-3 m- В C www 2 m イ D A The assembly above is comprised of cables and a spring (k = 1000 N/m). The assembly supports a crate at A, weighing 200 N. Assume the system is in static equilibrium and that cable CD is oriented vertically. Which of the following best represents the tension in cable CD? a) 87 N b) 0 c) 155 N d) 200 N

Q: SITUATION. The suspended load exerts a force F-800lbs at A and bar OA weighs 300 lb. Assume that the…

A:

Q: Q2: The homogeneous block shown in figure weighs 1500-Ib. Determine the reactions at A, B, C and D.…

A: Given: A homogeneous block of 1500 lb weight  Required: Reaction at A, B,C and D

Q: Find the tension in the Active tension bracing in the center bay (hint: again, there is no need to…

A:

Q: The reaction at the support D of the continuous beam ABCD, hinged at two points shown in below…

A:

Q: *2-8 Part of a control linkage for an a rigid member CBD and a flexible cab applied to the end D of…

A:

Q: equivalent resultant force and couple moment at point A. +103. Replace the loading system acting on…

A: to find resultant

Q: 1O KNIM 60 KN 20 KNIM 48KN m A Fixed Pin/hirge 8 m 12 m C (Roller)

A: ∑MB=0 12×10×12×23×12 + 48 - RC×12 + 60×18 = 0 RC = 134 kN ∑V=0 RA+RC= 20×8 + 12×10×12 + 60 RA = 146…

Q: 3.6 A 4-m-long rigid body carrying a 10-kN/m uniformly distributed load is supported by a pinned…

A: given data is length of bar=4m to find the free body diagram and the reaction force at A also to…

Q: Problem 2) For the truss shown, solve for the influence line for member CH. The trucks run across…

A:

Q: From the figure of a cable connection shown. Refer to the details below: Distances: X = 2.9 m, Y =…

A:

Q: 8-21 The offset link has a width of w = 200 mm and a thick- ness of 40 mm. If the allowable normal…

A: Step 1: formula of Stress(Oallow)Oallow = P/Area , Area = width(thickness) Step 2: solve now for…

Q: 8) A shaft of diameter (d 5-mm) is to be pulled through a (4.5)-cm-diameter glycerin-filled sleeve…

A:

Q: Question 2 Neglecting friction and the radius of the pulley, determine (a) the tension in cable ADB,…

A:

Q: Q2. Draw the influence line for ( Rb, Rc, Rf, Rg, Mp, Mm, and Mb) P m A B C D E F mm n mmm b b b

A:

Q: A vent structure of mass 233 kg is suspended from an l-beam as shown below. 6w E C 3w 4w D G. А y 2w…

A: Mass of structure = 233 kg

Q: 3. For the cables shown in Figure ST – 064 1. Compute the tension in each segment if P = 400 N. 2.…

A:

Q: Find the tension in the Active tension bracing in the center bay (hint: again, there is no need to…

A: Given:- It is given a truss of tension members and asked to find the tension in the active tension…

Q: he support bracket for a water pipe that brings water from the city water system into the basement…

A: The pressure force is defined as the force that is exerted by the pressure on any area that is equal…

Q: 6. For a unit load moving from A to F on the truss shown in below construct influence lines for…

A: Step 1:Step 2:Step 3:Step 4:

Q: n oil pipeline is supported at 6-ft intervals by vertical hab=ngers attached to able shown. Due to…

A:

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.