3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is then connected to a 10V DC source. After 1 sec the voltage measured across the inductor is 3V. Find the value the unknown inductance for this condition. Use the false- position method to determine L to a level of Es = 0.1%. Employ initial guess of x₁ = 6 and x₂ = 10

3. A 10ohms resistor and an unknown inductance is connected in series. The series combination is then connected to a 10V DC source. After 1 sec the voltage measured across the inductor is 3V. Find the value the unknown inductance for this condition. Use the false- position method to determine L to a level of Es = 0.1%. Employ initial guess of x₁ = 6 and x₂ = 10

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In the figure ɛ = 10.0 V, Rị = 4.00 N, and R2 = 1.00 N. The inductor is ideal. If the switch is…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: a) Design the circuit and sketch the waveform and the phasor diagram of voltage and current in i.…

Q: 20 A sinusoidal ac source in the figure has an rms value of V. Considering all possible values of R,…

A: Given: VRMS = 202Vinput= Vin(t) = 20sintAnd Consider RL =∞VZ = 5 volt Find: minimum Value of Rs to…

Q: The network Nc shown below in Figure 1.99(a) contains a combination of scaled capaci- tors in series…

A: When capacitors are connected in parallel their equivalent value adds up and when capacitors are…

Q: Identify from the following statement when the capacitance can be discharged? a. If resistor is…

A: In this question , we will find when capacitor discharged..

Q: A resistor of 20 Ohms and a capacitance of unknown value when connected in in parallel across a…

Q: To describe the charging and discharging process of the capacitors. To compare the charging and…

A: The charging circuit if a capacitor is as shown below,

Q: alternating current bridge is arranged as follows: The ar sts of non-inductive resistance of 800 Q…

Q: A 250-V circuit, consisting of a resistor, an inductor and a capacitor in series, resonates at 50…

Q: A variable capacitance and a resistance of 290 ohm are connected in series across a 110-V; 60-Hz…

A: In this question A variable capacitance and a resistance of 290 ohm are connected in series across a…

Q: 11 6. For the circuit shown in the figure next, the value of (equivalent inductance) L T is found to…

A: We have to find the equivalent inductance of the following circuit

Q: esistance of 20 N and an unknown capacitance are conne -Vac, variable frequency source. When the…

Q: 5. How does a capacitor work, and what is its purpose in an AC circuit? 6. In an AC circuit, Ohun's…

A: AC circuit is nothing but a circuit using alternating current, the magnitude and the direction of an…

Q: 1. Series RL Given: E -12V Complete the table below t 0 Ιτ 2t = 3t = 4t= 5t= = I R 50 L 1mH ER EL…

A: Here RL series circuit is given.R=5ΩL=1mHV=12vis given.and we have to find Current through the…

Q: Find the equivalent inductance between terminals A and B in the following figure. Assume no mutual…

A: If three inductors of inductance L are connected in parallel then equivalent inductance is L/3. If…

Q: or a RC discharge circuit, the resistor and the capacitor are having 2400 ohms and 0.00005 Farads.…

A: Given Value R = 2400 ohm C = 0.00005 Farads

Q: A series circuit consists of a resistor, a coil, and a capacitor connected across a 300 V, 60 Hz AC…

Q: What is the correct explanation for the voltage seen at Va in Figure C5? Vaz We will assume that the…

Q: Both the number of turns and the core length of an inductive coil are double. Its . . self…

A: It is given that: The number of turns and the core length of an inductive coil are doubled.

Q: A coil of resistance 152 and an inductance 1H and a capacitance 15µF are connected in series across…

Q: Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Clipper Circuits:- A clipper circuit is used to clip the input voltage at a fixed higher and lower…

Q: A 150 µF and 100 µF capacitors are connected in series and across a 100 sin (wt + 30*) voltage.…

A: We need to find out current through circuit .

Q: (iii). Determine the net capacitance C of the capacitor network shown in figure. Assume C-3 pF, C 5…

A: The solution is given below

Q: A 40 micro-farad capacitor is connected in series with a 40 ohm resistor. If the voltage is 220-V,…

A: Series circuit consists of Voltage, V = 220 V Capacitance, C = 40microF Resistor, R = 40 ohm…

Q: 2. The current through a 0.1mH inductor (in the direction of the voltage drop) is depicted below.…

Q: 1. You are an electrician working in an industrial plant. You discover the problem with a certain…

A: Given that: In an industrial plant, a machine has a defective capacitor and its rating is 10 μF and…

Q: concept of pure inductive circuit

A: Given: Pure inductive circuit

Q: A series circuit consists of a resistor, a coil, and a capacitor connected across a 300V, 60Hz AC…

Q: Find the equivalent inductance as seen from the terminals shown in the figure

A: Given circuit,

Q: An inductor is constructed by winding a coil of 100 turns around a magnetic core. The core is a…

A: Given values are - Number of turnsN=100Radiusr=0.5cm=0.005mLengthL=10cm=0.10mRelative…

Q: For the circuit shown in the figure next, the value of (equivalent inductance) L_T is found to be *…

Q: In the figure e = 10.0 V, R1 inductor is ideal. If the switch is closed for a long time, what is the…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: Find the equivalent inductance as seen from the terminals shown in the

A: In this question we will find equivalent inductance between given terminal...

Q: In the figure ɛ = 10.0 V, R1 = 4.00 N , and R2 = 1.00 N. The inductor is ideal. If the switch is…

A: Transient Transient represent sudden change in the state of a network or circuit which are indicated…

Q: In the figure e = 10.0 V, R, = 4.00 N, and R2 = 1.00 N. The inductor is ideal. If the switch is…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: Suppose a resistor of value 6 k is in series with a 19.8 H induct What is the magnitude of their…

A: According to question,:

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

3. A 10ohms resistor and an unknown inductance is connected in series. The series
combination is then connected to a 10V DC source. After 1 sec the voltage measured across
the inductor is 3V. Find the value the unknown inductance for this condition. Use the false-
position method to determine L to a level of Es = 0.1%. Employ initial guess of x₁ =
6 and x₂ = 10

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The current through a 50 mH inductor is given below. Use Ohm’s Law to find the voltage. Convert to polar form, find the impedance and complete the math, then convert back to the waveform at i1 = 7.5sin(2500t – 20°) mA and i2 = 5.9sin(200t + 40°) mA
In the figure R1 When the switch is opened after having been closed for a long time, the current in the inductor drops from 1.00 A to 0.250 A in 0.200 s. What is the inductance of the inductor in mH? = 4.00 N , and R2 = 1.00 N. The inductor is ideal. %3D Şekildeki devrede R1 = 4.00 N , ve R2 = 1.00 N olarak verilmişlerdir. Solenoidin iç direnci yoktur. Anahtar uzun süre sonra kapalı kaldıktan sonra açılırsa solenoidden geçen akım 0,200 s içinde 1,00 A değerinden 0,250 A değerine düşmektedir. Solenoidin indüktansı mH cinsinden nedir? R1 S R2 L le
Find the equivalent inductance of the circuit shown in the image below. Assume all inductors are 80 mH. ell ell ell The equivalent inductance of the circuit is mH.
.A series RLC circuit contains a 4-kN resistor, an inductor with an inductive reactance (X,) of 3.5 kn, and a capacitor with a capacitive reactance (Xc) of 2.4 kN. A 120-Vac, 60-Hz power source is connected to the circuit. How much voltage is dropped across the inductor?
Find the Equivalent Capacitance between P and Q from the figure below
Solve it fast plz
3-10 A0.25-F capacitor has a current waveform i(t) as shown in Figure P3–10. Determine and plot the voltage waveform v(t) as a function of time. The capacitor is initially a and plot the voltage waveform v(t) as a function of time. The capacitor is imu uncharged. FIGURE P3-10 ilt) 4 A 6. -4 A
Q9. i) An inductance network with total inductance across A and B is 30mH is shown in Figure CI. L4 L2 = 40mH L6 = 40mH Leq-30mH L1= 20mH L5 50MH 100mH 30mH B. Figure C1 Estimate, inductance value, L4. [3]
The current through a 25-mH inductor is 10e t/2 A. Find the voltage at t = 3 s. Enter your answer with the correct sign and in units of mV.
A resistor and a capacitor are connected in series with a variable inductor. When the circuit is connected to a 550V, 40 hz supply, the maximum current given by varying the inductance is 15 A. At this current, the voltage drop across the capacitor is 2800 V. Calculate the power taken and power factor of the circuit when across a 250 V, 60 Hz source.
Determine the current through the 260mH inductor in the circuit shown in the figure and choose the solution from the options given. 0.7, ángulo de -2.9° 0.9, ángulo de -19.8° .52, ángulo de -23.1° 0.338, ángulo de 303⁰ 65 Ω 85mH 150 sin(2π 100t) mn 200 Ω 260mH 28 75 카 120 Ω 50uF
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source.