3- The pile is classified as Micro (Mini) pile when its diameter is: *less than 0.2m less than 0.3m *less than 0.1m "less than 0.15m

Q: What is Group capacity of pile ?

A: Capacity of pile group is that the total of the individual capacities of piles, however it's…

Q: the water table rises to the excavation depth

A: The moment induced piles are predominantly the piles that withstands the seismic forces.

Q: What type of pile is least prone to damage during handling?

A: There are many different types of pile foundation available which are used depending upon function…

Q: What are the factors to be considered for the selection of a pile type?

A: The selection of pile type: The selection of piles must be done for the large structure, to prevent…

Q: Define The local availability of each pile type

A: Pile foundation : Pile foundation is defined as a series of columns constructed or inserted into the…

Q: 1.0 Define Pile caps.

A: The foundation is a vital part of the construction of any structure. The total load of the structure…

Q: What are the two methods that are used to determine the capacity developed along the length of the…

A: Pile load capacity depends on a number of factors including cross section, pile length and shape…

Q: How does the Pile capacity can be determined?

A: Piles may either be pushed or casted on the spot. Pile drive is accomplished through: affect lateral…

Q: Define  the method of obtaining ultimate load and also allowableload on a single pile from pile load…

A: pile load test is the in situ method of the calculation of the load and settlement.  this method is…

Q: In what situation would the LTP be complemented by a pile cap?

A: A pile cap is a mat-like structure made of cement, sand and small scales. This mixture is placed in…

Q: Provide sketches/illustrations of pile cap steel reinforcement for 1 pile to 4 pile? (Provide…

A: Here, It is asked to provide the sketches of pile cap steel reinforcement for 1 pile to 4 pile.

Q: Which advantages fall under which type of pile? Please answer this asap. For upvote. Thank you very…

A: The foundation or substructure of the building is the structure lying below the ground surface to…

Q: Describe representative Pile Load Capacities and Available Lengths.

A: The ultimate bearing capacity of a pile is the maximum load that it can carry without excessive…

Q: determine: Pile Load Test -- You are to use the results of a pile load test given below to A. The…

A: The question might be related to calculating the equivalent resistance (Req) of the parallel…

Q: A group of nine piles is arranged in a square pattern and is used as a foundation for column in…

A: Given-9-pile group arranged in a square pattern,foundation in sand,diameter d= 350 mm= 0.35…

Q: What kind of information Load test results provide on pile type?

A: Load test can be carried out on piles after 28 days of casting the piles. Two types of tests could…

Q: Discuss the method of obtaining ultimate load and also allowableload on a single pile from pile load…

A: Pile load test is the in situ method of the calculation of the load and settlement. This method is…

Q: Describe the method  of plotting pile load test data to determine pile design capacity.

A: Pile load test is done to determine the pile design capacity i.e to determine settlement of pile…

Q: 2. Please describe the construction process of slurry wall protection bored pile.

A: A slurry wall is a method used to build reinforced concrete walls in areas which is nearby open…

Q: Describe the Concept—Osterberg load cell placement and effects on test pile.

A: - In Osterberg test, The Osterberg cell also known as O cell is placed inside the pile during its…

Q: Discuss the ultimate load carrying capacity of the single pile when the pile embedded soil is; i)…

A: In Granular soils the ultimate load-carrying capacity: The pile drives load-carrying capacity from…

Q: Define Pile Driving Methods and Equipment

A: Solution: Methods of the pile driving includes:1. Dropping weight2. Explosion3. Vibration4. Jacking…

Q: A single vertical friction pile of diameter 500 mm and length 20 m is subjected to a vertical…

A: Given data- A single vertical friction pile- Diameter d=500 mm, Length L=20 m Angle of internal…

Q: Describe the feature of the installation procedure for a driven pile.

A: The piles are used to lay the foundation at hard strata thus getting better bearing capacity of soil…

Q: the calculations to find the pile cap depth if pile diameter is 12(3/4). Also calculate the minimum…

A: Consider given data Depth of the pile is 12 m     H=12 mand   diameter od the piles        D=34…

Q: Define Cast-in-drilled-hole (CIDH) pile

A: Cast-in-drilled-hole (CIDH) pile are simply reinforced concrete piles cast in holes drilled to…

Q: Elevati Distanc on (ft) (y- axis) e (ft) (x- axis) 5 15 10 17 10 18 15 19 15 28 33 40 -5 44 -5 54…

A: First find the excavation volume using the give values and then determine the volume of filling.…

Q: Describe the  pile model used in wave equation analyses with the diagram.

A: Proper modeling of pile driving is important for both planning and inspection of pile driving…

Q: Note: Read the question carefully and give me right solution according to the question. A pile is…

A: Foundations are provided in a structure to provide stability and transfer the load to the soil…

Q: C Q- A concrete pile has size 40 cm x 40 cm, ultimate load carrying capacity of pile is 1200 kN, x…

A: Given- Concrete size- 0.40 m×0.40 m Ultimate load carrying capacity Qup=1200 kN. C=50 kN/m2, ∝=0.6

Pricing Excavation and Backfill

Backfill, in construction, is the activity of returning the soil and gravel that are removed during building construction or using them again to toughen and support the foundation of the building or any other structural component.