2000 ohm C1 = 500 μF C2 = 1000 μF C3 = 1000 μF E = 50 volts

Q: 4. Using source transformation and resistance combination, reduce the network to the left of 4-ohm…

Q: 12. In a potentiometer arrangement, a cell of emf 1.25V gives a balance point at 35.0cm length of…

Q: 1. A small water-heating coil is submerged in a container with 200g of water and 100g of ice,…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: 1. Tifanny is trying to get a light to burn brighter by increasing the current in its circuit. Would…

A: Answer (1) No , adding a resistor in series with the bulb doesn’t allow it to light brighter…

Q: 6. At t=0, the switch is closed on a, at t=RC, it is switched to b (R, = R; = R) a) Find the…

A: Given, R1=R2=R a) At t=0 switch is closed on a. The current will pass through the battery E.…

Q: 15. In the circuit drawn at the right, at the instant at which half the power being supplied by the…

Q: 2. A resistor of R = 50N resistance is in series with a capacitor of C = 150µF. At t= 0, it is…

A: Resistance R=50 Ω Capacitance C=150 μF=150×10-6 F The voltage of the source V=25 V The current…

Q: Using Mesh analysis, find the currents loop in the circuit shown below: 7.5 kn R4 R39.1 kn E 3 V R3…

Q: In the given circuit, switches S1, S2, and S3 are closed. Which resistor has the highest current…

Q: 13, What is the current (in amperes) in the 60-Ω resistor? ΙΩ ww D ww 30 Ω (a) 0.352 (b) 0.143 (c)…

Q: the reactance offered by a capacitor to alternating current of frequency 40 Hz is 100 ohms. it…

Q: The circuit in Figure 2 is closed at time t = 0 s. Find the c circuit at time t = 2 ms. Figure 2 O…

Q: 5. Determine the equivalent Norton's circuit if the load is connected to the A and B terminals. R₂…

Q: 15. Please consider the following circuit (Yay! Last question of this set!). RA RB a Rc RD ɛ = 12 V,…

A: a) RB and RD are in series so their equivalent resistance is R' = 3 + 3 = 6 ohm RA and RC are in…

Q: 8. The switch in figure has been open for a long time. It is closed at t = 0 s. What is the current…

A: Electricity.

Q: 81. Electric Circuit After the switch is closed in the circuit shown, the current t seconds later is…

Q: a) Use Kirchhoff's rules to show the loops and junctions. b) Find the emf of the battery and reading…

A: R1= 75ΩR2= 20ΩR3= 30ΩR4= 50Ω Unknown emf =ε Voltage applied on arm containing switch, =25 Volts

Q: A battery with = 5.80 V and no internal resistance supplies current to the circuit shown in the…

A: Here we need to find out the values of the resistances R1, R2 and R3 When the switch S is open, 1.0…

Q: A 200-volt electromotive force is applied to an RC series circuit in which the resistance is 1000…

A: When the electric potential is applied across a RC series circuit, then the potential across the…

Q: A 200 ohm resistor and a 300 ohm resistor are in parallel. In series with them is a 180 ohm…

Q: 3. Consider the following circuit. The switch is closed for a long time and then opened at time t =…

Q: 3. A circuit consists of a resistor, capacitor (initially uncharged), and battery. At t=0 the switch…

A: Here given a circuit diagram with a switch, capacitor . The value of the capacitor is 6μF and the…

Q: 1. Determine the currents in the various branches of the electrical network. The units of current…

Q: 1. A switch has a variable resistance that is nearly zero when closed and extremely large when open,…

A: (a) Current = 0(b) Current = E/(R+r)(c) Voltage across the open switch = E The explanation is given…

Q: A student conducts an investigation and connects a multimeter to a circuit. The multimeter produces…

Q: Consider the circuit shown in the figure. S 7.20 (a) What is the current, in amperes, on the 7.2N…

A: since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 2. A series RC circuit with R = 5 W and C = 0.02 F is connected with a battery of E= 100 V. At t =…

Q: 5. In the circuit on the right, the emf (voltage) of the power supply is V = 120V. Resistors R₁ =…

A: Given, The emf of the source is The resistors are

Q: 7. An electric power station that operates at 25 kV and uses a 10:1 step-up ideal transformer is…

Q: Problem 4. Given the circuit below, determine the current going through the R4 resistor using the…

Q: Consider these three circuits. 100 Hz 100 Hz 50 Hz 2 µH 1 µH C 4 pµH 1 Rank in order, from largest…

A: Given that: Peak voltage = εo L1=2μHL2=1μHL3=4μHf1=100 Hzf2=200 Hzf3=50 Hz

Q: 5. Given a DC circuit shown below with a DC battery, ammeter and single resistor of resistance R. If…

Q: 3. Kirchhoff's voltage laws tell us that (1) At any node (or junction), the sum of currents flowing…

A: Kirchhoff's Voltage Law: According to this law, the total voltage drop across the closed loop is…

Q: 3. A 10KN resistor is connected in series with a capacitor which has a capa 1µF and a battery with…

A: time constant = RC

Q: A transformer having efficiency of 90% is working on 200 V and3 kW power supply. If the current in…

Q: In a DC circuit with a single resistor, a current of 13 Amperes flows through a point in the…

A: Charge

Concept explainers

Magnetic Field Of Coaxial Cable

The word coaxial means same axis. So for a long straight cable to be coaxial, it must have concentric cylindrical shaped conductor around it. Coaxial cable (popularly called ‘coax’) has various applications ranging from current conductors to radiofrequency signal transmitters. This cable has lower emission losses and provides protection from electromagnetic interference which allows signals with less power to transmit over longer distances.For example, currents produced in the pickup of a stereo turntable generally travel to the amplifier through a coaxial cable.The self-inductance of a coaxial cable is another important characteristic, because it influences the propagation of electrical signals in the cable.

Question

3. A transformer connected to a 120 V
as power line has 200 turns in its
primary winding and 50 turns in its
secondary winding. The secondary is
connected to a 1000 light bulb. How
much current is drawn from the 120 V
power line.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

16. A parallel plate capacitor used in a flash for a camera must be able to store 31.0 J of energy when connected to 312 V. (Most electronic flashes actually use a 1.50- to 6.00-V battery, but increase the effective voltage using a dc–dc inverter.) Assuming the capacitor completely discharges to produce a flash in 7.40×10−3 s, what average power is dissipated in the flashbulb during this time? _____kW
16. You see a group of small fuse holders on a DIN rail in an industrial control cabinet. The fuse holders are in groups of five and are separated by a single terminal block. What's connected to that terminal block? A. System ground B. A control signal C. The AC or DC power to the fuses D. The power supply neutral 17. Which one of the following types of raceway offers the greatest protection for the conductors in the raceway? A. Metal wireway B. EMT conduit C. Rigid conduit D. Flexible conduit 18. Class 1 conductors or cables may be run with other Class 1 conductors if they all A. are part of different machine circuits. B. have different power supplies. C. have reduced voltages on the conductors. D. have the same insulation value.
4. In the circuit below, I - 2 A, and flows in the direction shown. Calculate the value of the unknown emf source, E. на не н I 1 вл IV 12 L
1. A 32.0-0 resistor and a 20.0-0 are connected in parallel, and the combination is applied across a 240 V dc line. (a) What is the resistance of the parallel combination? (b) What is the total current through the parallel combination? (c) What is the current through each resistor?
6. A series circuit is comprised of 2 resistors R1 = 500 ohms and R2 = 1000 ohms and a capacitor of C = 470mF. The combination is suddenly connected across a 50V dc supply battery. Determine the time constant and the time when the capacitor charge reaches 20Coulombs.
Rank the five networks for their resistance from largest to smallest. A. RA>RB>R>Rp>RE B. RE>Rg>R>Rp>RA C. RA RB>R>Rp>RE D. Rp Rp>Rp>RA>Rc E. RE>Rp>Rc>Rg>R¾ С.
4) The most basic DC circuit consists of a battery (direct current source) and a resistor connected with conducting wires. Draw such a circuit for a 10V battery and a 500 resistor. Indicate the direction of current on your diagram and find the current magnitude in this circuit.
Nordlink is a proposed subsea high voltage direct current (HVDC) power cable between Norway and Germany. The over 500km long cable will have a capacity of 1400 MW and a operational voltage of 500Kv. The new connection would be tested in late 2019 and operational in 2020. Briefly describe why HVDC is overtaking high voltage alternating current (HVAC) for long distance transmission
3. Consider the DC circuit shown below. + 1.5 V 10 Ω M M 5Ω 15Ω 7.5 Ω (a) Calculate the current, I, that flows through the 10 22 resistor as shown in the diagram above. (b) Calculate the voltage drop across and the current through the 15 2 resistor. (c) Calculate the current through the 7.5 9 resistor. (d) Calculate the voltage drop across the 5 2 resistor. (e) Calculate the total power dissipation of the circuit.
Based on the circuit shown below, according to Kirchoff’s current rule, thecurrent in point b is equal to the current in a. point cb. point dc. point c+dd. indeterminate Based on the circuit shown below, according to Kirchoff’s current rule, the emf inthe battery is equal to the potential difference measured between a. points a and bb. points b and cc. points c and dd. points a and d
1. A series circuit has 3 resistors of values 10, 20, and 30 Ohms and a current of 2.0 Amps. What must be the voltage supplied to the circuit? a) 50 volts b) 250 volts c) 120 volts d) 25 volts 21V , 102 50 50 2. In the above 10-Ohm resistor, what is the current reading after the power supply? a) 0.60 A b) 3.0 A ) 1.2A d) 2.4A
99. Subject Physics