3.) A 3 inches diameter 5-tooth cemented-carbide-tipped face milling cutter is to use for milling a rectangular shape machine steel workpiece (2-in width x 5 in. length) in a single pass. The cutting speed is 150 ft/min and the feed per tooth is 0.016 in. Determine (a) the feed rate in inch per minute and (b) the cutting time omitting the over travel.

Q: A drilling operation is performed to create a through hole on a steel plate that is 20 mm thick.…

A:

Q: i. spindle rpm ii. feed speed iii. cutting time iv. material removal rate

A:

Q: Through hole of 12 mm diameter is to be drilled in a steel plate of 20 mm thickness, drilled spindle…

A: Given: The diameter of hole is d=12 mm. The thickness of steel plate is t=20 mm. The drilled…

Q: 5. An engine lathe is used to turn a cylindrical work part, cutting speed 2.4 m/s, feed 0.20 mm/rev,…

A:

Q: If a fairing operation is executed at a rotational speed of 40.0 rev / min, the feed is 0.015 in /…

A: As the outer and inner diameter is not given so I am assuming it as D0 and Direspectivelya)…

Q: Calculate the ranges of typical machining times for face milling a 250-mm-long workpiece with a…

A: solution to first three sub-parts as per our company policy:

Q: In 3-axis milling, the table feedrate is 703.00 mm/min. Using a 10mm endmill to cut the material…

A:

Q: 17) A50-mm-dia endmill cuts 6061 aluminum with 30% tool engagement at a depth of 6 mm. The tool…

A:

Q: A part to be turned in an engine lathe must have a surface finish of 1.6 μm. The part is made of a…

A: Proper tool Nose radiusing improves machinability to some extent though. It increase the tool life…

Q: The following data is given for slab milling of a 300 mm long 50 mm wide mild steel block: Cutter of…

A:

Q: single-point cutting tool with 12° rake angle is used to machine a steel work-piece. The depth of…

A: Given:uncut thickness, t1=0.81 mmchip thickness, t2=1.8

Q: Calculate the time required for completing

A: Given DataDepth of cut d = 5 mmwith  w = 150  mmLength of the elate l= 600 mmThickness t = 25…

Q: Using slot milling with a cutting tool surface width of 36mm was performed from the top surface to…

A: Given:The width of the cutting tool surface, The dimensions of the workpiece is The diameter of the…

Q: 5. AT-slot is to be cut in a C.I. slab 260 mm long as shown make the T-slot if the cutting speed is…

A: Given    Cutting speed, v = 25 m/min            Diameter, d = 20 mm Number of teeth, z = 6 Find…

Die Stock

Die stock is expressed as the type of component which is utilized for fitting purposes while creating or shaping uniform threads on tubes, pipes, or screws. The die stock (die handle) has three screws around the adjustable part of a particular machine that helps to locate the die. Also, die stock can endure on a variety of hex and split adjustable dies of several dimensions. One of the primary reasons for using die stock in industries is because die stock can be operated by hands. Commonly, it is made up of high carbon steel.